dmaengine: PL08x: remove waiting descriptor pointer
As we no longer need to pass a descriptor to prep_phy_channel(), we
don't need to keep track of the descriptor which is waiting for a
channel to become available. So let's get rid of it.
Acked-by: Linus Walleij <linus.walleij@linaro.org>
Tested-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>
diff --git a/drivers/dma/amba-pl08x.c b/drivers/dma/amba-pl08x.c
index e04ca0b..88661fa 100644
--- a/drivers/dma/amba-pl08x.c
+++ b/drivers/dma/amba-pl08x.c
@@ -223,8 +223,6 @@
* @host: a pointer to the host (internal use)
* @state: whether the channel is idle, paused, running etc
* @slave: whether this channel is a device (slave) or for memcpy
- * @waiting: a TX descriptor on this channel which is waiting for a physical
- * channel to become available
* @signal: the physical DMA request signal which this channel is using
* @mux_use: count of descriptors using this DMA request signal setting
*/
@@ -243,7 +241,6 @@
struct pl08x_driver_data *host;
enum pl08x_dma_chan_state state;
bool slave;
- struct pl08x_txd *waiting;
int signal;
unsigned mux_use;
};
@@ -1074,7 +1071,6 @@
if (!plchan->slave && !plchan->phychan) {
/* Do this memcpy whenever there is a channel ready */
plchan->state = PL08X_CHAN_WAITING;
- plchan->waiting = txd;
} else {
plchan->phychan_hold--;
}
@@ -1696,8 +1692,7 @@
*/
list_for_each_entry(waiting, &pl08x->memcpy.channels,
chan.device_node) {
- if (waiting->state == PL08X_CHAN_WAITING &&
- waiting->waiting != NULL) {
+ if (waiting->state == PL08X_CHAN_WAITING) {
int ret;
/* This should REALLY not fail now */
@@ -1705,7 +1700,6 @@
BUG_ON(ret);
waiting->phychan_hold--;
waiting->state = PL08X_CHAN_RUNNING;
- waiting->waiting = NULL;
pl08x_issue_pending(&waiting->chan);
break;
}