| /* |
| * Intel Wireless WiMAX Connection 2400m over USB |
| * Notification handling |
| * |
| * |
| * Copyright (C) 2007-2008 Intel Corporation. All rights reserved. |
| * |
| * Redistribution and use in source and binary forms, with or without |
| * modification, are permitted provided that the following conditions |
| * are met: |
| * |
| * * Redistributions of source code must retain the above copyright |
| * notice, this list of conditions and the following disclaimer. |
| * * Redistributions in binary form must reproduce the above copyright |
| * notice, this list of conditions and the following disclaimer in |
| * the documentation and/or other materials provided with the |
| * distribution. |
| * * Neither the name of Intel Corporation nor the names of its |
| * contributors may be used to endorse or promote products derived |
| * from this software without specific prior written permission. |
| * |
| * THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS |
| * "AS IS" AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT |
| * LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR |
| * A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT |
| * OWNER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, |
| * SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT |
| * LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, |
| * DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY |
| * THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT |
| * (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE |
| * OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE. |
| * |
| * |
| * Intel Corporation <linux-wimax@intel.com> |
| * Yanir Lubetkin <yanirx.lubetkin@intel.com> |
| * Inaky Perez-Gonzalez <inaky.perez-gonzalez@intel.com> |
| * - Initial implementation |
| * |
| * |
| * The notification endpoint is active when the device is not in boot |
| * mode; in here we just read and get notifications; based on those, |
| * we act to either reinitialize the device after a reboot or to |
| * submit a RX request. |
| * |
| * ROADMAP |
| * |
| * i2400mu_usb_notification_setup() |
| * |
| * i2400mu_usb_notification_release() |
| * |
| * i2400mu_usb_notification_cb() Called when a URB is ready |
| * i2400mu_notif_grok() |
| * i2400m_dev_reset_handle() |
| * i2400mu_rx_kick() |
| */ |
| #include <linux/usb.h> |
| #include "i2400m-usb.h" |
| |
| |
| #define D_SUBMODULE notif |
| #include "usb-debug-levels.h" |
| |
| |
| static const |
| __le32 i2400m_ZERO_BARKER[4] = { 0, 0, 0, 0 }; |
| |
| |
| /* |
| * Process a received notification |
| * |
| * In normal operation mode, we can only receive two types of payloads |
| * on the notification endpoint: |
| * |
| * - a reboot barker, we do a bootstrap (the device has reseted). |
| * |
| * - a block of zeroes: there is pending data in the IN endpoint |
| */ |
| static |
| int i2400mu_notification_grok(struct i2400mu *i2400mu, const void *buf, |
| size_t buf_len) |
| { |
| int ret; |
| struct device *dev = &i2400mu->usb_iface->dev; |
| struct i2400m *i2400m = &i2400mu->i2400m; |
| |
| d_fnstart(4, dev, "(i2400m %p buf %p buf_len %zu)\n", |
| i2400mu, buf, buf_len); |
| ret = -EIO; |
| if (buf_len < sizeof(i2400m_NBOOT_BARKER)) |
| /* Not a bug, just ignore */ |
| goto error_bad_size; |
| if (!memcmp(i2400m_NBOOT_BARKER, buf, sizeof(i2400m_NBOOT_BARKER)) |
| || !memcmp(i2400m_SBOOT_BARKER, buf, sizeof(i2400m_SBOOT_BARKER))) |
| ret = i2400m_dev_reset_handle(i2400m); |
| else if (!memcmp(i2400m_ZERO_BARKER, buf, sizeof(i2400m_ZERO_BARKER))) { |
| i2400mu_rx_kick(i2400mu); |
| ret = 0; |
| } else { /* Unknown or unexpected data in the notif message */ |
| char prefix[64]; |
| ret = -EIO; |
| dev_err(dev, "HW BUG? Unknown/unexpected data in notification " |
| "message (%zu bytes)\n", buf_len); |
| snprintf(prefix, sizeof(prefix), "%s %s: ", |
| dev_driver_string(dev), dev_name(dev)); |
| if (buf_len > 64) { |
| print_hex_dump(KERN_ERR, prefix, DUMP_PREFIX_OFFSET, |
| 8, 4, buf, 64, 0); |
| printk(KERN_ERR "%s... (only first 64 bytes " |
| "dumped)\n", prefix); |
| } else |
| print_hex_dump(KERN_ERR, prefix, DUMP_PREFIX_OFFSET, |
| 8, 4, buf, buf_len, 0); |
| } |
| error_bad_size: |
| d_fnend(4, dev, "(i2400m %p buf %p buf_len %zu) = %d\n", |
| i2400mu, buf, buf_len, ret); |
| return ret; |
| } |
| |
| |
| /* |
| * URB callback for the notification endpoint |
| * |
| * @urb: the urb received from the notification endpoint |
| * |
| * This function will just process the USB side of the transaction, |
