| /* |
| * Cavium Networks CNS3420 Validation Board |
| * |
| * Copyright 2000 Deep Blue Solutions Ltd |
| * Copyright 2008 ARM Limited |
| * Copyright 2008 Cavium Networks |
| * Scott Shu |
| * Copyright 2010 MontaVista Software, LLC. |
| * Anton Vorontsov <avorontsov@mvista.com> |
| * |
| * This file is free software; you can redistribute it and/or modify |
| * it under the terms of the GNU General Public License, Version 2, as |
| * published by the Free Software Foundation. |
| */ |
| |
| #include <linux/init.h> |
| #include <linux/kernel.h> |
| #include <linux/compiler.h> |
| #include <linux/io.h> |
| #include <linux/dma-mapping.h> |
| #include <linux/serial_core.h> |
| #include <linux/serial_8250.h> |
| #include <linux/platform_device.h> |
| #include <linux/mtd/mtd.h> |
| #include <linux/mtd/physmap.h> |
| #include <linux/mtd/partitions.h> |
| #include <linux/usb/ehci_pdriver.h> |
| #include <linux/usb/ohci_pdriver.h> |
| #include <asm/setup.h> |
| #include <asm/mach-types.h> |
| #include <asm/mach/arch.h> |
| #include <asm/mach/map.h> |
| #include <asm/mach/time.h> |
| #include "cns3xxx.h" |
| #include "pm.h" |
| #include "core.h" |
| #include "devices.h" |
| |
| /* |
| * NOR Flash |
| */ |
| static struct mtd_partition cns3420_nor_partitions[] = { |
| { |
| .name = "uboot", |
| .size = 0x00040000, |
| .offset = 0, |
| .mask_flags = MTD_WRITEABLE, |
| }, { |
| .name = "kernel", |
| .size = 0x004C0000, |
| .offset = MTDPART_OFS_APPEND, |
| }, { |
| .name = "filesystem", |
| .size = 0x7000000, |
| .offset = MTDPART_OFS_APPEND, |
| }, { |
| .name = "filesystem2", |
| .size = 0x0AE0000, |
| .offset = MTDPART_OFS_APPEND, |
| }, { |
| .name = "ubootenv", |
| .size = MTDPART_SIZ_FULL, |
| .offset = MTDPART_OFS_APPEND, |
| }, |
| }; |
| |
| static struct physmap_flash_data cns3420_nor_pdata = { |
| .width = 2, |
| .parts = cns3420_nor_partitions, |
| .nr_parts = ARRAY_SIZE(cns3420_nor_partitions), |
| }; |
| |
| static struct resource cns3420_nor_res = { |
| .start = CNS3XXX_FLASH_BASE, |
| .end = CNS3XXX_FLASH_BASE + SZ_128M - 1, |
| .flags = IORESOURCE_MEM | IORESOURCE_MEM_32BIT, |
| }; |
| |
| static struct platform_device cns3420_nor_pdev = { |
| .name = "physmap-flash", |
| .id = 0, |
| .resource = &cns3420_nor_res, |
| .num_resources = 1, |
| .dev = { |
| .platform_data = &cns3420_nor_pdata, |
| }, |
| }; |
| |
| /* |
| * UART |
| */ |
| static void __init cns3420_early_serial_setup(void) |
| { |
| #ifdef CONFIG_SERIAL_8250_CONSOLE |
| static struct uart_port cns3420_serial_port = { |
| .membase = (void __iomem *)CNS3XXX_UART0_BASE_VIRT, |
| .mapbase = CNS3XXX_UART0_BASE, |
| .irq = IRQ_CNS3XXX_UART0, |
| .iotype = UPIO_MEM, |
| .flags = UPF_BOOT_AUTOCONF | UPF_FIXED_TYPE, |
| .regshift = 2, |
| .uartclk = 24000000, |
| .line = 0, |
| .type = PORT_16550A, |
| .fifosize = 16, |
| }; |
| |
| early_serial_setup(&cns3420_serial_port); |
| #endif |
| } |
| |
| /* |
| * USB |
| */ |
| static struct resource cns3xxx_usb_ehci_resources[] = { |
| [0] = { |
| .start = CNS3XXX_USB_BASE, |
| .end = CNS3XXX_USB_BASE + SZ_16M - 1, |
| .flags = IORESOURCE_MEM, |
| }, |
| [1] = { |
| .start = IRQ_CNS3XXX_USB_EHCI, |
| .flags = IORESOURCE_IRQ, |
| }, |
| }; |
| |
| static u64 cns3xxx_usb_ehci_dma_mask = DMA_BIT_MASK(32); |
| |
| static int csn3xxx_usb_power_on(struct platform_device *pdev) |
| { |
| /* |
| * EHCI and OHCI share the same clock and power, |
| * resetting twice would cause the 1st controller been reset. |
