| /* |
| * pata_winbond.c - Winbond VLB ATA controllers |
| * (C) 2006 Red Hat <alan@redhat.com> |
| * |
| * Support for the Winbond 83759A when operating in advanced mode. |
| * Multichip mode is not currently supported. |
| */ |
| |
| #include <linux/kernel.h> |
| #include <linux/module.h> |
| #include <linux/init.h> |
| #include <linux/blkdev.h> |
| #include <linux/delay.h> |
| #include <scsi/scsi_host.h> |
| #include <linux/libata.h> |
| #include <linux/platform_device.h> |
| |
| #define DRV_NAME "pata_winbond" |
| #define DRV_VERSION "0.0.2" |
| |
| #define NR_HOST 4 /* Two winbond controllers, two channels each */ |
| |
| struct winbond_data { |
| unsigned long config; |
| struct platform_device *platform_dev; |
| }; |
| |
| static struct ata_host *winbond_host[NR_HOST]; |
| static struct winbond_data winbond_data[NR_HOST]; |
| static int nr_winbond_host; |
| |
| #ifdef MODULE |
| static int probe_winbond = 1; |
| #else |
| static int probe_winbond; |
| #endif |
| |
| static DEFINE_SPINLOCK(winbond_lock); |
| |
| static void winbond_writecfg(unsigned long port, u8 reg, u8 val) |
| { |
| unsigned long flags; |
| spin_lock_irqsave(&winbond_lock, flags); |
| outb(reg, port + 0x01); |
| outb(val, port + 0x02); |
| spin_unlock_irqrestore(&winbond_lock, flags); |
| } |
| |
| static u8 winbond_readcfg(unsigned long port, u8 reg) |
| { |
| u8 val; |
| |
| unsigned long flags; |
| spin_lock_irqsave(&winbond_lock, flags); |
| outb(reg, port + 0x01); |
| val = inb(port + 0x02); |
| spin_unlock_irqrestore(&winbond_lock, flags); |
| |
| return val; |
| } |
| |
| static void winbond_set_piomode(struct ata_port *ap, struct ata_device *adev) |
| { |
| struct ata_timing t; |
| struct winbond_data *winbond = ap->host->private_data; |
| int active, recovery; |
| u8 reg; |
| int timing = 0x88 + (ap->port_no * 4) + (adev->devno * 2); |
| |
| reg = winbond_readcfg(winbond->config, 0x81); |
| |
| /* Get the timing data in cycles */ |
| if (reg & 0x40) /* Fast VLB bus, assume 50MHz */ |
| ata_timing_compute(adev, adev->pio_mode, &t, 20000, 1000); |
| else |
| ata_timing_compute(adev, adev->pio_mode, &t, 30303, 1000); |
| |
| active = (FIT(t.active, 3, 17) - 1) & 0x0F; |
| recovery = (FIT(t.recover, 1, 15) + 1) & 0x0F; |
| timing = (active << 4) | recovery; |
| winbond_writecfg(winbond->config, timing, reg); |
| |
| /* Load the setup timing */ |
| |
| reg = 0x35; |
| if (adev->class != ATA_DEV_ATA) |
| reg |= 0x08; /* FIFO off */ |
| if (!ata_pio_need_iordy(adev)) |
| reg |= 0x02; /* IORDY off */ |
| reg |= (FIT(t.setup, 0, 3) << 6); |
| winbond_writecfg(winbond->config, timing + 1, reg); |
| } |
| |
| |
| static void winbond_data_xfer(struct ata_device *adev, unsigned char *buf, unsigned int buflen, int write_data) |
| { |
| struct ata_port *ap = adev->ap; |
| int slop = buflen & 3; |
| |
| if (ata_id_has_dword_io(adev->id)) { |
| if (write_data) |
| iowrite32_rep(ap->ioaddr.data_addr, buf, buflen >> 2); |
| else |
| ioread32_rep(ap->ioaddr.data_addr, buf, buflen >> 2); |
| |
| if (unlikely(slop)) { |
| u32 pad; |
| if (write_data) { |
| memcpy(&pad, buf + buflen - slop, slop); |
| pad = le32_to_cpu(pad); |
| iowrite32(pad, ap->ioaddr.data_addr); |
| } else { |
