[media] cec: improve dqevent documentation
The documentation for the cec_event_state_change struct was incomplete.
This patch documents what happens in the corner cases.
Signed-off-by: Hans Verkuil <hans.verkuil@cisco.com>
Signed-off-by: Mauro Carvalho Chehab <mchehab@s-opensource.com>
diff --git a/Documentation/media/uapi/cec/cec-ioc-dqevent.rst b/Documentation/media/uapi/cec/cec-ioc-dqevent.rst
index 7a6d6d0..2e1e7392 100644
--- a/Documentation/media/uapi/cec/cec-ioc-dqevent.rst
+++ b/Documentation/media/uapi/cec/cec-ioc-dqevent.rst
@@ -64,7 +64,8 @@
- ``phys_addr``
- - The current physical address.
+ - The current physical address. This is ``CEC_PHYS_ADDR_INVALID`` if no
+ valid physical address is set.
- .. row 2
@@ -72,7 +73,10 @@
- ``log_addr_mask``
- - The current set of claimed logical addresses.
+ - The current set of claimed logical addresses. This is 0 if no logical
+ addresses are claimed or if ``phys_addr`` is ``CEC_PHYS_ADDR_INVALID``.
+ If bit 15 is set (``1 << CEC_LOG_ADDR_UNREGISTERED``) then this device
+ has the unregistered logical address. In that case all other bits are 0.