| * Therefore only do power up at the first up device, and |
| * power down at the last down device. |
| * |
| * Set USB AHB INCR length to 16 |
| */ |
| if (atomic_inc_return(&usb_pwr_ref) == 1) { |
| cns3xxx_pwr_power_up(1 << PM_PLL_HM_PD_CTRL_REG_OFFSET_PLL_USB); |
| cns3xxx_pwr_clk_en(1 << PM_CLK_GATE_REG_OFFSET_USB_HOST); |
| cns3xxx_pwr_soft_rst(1 << PM_SOFT_RST_REG_OFFST_USB_HOST); |
| __raw_writel((__raw_readl(MISC_CHIP_CONFIG_REG) | (0X2 << 24)), |
| MISC_CHIP_CONFIG_REG); |
| } |
| |
| return 0; |
| } |
| |
| static void csn3xxx_usb_power_off(struct platform_device *pdev) |
| { |
| /* |
| * EHCI and OHCI share the same clock and power, |
| * resetting twice would cause the 1st controller been reset. |
| * Therefore only do power up at the first up device, and |
| * power down at the last down device. |
| */ |
| if (atomic_dec_return(&usb_pwr_ref) == 0) |
| cns3xxx_pwr_clk_dis(1 << PM_CLK_GATE_REG_OFFSET_USB_HOST); |
| } |
| |
| static struct usb_ehci_pdata cns3xxx_usb_ehci_pdata = { |
| .power_on = csn3xxx_usb_power_on, |
| .power_off = csn3xxx_usb_power_off, |
| }; |
| |
| static struct platform_device cns3xxx_usb_ehci_device = { |
| .name = "ehci-platform", |
| .num_resources = ARRAY_SIZE(cns3xxx_usb_ehci_resources), |
| .resource = cns3xxx_usb_ehci_resources, |
| .dev = { |
| .dma_mask = &cns3xxx_usb_ehci_dma_mask, |
| .coherent_dma_mask = DMA_BIT_MASK(32), |
| .platform_data = &cns3xxx_usb_ehci_pdata, |
| }, |
| }; |
| |
| static struct resource cns3xxx_usb_ohci_resources[] = { |
| [0] = { |
| .start = CNS3XXX_USB_OHCI_BASE, |
| .end = CNS3XXX_USB_OHCI_BASE + SZ_16M - 1, |
| .flags = IORESOURCE_MEM, |
| }, |
| [1] = { |
| .start = IRQ_CNS3XXX_USB_OHCI, |
| .flags = IORESOURCE_IRQ, |
| }, |
| }; |
| |
| static u64 cns3xxx_usb_ohci_dma_mask = DMA_BIT_MASK(32); |
| |
| static struct usb_ohci_pdata cns3xxx_usb_ohci_pdata = { |
| .num_ports = 1, |
| .power_on = csn3xxx_usb_power_on, |
| .power_off = csn3xxx_usb_power_off, |
| }; |
| |
| static struct platform_device cns3xxx_usb_ohci_device = { |
| .name = "ohci-platform", |
| .num_resources = ARRAY_SIZE(cns3xxx_usb_ohci_resources), |
| .resource = cns3xxx_usb_ohci_resources, |
| .dev = { |
| .dma_mask = &cns3xxx_usb_ohci_dma_mask, |
| .coherent_dma_mask = DMA_BIT_MASK(32), |
| .platform_data = &cns3xxx_usb_ohci_pdata, |
| }, |
| }; |
| |
| /* |
| * Initialization |
| */ |
| static struct platform_device *cns3420_pdevs[] __initdata = { |
| &cns3420_nor_pdev, |
| &cns3xxx_usb_ehci_device, |
| &cns3xxx_usb_ohci_device, |
| }; |
| |
| static void __init cns3420_init(void) |
| { |
| cns3xxx_l2x0_init(); |
| |
| platform_add_devices(cns3420_pdevs, ARRAY_SIZE(cns3420_pdevs)); |
| |
| cns3xxx_ahci_init(); |
| cns3xxx_sdhci_init(); |
| |
| pm_power_off = cns3xxx_power_off; |
| } |
| |
| static struct map_desc cns3420_io_desc[] __initdata = { |
| { |
| .virtual = CNS3XXX_UART0_BASE_VIRT, |
| .pfn = __phys_to_pfn(CNS3XXX_UART0_BASE), |
| .length = SZ_4K, |
| .type = MT_DEVICE, |
| }, |
| }; |
| |
| static void __init cns3420_map_io(void) |
| { |
| cns3xxx_map_io(); |
| iotable_init(cns3420_io_desc, ARRAY_SIZE(cns3420_io_desc)); |
| |
| cns3420_early_serial_setup(); |
| } |
| |
| MACHINE_START(CNS3420VB, "Cavium Networks CNS3420 Validation Board") |
| .atag_offset = 0x100, |
| .nr_irqs = NR_IRQS_CNS3XXX, |
| .map_io = cns3420_map_io, |
| .init_irq = cns3xxx_init_irq, |
| .init_time = cns3xxx_timer_init, |
| .init_machine = cns3420_init, |
| .restart = cns3xxx_restart, |
| MACHINE_END |