| /* |
| * linux/arch/arm/plat-omap/common.c |
| * |
| * Code common to all OMAP machines. |
| * |
| * This program is free software; you can redistribute it and/or modify |
| * it under the terms of the GNU General Public License version 2 as |
| * published by the Free Software Foundation. |
| */ |
| #include <linux/module.h> |
| #include <linux/kernel.h> |
| #include <linux/init.h> |
| #include <linux/delay.h> |
| #include <linux/pm.h> |
| #include <linux/console.h> |
| #include <linux/serial.h> |
| #include <linux/tty.h> |
| #include <linux/serial_8250.h> |
| #include <linux/serial_reg.h> |
| #include <linux/clk.h> |
| #include <linux/io.h> |
| |
| #include <mach/hardware.h> |
| #include <asm/system.h> |
| #include <asm/pgtable.h> |
| #include <asm/mach/map.h> |
| #include <asm/setup.h> |
| |
| #include <mach/common.h> |
| #include <mach/board.h> |
| #include <mach/control.h> |
| #include <mach/mux.h> |
| #include <mach/fpga.h> |
| |
| #include <mach/clock.h> |
| |
| #if defined(CONFIG_ARCH_OMAP2) || defined(CONFIG_ARCH_OMAP3) |
| # include "../mach-omap2/sdrc.h" |
| #endif |
| |
| #define NO_LENGTH_CHECK 0xffffffff |
| |
| unsigned char omap_bootloader_tag[512]; |
| int omap_bootloader_tag_len; |
| |
| struct omap_board_config_kernel *omap_board_config; |
| int omap_board_config_size; |
| |
| static const void *get_config(u16 tag, size_t len, int skip, size_t *len_out) |
| { |
| struct omap_board_config_kernel *kinfo = NULL; |
| int i; |
| |
| #ifdef CONFIG_OMAP_BOOT_TAG |
| struct omap_board_config_entry *info = NULL; |
| |
| if (omap_bootloader_tag_len > 4) |
| info = (struct omap_board_config_entry *) omap_bootloader_tag; |
| while (info != NULL) { |
| u8 *next; |
| |
| if (info->tag == tag) { |
| if (skip == 0) |
| break; |
| skip--; |
| } |
| |
| if ((info->len & 0x03) != 0) { |
| /* We bail out to avoid an alignment fault */ |
| printk(KERN_ERR "OMAP peripheral config: Length (%d) not word-aligned (tag %04x)\n", |
| info->len, info->tag); |
| return NULL; |
| } |
| next = (u8 *) info + sizeof(*info) + info->len; |
| if (next >= omap_bootloader_tag + omap_bootloader_tag_len) |
| info = NULL; |
| else |
| info = (struct omap_board_config_entry *) next; |
| } |
| if (info != NULL) { |
| /* Check the length as a lame attempt to check for |
| * binary inconsistency. */ |
| if (len != NO_LENGTH_CHECK) { |
| /* Word-align len */ |
| if (len & 0x03) |
| len = (len + 3) & ~0x03; |
| if (info->len != len) { |
| printk(KERN_ERR "OMAP peripheral config: Length mismatch with tag %x (want %d, got %d)\n", |
| tag, len, info->len); |
| return NULL; |
| } |
| } |
| if (len_out != NULL) |
| *len_out = info->len; |
| return info->data; |
| } |
| #endif |
| /* Try to find the config from the board-specific structures |
| * in the kernel. */ |
| for (i = 0; i < omap_board_config_size; i++) { |
| if (omap_board_config[i].tag == tag) { |
| if (skip == 0) { |
| kinfo = &omap_board_config[i]; |
| break; |
| } else { |
| skip--; |
| } |
| } |
| } |
| if (kinfo == NULL) |
| return NULL; |
