| /* |
| * drivers/gpio/max7301.c |
| * |
| * Copyright (C) 2006 Juergen Beisert, Pengutronix |
| * Copyright (C) 2008 Guennadi Liakhovetski, Pengutronix |
| * Copyright (C) 2009 Wolfram Sang, Pengutronix |
| * |
| * This program is free software; you can redistribute it and/or modify |
| * it under the terms of the GNU General Public License version 2 as |
| * published by the Free Software Foundation. |
| * |
| * Check max730x.c for further details. |
| */ |
| |
| #include <linux/module.h> |
| #include <linux/init.h> |
| #include <linux/platform_device.h> |
| #include <linux/mutex.h> |
| #include <linux/spi/spi.h> |
| #include <linux/spi/max7301.h> |
| |
| /* A write to the MAX7301 means one message with one transfer */ |
| static int max7301_spi_write(struct device *dev, unsigned int reg, |
| unsigned int val) |
| { |
| struct spi_device *spi = to_spi_device(dev); |
| u16 word = ((reg & 0x7F) << 8) | (val & 0xFF); |
| |
| return spi_write(spi, (const u8 *)&word, sizeof(word)); |
| } |
| |
| /* A read from the MAX7301 means two transfers; here, one message each */ |
| |
| static int max7301_spi_read(struct device *dev, unsigned int reg) |
| { |
| int ret; |
| u16 word; |
| struct spi_device *spi = to_spi_device(dev); |
| |
| word = 0x8000 | (reg << 8); |
| ret = spi_write(spi, (const u8 *)&word, sizeof(word)); |
| if (ret) |
| return ret; |
| /* |
| * This relies on the fact, that a transfer with NULL tx_buf shifts out |
| * zero bytes (=NOOP for MAX7301) |
| */ |
| ret = spi_read(spi, (u8 *)&word, sizeof(word)); |
| if (ret) |
| return ret; |
| return word & 0xff; |
| } |
| |
| static int __devinit max7301_probe(struct spi_device *spi) |
| { |
| struct max7301 *ts; |
| int ret; |
| |
| /* bits_per_word cannot be configured in platform data */ |
| spi->bits_per_word = 16; |
| ret = spi_setup(spi); |
| if (ret < 0) |
| return ret; |
| |
| ts = kzalloc(sizeof(struct max7301), GFP_KERNEL); |
| if (!ts) |
| return -ENOMEM; |
| |
| ts->read = max7301_spi_read; |
| ts->write = max7301_spi_write; |
| ts->dev = &spi->dev; |
| |
| ret = __max730x_probe(ts); |
| if (ret) |
| kfree(ts); |
| return ret; |
| } |
| |
| static int __devexit max7301_remove(struct spi_device *spi) |
| { |
| return __max730x_remove(&spi->dev); |
| } |
| |
| static const struct spi_device_id max7301_id[] = { |
| { "max7301", 0 }, |
| { } |
| }; |
| MODULE_DEVICE_TABLE(spi, max7301_id); |
| |
| static struct spi_driver max7301_driver = { |
| .driver = { |
| .name = "max7301", |
| .owner = THIS_MODULE, |
| }, |
| .probe = max7301_probe, |
| .remove = __devexit_p(max7301_remove), |
| .id_table = max7301_id, |
| }; |
| |
| static int __init max7301_init(void) |
| { |
| return spi_register_driver(&max7301_driver); |
| } |
| /* register after spi postcore initcall and before |
| * subsys initcalls that may rely on these GPIOs |
| */ |
| subsys_initcall(max7301_init); |
| |
| static void __exit max7301_exit(void) |
| { |
| spi_unregister_driver(&max7301_driver); |
| } |
| module_exit(max7301_exit); |
| |
| MODULE_AUTHOR("Juergen Beisert, Wolfram Sang"); |
| MODULE_LICENSE("GPL v2"); |
| MODULE_DESCRIPTION("MAX7301 GPIO-Expander"); |