| menu "Dallas's 1-wire bus" |
| |
| config W1 |
| tristate "Dallas's 1-wire support" |
| ---help--- |
| Dallas's 1-wire bus is usefull to connect slow 1-pin devices |
| such as iButtons and thermal sensors. |
| |
| If you want W1 support, you should say Y here. |
| |
| This W1 support can also be built as a module. If so, the module |
| will be called wire.ko. |
| |
| config W1_MATROX |
| tristate "Matrox G400 transport layer for 1-wire" |
| depends on W1 && PCI |
| help |
| Say Y here if you want to communicate with your 1-wire devices |
| using Matrox's G400 GPIO pins. |
| |
| This support is also available as a module. If so, the module |
| will be called matrox_w1.ko. |
| |
| config W1_DS9490 |
| tristate "DS9490R transport layer driver" |
| depends on W1 && USB |
| help |
| Say Y here if you want to have a driver for DS9490R UWB <-> W1 bridge. |
| |
| This support is also available as a module. If so, the module |
| will be called ds9490r.ko. |
| |
| config W1_DS9490R_BRIDGE |
| tristate "DS9490R USB <-> W1 transport layer for 1-wire" |
| depends on W1_DS9490 |
| help |
| Say Y here if you want to communicate with your 1-wire devices |
| using DS9490R USB bridge. |
| |
| This support is also available as a module. If so, the module |
| will be called ds_w1_bridge.ko. |
| |
| config W1_THERM |
| tristate "Thermal family implementation" |
| depends on W1 |
| help |
| Say Y here if you want to connect 1-wire thermal sensors to you |
| wire. |
| |
| config W1_SMEM |
| tristate "Simple 64bit memory family implementation" |
| depends on W1 |
| help |
| Say Y here if you want to connect 1-wire |
| simple 64bit memory rom(ds2401/ds2411/ds1990*) to you wire. |
| |
| endmenu |