| /* Copyright (c) 2016-2017, 2019, The Linux Foundation. All rights reserved. |
| * |
| * This program is free software; you can redistribute it and/or modify |
| * it under the terms of the GNU General Public License version 2 and |
| * only version 2 as published by the Free Software Foundation. |
| * |
| * This program is distributed in the hope that it will be useful, |
| * but WITHOUT ANY WARRANTY; without even the implied warranty of |
| * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the |
| * GNU General Public License for more details. |
| */ |
| |
| #include <dt-bindings/spmi/spmi.h> |
| #include <dt-bindings/interrupt-controller/irq.h> |
| #include <dt-bindings/msm/power-on.h> |
| |
| &spmi_bus { |
| qcom,pm8998@0 { |
| compatible = "qcom,spmi-pmic"; |
| reg = <0x0 SPMI_USID>; |
| #address-cells = <2>; |
| #size-cells = <0>; |
| |
| pm8998_revid: qcom,revid@100 { |
| compatible = "qcom,qpnp-revid"; |
| reg = <0x100 0x100>; |
| }; |
| |
| qcom,power-on@800 { |
| compatible = "qcom,qpnp-power-on"; |
| reg = <0x800 0x100>; |
| interrupts = <0x0 0x8 0x0 IRQ_TYPE_NONE>, |
| <0x0 0x8 0x1 IRQ_TYPE_NONE>, |
| <0x0 0x8 0x4 IRQ_TYPE_NONE>, |
| <0x0 0x8 0x5 IRQ_TYPE_NONE>; |
| interrupt-names = "kpdpwr", "resin", |
| "resin-bark", "kpdpwr-resin-bark"; |
| qcom,pon-dbc-delay = <15625>; |
| qcom,kpdpwr-sw-debounce; |
| qcom,system-reset; |
| qcom,store-hard-reset-reason; |
| |
| qcom,pon_1 { |
| qcom,pon-type = <0>; |
| qcom,pull-up = <1>; |
| linux,code = <116>; |
| }; |
| |
| qcom,pon_2 { |
| qcom,pon-type = <1>; |
| qcom,pull-up = <1>; |
| linux,code = <114>; |
| }; |
| |
| qcom,pon_3 { |
| qcom,pon-type = <3>; |
| qcom,support-reset = <1>; |
| qcom,pull-up = <1>; |
| qcom,s1-timer = <6720>; |
| qcom,s2-timer = <2000>; |
| qcom,s2-type = <PON_POWER_OFF_DVDD_HARD_RESET>; |
| qcom,use-bark; |
| }; |
| }; |
| |
| pm8998_tz: qcom,temp-alarm@2400 { |
| compatible = "qcom,qpnp-temp-alarm"; |
| reg = <0x2400 0x100>; |
| interrupts = <0x0 0x24 0x0 IRQ_TYPE_EDGE_RISING>; |
| label = "pm8998_tz"; |
| qcom,channel-num = <6>; |
| qcom,temp_alarm-vadc = <&pm8998_vadc>; |
| #thermal-sensor-cells = <0>; |
| }; |
| |
| pm8998_gpios: pinctrl@c000 { |
| compatible = "qcom,spmi-gpio"; |
| reg = <0xc000 0x1a00>; |
| interrupts = <0x0 0xc0 0 IRQ_TYPE_NONE>, |
| <0x0 0xc1 0 IRQ_TYPE_NONE>, |
| <0x0 0xc3 0 IRQ_TYPE_NONE>, |
| <0x0 0xc4 0 IRQ_TYPE_NONE>, |
| <0x0 0xc5 0 IRQ_TYPE_NONE>, |
| <0x0 0xc6 0 IRQ_TYPE_NONE>, |
| <0x0 0xc7 0 IRQ_TYPE_NONE>, |
| <0x0 0xc8 0 IRQ_TYPE_NONE>, |
| <0x0 0xc9 0 IRQ_TYPE_NONE>, |
| <0x0 0xca 0 IRQ_TYPE_NONE>, |
| <0x0 0xcb 0 IRQ_TYPE_NONE>, |
| <0x0 0xcc 0 IRQ_TYPE_NONE>, |
| <0x0 0xcd 0 IRQ_TYPE_NONE>, |
| <0x0 0xcf 0 IRQ_TYPE_NONE>, |
| <0x0 0xd0 0 IRQ_TYPE_NONE>, |
| <0x0 0xd1 0 IRQ_TYPE_NONE>, |
| <0x0 0xd2 0 IRQ_TYPE_NONE>, |
| <0x0 0xd4 0 IRQ_TYPE_NONE>, |
| <0x0 0xd6 0 IRQ_TYPE_NONE>; |
| interrupt-names = "pm8998_gpio1", "pm8998_gpio2", |
| "pm8998_gpio4", "pm8998_gpio5", |
| "pm8998_gpio6", "pm8998_gpio7", |
| "pm8998_gpio8", "pm8998_gpio9", |
| "pm8998_gpio10", "pm8998_gpio11", |
| "pm8998_gpio12", "pm8998_gpio13", |
| "pm8998_gpio14", "pm8998_gpio16", |
| "pm8998_gpio17", "pm8998_gpio18", |
| "pm8998_gpio19", "pm8998_gpio21", |
| "pm8998_gpio23"; |
| gpio-controller; |
| #gpio-cells = <2>; |
| qcom,gpios-disallowed = <3 15 20 22 24 25 26>; |
| }; |
| |
| pm8998_coincell: qcom,coincell@2800 { |
| compatible = "qcom,qpnp-coincell"; |
