| |
| /* |
| * Board initialization code should put one of these into dev->platform_data |
| * and place the isp116x onto platform_bus. |
| */ |
| |
| struct isp116x_platform_data { |
| /* Enable internal resistors on downstream ports */ |
| unsigned sel15Kres:1; |
| /* Chip's internal clock won't be stopped in suspended state. |
| Setting/unsetting this bit takes effect only if |
| 'remote_wakeup_enable' below is not set. */ |
| unsigned clknotstop:1; |
| /* On-chip overcurrent protection */ |
| unsigned oc_enable:1; |
| /* INT output polarity */ |
| unsigned int_act_high:1; |
| /* INT edge or level triggered */ |
| unsigned int_edge_triggered:1; |
| /* WAKEUP pin connected - NOT SUPPORTED */ |
| /* unsigned remote_wakeup_connected:1; */ |
| /* Wakeup by devices on usb bus enabled */ |
| unsigned remote_wakeup_enable:1; |
| /* Switch or not to switch (keep always powered) */ |
| unsigned no_power_switching:1; |
| /* Ganged port power switching (0) or individual port |
| power switching (1) */ |
| unsigned power_switching_mode:1; |
| /* Given port_power, msec/2 after power on till power good */ |
| u8 potpg; |
| /* Hardware reset set/clear. If implemented, this function must: |
| if set == 0, deassert chip's HW reset pin |
| otherwise, assert chip's HW reset pin */ |
| void (*reset) (struct device * dev, int set); |
| /* Hardware clock start/stop. If implemented, this function must: |
| if start == 0, stop the external clock |
| otherwise, start the external clock |
| */ |
| void (*clock) (struct device * dev, int start); |
| /* Inter-io delay (ns). The chip is picky about access timings; it |
| expects at least: |
| 150ns delay between consecutive accesses to DATA_REG, |
| 300ns delay between access to ADDR_REG and DATA_REG |
| OE, WE MUST NOT be changed during these intervals |
| */ |
| void (*delay) (struct device * dev, int delay); |
| }; |