| return kinfo->data; |
| } |
| |
| const void *__omap_get_config(u16 tag, size_t len, int nr) |
| { |
| return get_config(tag, len, nr, NULL); |
| } |
| EXPORT_SYMBOL(__omap_get_config); |
| |
| const void *omap_get_var_config(u16 tag, size_t *len) |
| { |
| return get_config(tag, NO_LENGTH_CHECK, 0, len); |
| } |
| EXPORT_SYMBOL(omap_get_var_config); |
| |
| static int __init omap_add_serial_console(void) |
| { |
| const struct omap_serial_console_config *con_info; |
| const struct omap_uart_config *uart_info; |
| static char speed[11], *opt = NULL; |
| int line, i, uart_idx; |
| |
| uart_info = omap_get_config(OMAP_TAG_UART, struct omap_uart_config); |
| con_info = omap_get_config(OMAP_TAG_SERIAL_CONSOLE, |
| struct omap_serial_console_config); |
| if (uart_info == NULL || con_info == NULL) |
| return 0; |
| |
| if (con_info->console_uart == 0) |
| return 0; |
| |
| if (con_info->console_speed) { |
| snprintf(speed, sizeof(speed), "%u", con_info->console_speed); |
| opt = speed; |
| } |
| |
| uart_idx = con_info->console_uart - 1; |
| if (uart_idx >= OMAP_MAX_NR_PORTS) { |
| printk(KERN_INFO "Console: external UART#%d. " |
| "Not adding it as console this time.\n", |
| uart_idx + 1); |
| return 0; |
| } |
| if (!(uart_info->enabled_uarts & (1 << uart_idx))) { |
| printk(KERN_ERR "Console: Selected UART#%d is " |
| "not enabled for this platform\n", |
| uart_idx + 1); |
| return -1; |
| } |
| line = 0; |
| for (i = 0; i < uart_idx; i++) { |
| if (uart_info->enabled_uarts & (1 << i)) |
| line++; |
| } |
| return add_preferred_console("ttyS", line, opt); |
| } |
| console_initcall(omap_add_serial_console); |
| |
| |
| /* |
| * 32KHz clocksource ... always available, on pretty most chips except |
| * OMAP 730 and 1510. Other timers could be used as clocksources, with |
| * higher resolution in free-running counter modes (e.g. 12 MHz xtal), |
| * but systems won't necessarily want to spend resources that way. |
| */ |
| |
| #if defined(CONFIG_ARCH_OMAP16XX) |
| #define TIMER_32K_SYNCHRONIZED 0xfffbc410 |
| #elif defined(CONFIG_ARCH_OMAP24XX) || defined(CONFIG_ARCH_OMAP34XX) |
| #define TIMER_32K_SYNCHRONIZED (OMAP2_32KSYNCT_BASE + 0x10) |
| #endif |
| |
| #ifdef TIMER_32K_SYNCHRONIZED |
| |
| #include <linux/clocksource.h> |
| |
| static cycle_t omap_32k_read(void) |
| { |
| return omap_readl(TIMER_32K_SYNCHRONIZED); |
| } |
| |
| static struct clocksource clocksource_32k = { |
| .name = "32k_counter", |
| .rating = 250, |
| .read = omap_32k_read, |
| .mask = CLOCKSOURCE_MASK(32), |
| .shift = 10, |
| .flags = CLOCK_SOURCE_IS_CONTINUOUS, |
| }; |
| |
| /* |
| * Rounds down to nearest nsec. |
| */ |
| unsigned long long omap_32k_ticks_to_nsecs(unsigned long ticks_32k) |
| { |
| return cyc2ns(&clocksource_32k, ticks_32k); |
| } |
| |
| /* |
| * Returns current time from boot in nsecs. It's OK for this to wrap |
| * around for now, as it's just a relative time stamp. |
| */ |
| unsigned long long sched_clock(void) |
| { |
| return omap_32k_ticks_to_nsecs(omap_32k_read()); |
| } |
