Documentation/devicetree/bindings/arm/samsung/exynos-adc.txt

Samsung Exynos Analog to Digital Converter bindings

The devicetree bindings are for the new ADC driver written for
Exynos4 and upward SoCs from Samsung.

New driver handles the following
1. Supports ADC IF found on EXYNOS4412/EXYNOS5250
   and future SoCs from Samsung
2. Add ADC driver under iio/adc framework
3. Also adds the Documentation for device tree bindings

Required properties:
- compatible:		Must be "samsung,exynos-adc-v1"
				for exynos4412/5250 controllers.
			Must be "samsung,exynos-adc-v2" for
				future controllers.
- reg:			Contains ADC register address range (base address and
			length) and the address of the phy enable register.
- interrupts: 		Contains the interrupt information for the timer. The
			format is being dependent on which interrupt controller
			the Samsung device uses.
- #io-channel-cells = <1>; As ADC has multiple outputs
- clocks		From common clock binding: handle to adc clock.
- clock-names		From common clock binding: Shall be "adc".
- vdd-supply		VDD input supply.

Note: child nodes can be added for auto probing from device tree.

Example: adding device info in dtsi file

adc: adc@12D10000 {
	compatible = "samsung,exynos-adc-v1";
	reg = <0x12D10000 0x100>, <0x10040718 0x4>;
	interrupts = <0 106 0>;
	#io-channel-cells = <1>;
	io-channel-ranges;

	clocks = <&clock 303>;
	clock-names = "adc";

	vdd-supply = <&buck5_reg>;
};


Example: Adding child nodes in dts file

adc@12D10000 {

	/* NTC thermistor is a hwmon device */
	ncp15wb473@0 {
		compatible = "murata,ncp15wb473";
		pullup-uv = <1800000>;
		pullup-ohm = <47000>;
		pulldown-ohm = <0>;
		io-channels = <&adc 4>;
	};
};

Note: Does not apply to ADC driver under arch/arm/plat-samsung/
Note: The child node can be added under the adc node or separately.