| source "drivers/video/fbdev/msm/msm_dba/Kconfig" |
| |
| if FB_MSM |
| |
| config FB_MSM_MDSS_COMMON |
| bool |
| |
| choice |
| prompt "MDP HW version" |
| default FB_MSM_MDP |
| |
| config FB_MSM_MDP |
| bool "MDP HW" |
| select FB_MSM_MDP_HW |
| ---help--- |
| The Mobile Display Processor (MDP) driver support devices which |
| contain MDP hardware block. |
| |
| Support for MSM MDP HW revision 2.2. |
| Say Y here if this is msm7201 variant platform. |
| |
| config FB_MSM_MDSS |
| bool "MDSS HW" |
| select SYNC |
| select SW_SYNC |
| select FB_MSM_MDSS_COMMON |
| ---help--- |
| The Mobile Display Sub System (MDSS) driver supports devices which |
| contain MDSS hardware block. |
| |
| The MDSS driver implements frame buffer interface to provide access to |
| the display hardware and provide a way for users to display graphics |
| on connected display panels. |
| |
| config FB_MSM_MDP_NONE |
| bool "MDP HW None" |
| ---help--- |
| This is used for platforms without Mobile Display Sub System (MDSS). |
| mdm platform don't have MDSS hardware block. |
| |
| Say Y here if this is mdm platform. |
| |
| endchoice |
| |
| config FB_MSM_QPIC |
| bool |
| select FB_MSM_MDSS_COMMON |
| |
| config FB_MSM_QPIC_ILI_QVGA_PANEL |
| bool "Qpic MIPI ILI QVGA Panel" |
| select FB_MSM_QPIC |
| ---help--- |
| Support for MIPI ILI QVGA (240x320) panel ILI TECHNOLOGY 9341 |
| with on-chip full display RAM use parallel interface. |
| |
| config FB_MSM_QPIC_PANEL_DETECT |
| bool "Qpic Panel Detect" |
| select FB_MSM_QPIC_ILI_QVGA_PANEL |
| ---help--- |
| Support for Qpic panel auto detect. |
| |
| config FB_MSM_MDSS_WRITEBACK |
| bool "MDSS Writeback Panel" |
| ---help--- |
| The MDSS Writeback Panel provides support for routing the output of |
| MDSS frame buffer driver and MDP processing to memory. |
| |
| config FB_MSM_MDSS_HDMI_PANEL |
| bool "MDSS HDMI Tx Panel" |
| depends on FB_MSM_MDSS |
| select MSM_EXT_DISPLAY |
| default n |
| ---help--- |
| The MDSS HDMI Panel provides support for transmitting TMDS signals of |
| MDSS frame buffer data to connected hdmi compliant TVs, monitors etc. |
| |
| config FB_MSM_MDSS_HDMI_MHL_SII8334 |
| depends on FB_MSM_MDSS_HDMI_PANEL |
| bool 'MHL SII8334 support ' |
| default n |
| ---help--- |
| Support the HDMI to MHL conversion. |
| MHL (Mobile High-Definition Link) technology |
| uses USB connector to output HDMI content |
| |
| config FB_MSM_MDSS_MHL3 |
| depends on FB_MSM_MDSS_HDMI_PANEL |
| bool "MHL3 SII8620 Support" |
| default n |
| ---help--- |
| Support the SiliconImage 8620 MHL Tx transmitter that uses |
| USB connector to output HDMI content. Transmitter is an |
| i2c device acting as an HDMI to MHL bridge. Chip supports |
| MHL 3.0 standard. |
| |
| config FB_MSM_MDSS_DSI_CTRL_STATUS |
| tristate "DSI controller status check feature" |
| ---help--- |
| Check DSI controller status periodically (default period is 5 |
| seconds) by sending Bus-Turn-Around (BTA) command. If DSI controller |
| fails to acknowledge the BTA command, it sends PANEL_ALIVE=0 status |
| to HAL layer to reset the controller. |
| |
| config FB_MSM_MDSS_EDP_PANEL |
| depends on FB_MSM_MDSS |
| bool "MDSS eDP Panel" |
| ---help--- |
| The MDSS eDP Panel provides support for eDP host controller driver. |
| Which runs in Video mode only and is responsible for transmitting |
| frame buffer from host SOC to eDP display panel. |
| |
| config FB_MSM_MDSS_MDP3 |
| depends on FB_MSM_MDSS |
| bool "MDP3 display controller" |
| ---help--- |
| The MDP3 provides support for an older version display controller. |
| Included in latest display sub-system, known as MDSS. |
| |
| config FB_MSM_MDSS_XLOG_DEBUG |
| depends on FB_MSM_MDSS |
| bool "Enable MDSS debugging" |
| ---help--- |
| The MDSS debugging provides support to enable display debugging |
| features to: Dump MDSS registers during driver errors, panic |
| driver during fatal errors and enable some display-driver logging |
| into an internal buffer (this avoids logging overhead). |
| |
| config FB_MSM_MDSS_FRC_DEBUG |
| depends on DEBUG_FS && FB_MSM_MDSS |
| bool "Enable Video FRC debugging" |
| default n |
| ---help--- |
| The MDSS FRC debugging provides support to enable the deterministic |
| frame rate control (FRC) debugging features to: Collect video frame |
| statistics and check whether its output pattern matches expected |
| cadence. |
| |
| endif |