| /****************************************************************************** |
| * QLOGIC LINUX SOFTWARE |
| * |
| * QLogic ISP2x00 device driver for Linux 2.6.x |
| * Copyright (C) 2003-2004 QLogic Corporation |
| * (www.qlogic.com) |
| * |
| * This program is free software; you can redistribute it and/or modify it |
| * under the terms of the GNU General Public License as published by the |
| * Free Software Foundation; either version 2, or (at your option) any |
| * later version. |
| * |
| * This program is distributed in the hope that it will be useful, but |
| * WITHOUT ANY WARRANTY; without even the implied warranty of |
| * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the GNU |
| * General Public License for more details. |
| * |
| ******************************************************************************/ |
| /* |
| * Compile time Options: |
| * 0 - Disable and 1 - Enable |
| */ |
| #define DEBUG_QLA2100 0 /* For Debug of qla2x00 */ |
| |
| #define STOP_ON_RESET 0 |
| #define USE_ABORT_TGT 1 /* Use Abort Target mbx cmd */ |
| |
| #define VSA 0 /* Volume Set Addressing */ |
| |
| /* Failover options */ |
| #define MAX_RECOVERYTIME 10 /* |
| * Max suspend time for a lun recovery |
| * time |
| */ |
| #define MAX_FAILBACKTIME 5 /* Max suspend time before fail back */ |
| |
| #define QLA_CMD_TIMER_DELTA 3 |
| |
| /* |
| * When a lun is suspended for the "Not Ready" condition then it will suspend |
| * the lun for increments of 6 sec delays. SUSPEND_COUNT is that count. |
| */ |
| #define SUSPEND_COUNT 10 /* 6 secs * 10 retries = 60 secs */ |
| |
| /* |
| * Defines the time in seconds that the driver extends the command timeout to |
| * get around the problem where the mid-layer only allows 5 retries for |
| * commands that return BUS_BUSY |
| */ |
| #define EXTEND_CMD_TIMEOUT 60 |
| |
| #define MAX_RETRIES_OF_ISP_ABORT 5 |
| |
| /* Max time to wait for the loop to be in LOOP_READY state */ |
| #define MAX_LOOP_TIMEOUT (60 * 5) |
| #define EH_ACTIVE 1 /* Error handler active */ |
| |
| /* |
| * Some vendor subsystems do not recover properly after a device reset. Define |
| * the following to force a logout after a successful device reset. |
| */ |
| #undef LOGOUT_AFTER_DEVICE_RESET |
| |
| #include "qla_version.h" |