[MIPS] Cobalt: Fix UART I/O type
The Cobalt UART is actually connected to memory resource area.
Signed-off-by: Yoichi Yuasa <yoichi_yuasa@tripeaks.co.jp>
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
diff --git a/arch/mips/cobalt/setup.c b/arch/mips/cobalt/setup.c
index a4b69b5..415ff87 100644
--- a/arch/mips/cobalt/setup.c
+++ b/arch/mips/cobalt/setup.c
@@ -130,7 +130,7 @@
set_io_port_base(CKSEG1ADDR(GT_DEF_PCI0_IO_BASE));
- /* I/O port resource must include UART and LCD/buttons */
+ /* I/O port resource must include LCD/buttons */
ioport_resource.end = 0x0fffffff;
/* request I/O space for devices used on all i[345]86 PCs */
@@ -149,24 +149,24 @@
register_pci_controller(&cobalt_pci_controller);
#endif
-#ifdef CONFIG_SERIAL_8250
if (cobalt_board_id > COBALT_BRD_ID_RAQ1) {
-
#ifdef CONFIG_EARLY_PRINTK
cobalt_early_console();
#endif
+#ifdef CONFIG_SERIAL_8250
uart.line = 0;
uart.type = PORT_UNKNOWN;
uart.uartclk = 18432000;
uart.irq = COBALT_SERIAL_IRQ;
- uart.flags = UPF_BOOT_AUTOCONF | UPF_SKIP_TEST;
- uart.iobase = 0xc800000;
- uart.iotype = UPIO_PORT;
+ uart.flags = UPF_IOREMAP | UPF_BOOT_AUTOCONF |
+ UPF_SKIP_TEST;
+ uart.iotype = UPIO_MEM;
+ uart.mapbase = 0x1c800000;
early_serial_setup(&uart);
- }
#endif
+ }
}
/*