| Documentation for /proc/sys/net/* kernel version 2.4.0-test11-pre4 |
| (c) 1999 Terrehon Bowden <terrehon@pacbell.net> |
| Bodo Bauer <bb@ricochet.net> |
| (c) 2000 Jorge Nerin <comandante@zaralinux.com> |
| (c) 2009 Shen Feng <shen@cn.fujitsu.com> |
| |
| For general info and legal blurb, please look in README. |
| |
| ============================================================== |
| |
| This file contains the documentation for the sysctl files in |
| /proc/sys/net and is valid for Linux kernel version 2.4.0-test11-pre4. |
| |
| The interface to the networking parts of the kernel is located in |
| /proc/sys/net. The following table shows all possible subdirectories.You may |
| see only some of them, depending on your kernel's configuration. |
| |
| |
| Table : Subdirectories in /proc/sys/net |
| .............................................................................. |
| Directory Content Directory Content |
| core General parameter appletalk Appletalk protocol |
| unix Unix domain sockets netrom NET/ROM |
| 802 E802 protocol ax25 AX25 |
| ethernet Ethernet protocol rose X.25 PLP layer |
| ipv4 IP version 4 x25 X.25 protocol |
| ipx IPX token-ring IBM token ring |
| bridge Bridging decnet DEC net |
| ipv6 IP version 6 |
| .............................................................................. |
| |
| 1. /proc/sys/net/core - Network core options |
| ------------------------------------------------------- |
| |
| rmem_default |
| ------------ |
| |
| The default setting of the socket receive buffer in bytes. |
| |
| rmem_max |
| -------- |
| |
| The maximum receive socket buffer size in bytes. |
| |
| wmem_default |
| ------------ |
| |
| The default setting (in bytes) of the socket send buffer. |
| |
| wmem_max |
| -------- |
| |
| The maximum send socket buffer size in bytes. |
| |
| message_burst and message_cost |
| ------------------------------ |
| |
| These parameters are used to limit the warning messages written to the kernel |
| log from the networking code. They enforce a rate limit to make a |
| denial-of-service attack impossible. A higher message_cost factor, results in |
| fewer messages that will be written. Message_burst controls when messages will |
| be dropped. The default settings limit warning messages to one every five |
| seconds. |
| |
| warnings |
| -------- |
| |
| This controls console messages from the networking stack that can occur because |
| of problems on the network like duplicate address or bad checksums. Normally, |
| this should be enabled, but if the problem persists the messages can be |
| disabled. |
| |
| netdev_budget |
| ------------- |
| |
| Maximum number of packets taken from all interfaces in one polling cycle (NAPI |
| poll). In one polling cycle interfaces which are registered to polling are |
| probed in a round-robin manner. The limit of packets in one such probe can be |
| set per-device via sysfs class/net/<device>/weight . |
| |
| netdev_max_backlog |
| ------------------ |
| |
| Maximum number of packets, queued on the INPUT side, when the interface |
| receives packets faster than kernel can process them. |
| |
| optmem_max |
| ---------- |
| |
| Maximum ancillary buffer size allowed per socket. Ancillary data is a sequence |
| of struct cmsghdr structures with appended data. |
| |
| 2. /proc/sys/net/unix - Parameters for Unix domain sockets |
| ------------------------------------------------------- |
| |
| There is only one file in this directory. |
| unix_dgram_qlen limits the max number of datagrams queued in Unix domain |
| socket's buffer. It will not take effect unless PF_UNIX flag is spicified. |
| |
| |
| 3. /proc/sys/net/ipv4 - IPV4 settings |
| ------------------------------------------------------- |
| Please see: Documentation/networking/ip-sysctl.txt and ipvs-sysctl.txt for |
| descriptions of these entries. |
| |
| |
| 4. Appletalk |
| ------------------------------------------------------- |
| |
| The /proc/sys/net/appletalk directory holds the Appletalk configuration data |
| when Appletalk is loaded. The configurable parameters are: |
| |
| aarp-expiry-time |
| ---------------- |
| |
| The amount of time we keep an ARP entry before expiring it. Used to age out |
| old hosts. |
| |
| aarp-resolve-time |
| ----------------- |
| |
| The amount of time we will spend trying to resolve an Appletalk address. |
| |
| aarp-retransmit-limit |
| --------------------- |
| |
| The number of times we will retransmit a query before giving up. |
| |
| aarp-tick-time |
| -------------- |
| |
| Controls the rate at which expires are checked. |
| |
| The directory /proc/net/appletalk holds the list of active Appletalk sockets |
| on a machine. |
| |
| The fields indicate the DDP type, the local address (in network:node format) |
| the remote address, the size of the transmit pending queue, the size of the |
| received queue (bytes waiting for applications to read) the state and the uid |
| owning the socket. |
| |
| /proc/net/atalk_iface lists all the interfaces configured for appletalk.It |
| shows the name of the interface, its Appletalk address, the network range on |
| that address (or network number for phase 1 networks), and the status of the |
| interface. |
| |
| /proc/net/atalk_route lists each known network route. It lists the target |
| (network) that the route leads to, the router (may be directly connected), the |
| route flags, and the device the route is using. |
| |
| |
| 5. IPX |
| ------------------------------------------------------- |
| |
| The IPX protocol has no tunable values in proc/sys/net. |
| |
| The IPX protocol does, however, provide proc/net/ipx. This lists each IPX |
| socket giving the local and remote addresses in Novell format (that is |
| network:node:port). In accordance with the strange Novell tradition, |
| everything but the port is in hex. Not_Connected is displayed for sockets that |
| are not tied to a specific remote address. The Tx and Rx queue sizes indicate |
| the number of bytes pending for transmission and reception. The state |
| indicates the state the socket is in and the uid is the owning uid of the |
| socket. |
| |
| The /proc/net/ipx_interface file lists all IPX interfaces. For each interface |
| it gives the network number, the node number, and indicates if the network is |
| the primary network. It also indicates which device it is bound to (or |
| Internal for internal networks) and the Frame Type if appropriate. Linux |
| supports 802.3, 802.2, 802.2 SNAP and DIX (Blue Book) ethernet framing for |
| IPX. |
| |
| The /proc/net/ipx_route table holds a list of IPX routes. For each route it |
| gives the destination network, the router node (or Directly) and the network |
| address of the router (or Connected) for internal networks. |