| * checking everything is fine, pass the processing to |
| * i2400m_notification_grok() and resubmit the URB. |
| */ |
| static |
| void i2400mu_notification_cb(struct urb *urb) |
| { |
| int ret; |
| struct i2400mu *i2400mu = urb->context; |
| struct device *dev = &i2400mu->usb_iface->dev; |
| |
| d_fnstart(4, dev, "(urb %p status %d actual_length %d)\n", |
| urb, urb->status, urb->actual_length); |
| ret = urb->status; |
| switch (ret) { |
| case 0: |
| ret = i2400mu_notification_grok(i2400mu, urb->transfer_buffer, |
| urb->actual_length); |
| if (ret == -EIO && edc_inc(&i2400mu->urb_edc, EDC_MAX_ERRORS, |
| EDC_ERROR_TIMEFRAME)) |
| goto error_exceeded; |
| if (ret == -ENOMEM) /* uff...power cycle? shutdown? */ |
| goto error_exceeded; |
| break; |
| case -EINVAL: /* while removing driver */ |
| case -ENODEV: /* dev disconnect ... */ |
| case -ENOENT: /* ditto */ |
| case -ESHUTDOWN: /* URB killed */ |
| case -ECONNRESET: /* disconnection */ |
| goto out; /* Notify around */ |
| default: /* Some error? */ |
| if (edc_inc(&i2400mu->urb_edc, |
| EDC_MAX_ERRORS, EDC_ERROR_TIMEFRAME)) |
| goto error_exceeded; |
| dev_err(dev, "notification: URB error %d, retrying\n", |
| urb->status); |
| } |
| usb_mark_last_busy(i2400mu->usb_dev); |
| ret = usb_submit_urb(i2400mu->notif_urb, GFP_ATOMIC); |
| switch (ret) { |
| case 0: |
| case -EINVAL: /* while removing driver */ |
| case -ENODEV: /* dev disconnect ... */ |
| case -ENOENT: /* ditto */ |
| case -ESHUTDOWN: /* URB killed */ |
| case -ECONNRESET: /* disconnection */ |
| break; /* just ignore */ |
| default: /* Some error? */ |
| dev_err(dev, "notification: cannot submit URB: %d\n", ret); |
| goto error_submit; |
| } |
| d_fnend(4, dev, "(urb %p status %d actual_length %d) = void\n", |
| urb, urb->status, urb->actual_length); |
| return; |
| |
| error_exceeded: |
| dev_err(dev, "maximum errors in notification URB exceeded; " |
| "resetting device\n"); |
| error_submit: |
| usb_queue_reset_device(i2400mu->usb_iface); |
| out: |
| d_fnend(4, dev, "(urb %p status %d actual_length %d) = void\n", |
| urb, urb->status, urb->actual_length); |
| return; |
| } |
| |
| |
| /* |
| * setup the notification endpoint |
| * |
| * @i2400m: device descriptor |
| * |
| * This procedure prepares the notification urb and handler for receiving |
| * unsolicited barkers from the device. |
| */ |
| int i2400mu_notification_setup(struct i2400mu *i2400mu) |
| { |
| struct device *dev = &i2400mu->usb_iface->dev; |
| int usb_pipe, ret = 0; |
| struct usb_endpoint_descriptor *epd; |
| char *buf; |
| |
| d_fnstart(4, dev, "(i2400m %p)\n", i2400mu); |
| buf = kmalloc(I2400MU_MAX_NOTIFICATION_LEN, GFP_KERNEL | GFP_DMA); |
| if (buf == NULL) { |
| dev_err(dev, "notification: buffer allocation failed\n"); |
| ret = -ENOMEM; |
| goto error_buf_alloc; |
| } |
| |
| i2400mu->notif_urb = usb_alloc_urb(0, GFP_KERNEL); |
| if (!i2400mu->notif_urb) { |
| ret = -ENOMEM; |
| dev_err(dev, "notification: cannot allocate URB\n"); |
| goto error_alloc_urb; |
| } |
| epd = usb_get_epd(i2400mu->usb_iface, |
| i2400mu->endpoint_cfg.notification); |
| usb_pipe = usb_rcvintpipe(i2400mu->usb_dev, epd->bEndpointAddress); |
| usb_fill_int_urb(i2400mu->notif_urb, i2400mu->usb_dev, usb_pipe, |
| buf, I2400MU_MAX_NOTIFICATION_LEN, |
| i2400mu_notification_cb, i2400mu, epd->bInterval); |
| ret = usb_submit_urb(i2400mu->notif_urb, GFP_KERNEL); |
| if (ret != 0) { |
| dev_err(dev, "notification: cannot submit URB: %d\n", ret); |
| goto error_submit; |
| } |
| d_fnend(4, dev, "(i2400m %p) = %d\n", i2400mu, ret); |
| return ret; |
| |
| error_submit: |
| usb_free_urb(i2400mu->notif_urb); |
| error_alloc_urb: |
| kfree(buf); |
| error_buf_alloc: |
| d_fnend(4, dev, "(i2400m %p) = %d\n", i2400mu, ret); |
| return ret; |
| } |
| |
| |
| /* |
| * Tear down of the notification mechanism |
| * |
| * @i2400m: device descriptor |
| * |
| * Kill the interrupt endpoint urb, free any allocated resources. |
| * |
| * We need to check if we have done it before as for example, |
| * _suspend() call this; if after a suspend() we get a _disconnect() |
| * (as the case is when hibernating), nothing bad happens. |
| */ |
| void i2400mu_notification_release(struct i2400mu *i2400mu) |
| { |
| struct device *dev = &i2400mu->usb_iface->dev; |
| |
| d_fnstart(4, dev, "(i2400mu %p)\n", i2400mu); |
| if (i2400mu->notif_urb != NULL) { |
| usb_kill_urb(i2400mu->notif_urb); |
| kfree(i2400mu->notif_urb->transfer_buffer); |
| usb_free_urb(i2400mu->notif_urb); |
| i2400mu->notif_urb = NULL; |
| } |
| d_fnend(4, dev, "(i2400mu %p)\n", i2400mu); |
| } |