drivers/net/ethernet/myricom/Kconfig

#
# Myricom device configuration
#

config NET_VENDOR_MYRI
	bool "Myricom devices"
	default y
	depends on PCI && INET
	---help---
	  If you have a network (Ethernet) card belonging to this class, say
	  Y and read the Ethernet-HOWTO, available from
	  <http://www.tldp.org/docs.html#howto>.

	  Note that the answer to this question doesn't directly affect the
	  kernel: saying N will just cause the configurator to skip all
	  the questions about Myricom cards. If you say Y, you will be asked for
	  your specific card in the following questions.

if NET_VENDOR_MYRI

config MYRI10GE
	tristate "Myricom Myri-10G Ethernet support"
	depends on PCI && INET
	select FW_LOADER
	select CRC32
	---help---
	  This driver supports Myricom Myri-10G Dual Protocol interface in
	  Ethernet mode. If the eeprom on your board is not recent enough,
	  you will need a newer firmware image.
	  You may get this image or more information, at:

	  <http://www.myri.com/scs/download-Myri10GE.html>

	  To compile this driver as a module, choose M here. The module
	  will be called myri10ge.

config MYRI10GE_DCA
	bool "Direct Cache Access (DCA) Support"
	default y
	depends on MYRI10GE && DCA && !(MYRI10GE=y && DCA=m)
	---help---
	  Say Y here if you want to use Direct Cache Access (DCA) in the
	  driver.  DCA is a method for warming the CPU cache before data
	  is used, with the intent of lessening the impact of cache misses.

endif # NET_VENDOR_MYRI