| reg = <0x2800 0x100>; |
| }; |
| |
| pm8998_rtc: qcom,pm8998_rtc { |
| compatible = "qcom,qpnp-rtc"; |
| #address-cells = <1>; |
| #size-cells = <1>; |
| qcom,qpnp-rtc-write = <0>; |
| qcom,qpnp-rtc-alarm-pwrup = <0>; |
| |
| qcom,pm8998_rtc_rw@6000 { |
| reg = <0x6000 0x100>; |
| }; |
| qcom,pm8998_rtc_alarm@6100 { |
| reg = <0x6100 0x100>; |
| interrupts = <0x0 0x61 0x1 IRQ_TYPE_NONE>; |
| }; |
| }; |
| |
| pm8998_vadc: vadc@3100 { |
| compatible = "qcom,qpnp-vadc-hc"; |
| reg = <0x3100 0x100>; |
| #address-cells = <1>; |
| #size-cells = <0>; |
| interrupts = <0x0 0x31 0x0 IRQ_TYPE_EDGE_RISING>; |
| interrupt-names = "eoc-int-en-set"; |
| qcom,adc-vdd-reference = <1875>; |
| |
| chan@6 { |
| label = "die_temp"; |
| reg = <6>; |
| qcom,decimation = <2>; |
| qcom,pre-div-channel-scaling = <0>; |
| qcom,calibration-type = "absolute"; |
| qcom,scale-function = <3>; |
| qcom,hw-settle-time = <0>; |
| qcom,fast-avg-setup = <0>; |
| qcom,cal-val = <0>; |
| }; |
| |
| chan@0 { |
| label = "ref_gnd"; |
| reg = <0>; |
| qcom,decimation = <2>; |
| qcom,pre-div-channel-scaling = <0>; |
| qcom,calibration-type = "absolute"; |
| qcom,scale-function = <0>; |
| qcom,hw-settle-time = <0>; |
| qcom,fast-avg-setup = <0>; |
| qcom,cal-val = <0>; |
| }; |
| |
| chan@1 { |
| label = "ref_1250v"; |
| reg = <1>; |
| qcom,decimation = <2>; |
| qcom,pre-div-channel-scaling = <0>; |
| qcom,calibration-type = "absolute"; |
| qcom,scale-function = <0>; |
| qcom,hw-settle-time = <0>; |
| qcom,fast-avg-setup = <0>; |
| qcom,cal-val = <0>; |
| }; |
| }; |
| |
| pm8998_adc_tm: vadc@3400 { |
| compatible = "qcom,qpnp-adc-tm-hc"; |
| reg = <0x3400 0x100>; |
| #address-cells = <1>; |
| #size-cells = <0>; |
| interrupts = <0x0 0x34 0x0 IRQ_TYPE_EDGE_RISING>; |
| interrupt-names = "eoc-int-en-set"; |
| qcom,adc-vdd-reference = <1875>; |
| qcom,adc_tm-vadc = <&pm8998_vadc>; |
| qcom,decimation = <0>; |
| qcom,fast-avg-setup = <0>; |
| #thermal-sensor-cells = <1>; |
| }; |
| |
| pm8998_div_clk1: qcom,clkdiv@5b00 { |
| compatible = "qcom,qpnp-clkdiv"; |
| reg = <0x5b00 0x100>; |
| #clock-cells = <1>; |
| qcom,cxo-freq = <19200000>; |
| qcom,clkdiv-id = <1>; |
| qcom,clkdiv-init-freq = <19200000>; |
| }; |
| |
| pm8998_div_clk2: qcom,clkdiv@5c00 { |
| compatible = "qcom,qpnp-clkdiv"; |
| reg = <0x5c00 0x100>; |
| #clock-cells = <1>; |
| qcom,cxo-freq = <19200000>; |
| qcom,clkdiv-id = <2>; |
| qcom,clkdiv-init-freq = <19200000>; |
| }; |
| |
| pm8998_div_clk3: qcom,clkdiv@5d00 { |
| compatible = "qcom,qpnp-clkdiv"; |
| reg = <0x5d00 0x100>; |
| #clock-cells = <1>; |
| qcom,cxo-freq = <19200000>; |
| qcom,clkdiv-id = <3>; |
| qcom,clkdiv-init-freq = <19200000>; |
| }; |
| }; |
| |
| qcom,pm8998@1 { |
| compatible ="qcom,spmi-pmic"; |
| reg = <0x1 SPMI_USID>; |
| #address-cells = <2>; |
| #size-cells = <0>; |
| }; |
| }; |
| |
| &thermal_zones { |
| pm8998_temp_alarm: pm8998_tz { |
| polling-delay-passive = <0>; |
| polling-delay = <0>; |
| thermal-governor = "step_wise"; |
| thermal-sensors = <&pm8998_tz>; |
| wake-capable-sensor; |
| |
| trips { |
| pm8998_trip0: pm8998-trip0 { |
| temperature = <105000>; |
| hysteresis = <0>; |
| type = "passive"; |
| }; |
| pm8998_trip1: pm8998-trip1 { |
| temperature = <125000>; |
| hysteresis = <0>; |
| type = "passive"; |
| }; |
| pm8998_trip2: pm8998-trip2 { |
| temperature = <145000>; |
| hysteresis = <0>; |
| type = "passive"; |
| }; |
| }; |
| }; |
| }; |