| /* |
| * Copyright (C) 2001-2006 Storlink, Corp. |
| * Copyright (C) 2008-2009 Paulius Zaleckas <paulius.zaleckas@teltonika.lt> |
| * |
| * This program is free software; you can redistribute it and/or modify |
| * it under the terms of the GNU General Public License as published by |
| * the Free Software Foundation; either version 2 of the License, or |
| * (at your option) any later version. |
| */ |
| #include <linux/interrupt.h> |
| #include <linux/irq.h> |
| #include <linux/io.h> |
| #include <mach/hardware.h> |
| #include <mach/global_reg.h> |
| #include <asm/mach/time.h> |
| |
| /* |
| * Register definitions for the timers |
| */ |
| #define TIMER_COUNT(BASE_ADDR) (BASE_ADDR + 0x00) |
| #define TIMER_LOAD(BASE_ADDR) (BASE_ADDR + 0x04) |
| #define TIMER_MATCH1(BASE_ADDR) (BASE_ADDR + 0x08) |
| #define TIMER_MATCH2(BASE_ADDR) (BASE_ADDR + 0x0C) |
| #define TIMER_CR(BASE_ADDR) (BASE_ADDR + 0x30) |
| |
| #define TIMER_1_CR_ENABLE (1 << 0) |
| #define TIMER_1_CR_CLOCK (1 << 1) |
| #define TIMER_1_CR_INT (1 << 2) |
| #define TIMER_2_CR_ENABLE (1 << 3) |
| #define TIMER_2_CR_CLOCK (1 << 4) |
| #define TIMER_2_CR_INT (1 << 5) |
| #define TIMER_3_CR_ENABLE (1 << 6) |
| #define TIMER_3_CR_CLOCK (1 << 7) |
| #define TIMER_3_CR_INT (1 << 8) |
| |
| /* |
| * IRQ handler for the timer |
| */ |
| static irqreturn_t gemini_timer_interrupt(int irq, void *dev_id) |
| { |
| timer_tick(); |
| |
| return IRQ_HANDLED; |
| } |
| |
| static struct irqaction gemini_timer_irq = { |
| .name = "Gemini Timer Tick", |
| .flags = IRQF_DISABLED | IRQF_TIMER, |
| .handler = gemini_timer_interrupt, |
| }; |
| |
| /* |
| * Set up timer interrupt, and return the current time in seconds. |
| */ |
| void __init gemini_timer_init(void) |
| { |
| unsigned int tick_rate, reg_v; |
| |
| reg_v = __raw_readl(IO_ADDRESS(GEMINI_GLOBAL_BASE + GLOBAL_STATUS)); |
| tick_rate = REG_TO_AHB_SPEED(reg_v) * 1000000; |
| |
| printk(KERN_INFO "Bus: %dMHz", tick_rate / 1000000); |
| |
| tick_rate /= 6; /* APB bus run AHB*(1/6) */ |
| |
| switch(reg_v & CPU_AHB_RATIO_MASK) { |
| case CPU_AHB_1_1: |
| printk(KERN_CONT "(1/1)\n"); |
| break; |
| case CPU_AHB_3_2: |
| printk(KERN_CONT "(3/2)\n"); |
| break; |
| case CPU_AHB_24_13: |
| printk(KERN_CONT "(24/13)\n"); |
| break; |
| case CPU_AHB_2_1: |
| printk(KERN_CONT "(2/1)\n"); |
| break; |
| } |
| |
| /* |
| * Make irqs happen for the system timer |
| */ |
| setup_irq(IRQ_TIMER2, &gemini_timer_irq); |
| /* Start the timer */ |
| __raw_writel(tick_rate / HZ, TIMER_COUNT(IO_ADDRESS(GEMINI_TIMER2_BASE))); |
| __raw_writel(tick_rate / HZ, TIMER_LOAD(IO_ADDRESS(GEMINI_TIMER2_BASE))); |
| __raw_writel(TIMER_2_CR_ENABLE | TIMER_2_CR_INT, TIMER_CR(IO_ADDRESS(GEMINI_TIMER_BASE))); |
| } |