| |
| static int __init omap_init_clocksource_32k(void) |
| { |
| static char err[] __initdata = KERN_ERR |
| "%s: can't register clocksource!\n"; |
| |
| if (cpu_is_omap16xx() || cpu_class_is_omap2()) { |
| struct clk *sync_32k_ick; |
| |
| sync_32k_ick = clk_get(NULL, "omap_32ksync_ick"); |
| if (sync_32k_ick) |
| clk_enable(sync_32k_ick); |
| |
| clocksource_32k.mult = clocksource_hz2mult(32768, |
| clocksource_32k.shift); |
| |
| if (clocksource_register(&clocksource_32k)) |
| printk(err, clocksource_32k.name); |
| } |
| return 0; |
| } |
| arch_initcall(omap_init_clocksource_32k); |
| |
| #endif /* TIMER_32K_SYNCHRONIZED */ |
| |
| /* Global address base setup code */ |
| |
| #if defined(CONFIG_ARCH_OMAP2) || defined(CONFIG_ARCH_OMAP3) |
| |
| static struct omap_globals *omap2_globals; |
| |
| static void __init __omap2_set_globals(void) |
| { |
| omap2_set_globals_memory(omap2_globals); |
| omap2_set_globals_control(omap2_globals); |
| omap2_set_globals_prcm(omap2_globals); |
| } |
| |
| #endif |
| |
| #if defined(CONFIG_ARCH_OMAP2420) |
| |
| static struct omap_globals omap242x_globals = { |
| .tap = (__force void __iomem *)OMAP2_IO_ADDRESS(0x48014000), |
| .sdrc = (__force void __iomem *)OMAP2_IO_ADDRESS(OMAP2420_SDRC_BASE), |
| .sms = (__force void __iomem *)OMAP2_IO_ADDRESS(OMAP2420_SMS_BASE), |
| .ctrl = (__force void __iomem *)OMAP2_IO_ADDRESS(OMAP2420_CTRL_BASE), |
| .prm = (__force void __iomem *)OMAP2_IO_ADDRESS(OMAP2420_PRM_BASE), |
| .cm = (__force void __iomem *)OMAP2_IO_ADDRESS(OMAP2420_CM_BASE), |
| }; |
| |
| void __init omap2_set_globals_242x(void) |
| { |
| omap2_globals = &omap242x_globals; |
| __omap2_set_globals(); |
| } |
| #endif |
| |
| #if defined(CONFIG_ARCH_OMAP2430) |
| |
| static struct omap_globals omap243x_globals = { |
| .tap = (__force void __iomem *)OMAP2_IO_ADDRESS(0x4900a000), |
| .sdrc = (__force void __iomem *)OMAP2_IO_ADDRESS(OMAP243X_SDRC_BASE), |
| .sms = (__force void __iomem *)OMAP2_IO_ADDRESS(OMAP243X_SMS_BASE), |
| .ctrl = (__force void __iomem *)OMAP2_IO_ADDRESS(OMAP243X_CTRL_BASE), |
| .prm = (__force void __iomem *)OMAP2_IO_ADDRESS(OMAP2430_PRM_BASE), |
| .cm = (__force void __iomem *)OMAP2_IO_ADDRESS(OMAP2430_CM_BASE), |
| }; |
| |
| void __init omap2_set_globals_243x(void) |
| { |
| omap2_globals = &omap243x_globals; |
| __omap2_set_globals(); |
| } |
| #endif |
| |
| #if defined(CONFIG_ARCH_OMAP3430) |
| |
| static struct omap_globals omap343x_globals = { |
| .tap = (__force void __iomem *)OMAP2_IO_ADDRESS(0x4830A000), |
| .sdrc = (__force void __iomem *)OMAP2_IO_ADDRESS(OMAP343X_SDRC_BASE), |
| .sms = (__force void __iomem *)OMAP2_IO_ADDRESS(OMAP343X_SMS_BASE), |
| .ctrl = (__force void __iomem *)OMAP2_IO_ADDRESS(OMAP343X_CTRL_BASE), |
| .prm = (__force void __iomem *)OMAP2_IO_ADDRESS(OMAP3430_PRM_BASE), |
| .cm = (__force void __iomem *)OMAP2_IO_ADDRESS(OMAP3430_CM_BASE), |
| }; |
| |
| void __init omap2_set_globals_343x(void) |
| { |
| omap2_globals = &omap343x_globals; |
| __omap2_set_globals(); |
| } |
| #endif |
| |