| pad = ioread32(ap->ioaddr.data_addr); |
| pad = cpu_to_le16(pad); |
| memcpy(buf + buflen - slop, &pad, slop); |
| } |
| } |
| } else |
| ata_data_xfer(adev, buf, buflen, write_data); |
| } |
| |
| static struct scsi_host_template winbond_sht = { |
| .module = THIS_MODULE, |
| .name = DRV_NAME, |
| .ioctl = ata_scsi_ioctl, |
| .queuecommand = ata_scsi_queuecmd, |
| .can_queue = ATA_DEF_QUEUE, |
| .this_id = ATA_SHT_THIS_ID, |
| .sg_tablesize = LIBATA_MAX_PRD, |
| .cmd_per_lun = ATA_SHT_CMD_PER_LUN, |
| .emulated = ATA_SHT_EMULATED, |
| .use_clustering = ATA_SHT_USE_CLUSTERING, |
| .proc_name = DRV_NAME, |
| .dma_boundary = ATA_DMA_BOUNDARY, |
| .slave_configure = ata_scsi_slave_config, |
| .slave_destroy = ata_scsi_slave_destroy, |
| .bios_param = ata_std_bios_param, |
| }; |
| |
| static struct ata_port_operations winbond_port_ops = { |
| .port_disable = ata_port_disable, |
| .set_piomode = winbond_set_piomode, |
| |
| .tf_load = ata_tf_load, |
| .tf_read = ata_tf_read, |
| .check_status = ata_check_status, |
| .exec_command = ata_exec_command, |
| .dev_select = ata_std_dev_select, |
| |
| .freeze = ata_bmdma_freeze, |
| .thaw = ata_bmdma_thaw, |
| .error_handler = ata_bmdma_error_handler, |
| .post_internal_cmd = ata_bmdma_post_internal_cmd, |
| .cable_detect = ata_cable_40wire, |
| |
| .qc_prep = ata_qc_prep, |
| .qc_issue = ata_qc_issue_prot, |
| |
| .data_xfer = winbond_data_xfer, |
| |
| .irq_clear = ata_bmdma_irq_clear, |
| .irq_on = ata_irq_on, |
| .irq_ack = ata_irq_ack, |
| |
| .port_start = ata_port_start, |
| }; |
| |
| /** |
| * winbond_init_one - attach a winbond interface |
| * @type: Type to display |
| * @io: I/O port start |
| * @irq: interrupt line |
| * @fast: True if on a > 33Mhz VLB |
| * |
| * Register a VLB bus IDE interface. Such interfaces are PIO and we |
| * assume do not support IRQ sharing. |
| */ |
| |
| static __init int winbond_init_one(unsigned long port) |
| { |
| struct platform_device *pdev; |
| u8 reg; |
| int i, rc; |
| |
| reg = winbond_readcfg(port, 0x81); |
| reg |= 0x80; /* jumpered mode off */ |
| winbond_writecfg(port, 0x81, reg); |
| reg = winbond_readcfg(port, 0x83); |
| reg |= 0xF0; /* local control */ |
| winbond_writecfg(port, 0x83, reg); |
| reg = winbond_readcfg(port, 0x85); |
| reg |= 0xF0; /* programmable timing */ |
| winbond_writecfg(port, 0x85, reg); |
| |
| reg = winbond_readcfg(port, 0x81); |
| |
| if (!(reg & 0x03)) /* Disabled */ |
| return 0; |
| |
| for (i = 0; i < 2 ; i ++) { |
| unsigned long cmd_port = 0x1F0 - (0x80 * i); |
| struct ata_host *host; |
| struct ata_port *ap; |
| void __iomem *cmd_addr, *ctl_addr; |
| |
| if (!(reg & (1 << i))) |
| continue; |
| |
| pdev = platform_device_register_simple(DRV_NAME, nr_winbond_host, NULL, 0); |
| if (IS_ERR(pdev)) |
| return PTR_ERR(pdev); |
| |
| rc = -ENOMEM; |
| host = ata_host_alloc(&pdev->dev, 1); |
| if (!host) |
| goto err_unregister; |
| |
| rc = -ENOMEM; |
| cmd_addr = devm_ioport_map(&pdev->dev, cmd_port, 8); |
| ctl_addr = devm_ioport_map(&pdev->dev, cmd_port + 0x0206, 1); |
| if (!cmd_addr || !ctl_addr) |
| goto err_unregister; |
| |
| ap = host->ports[0]; |
| ap->ops = &winbond_port_ops; |
| ap->pio_mask = 0x1F; |
| ap->flags |= ATA_FLAG_SLAVE_POSS; |
| ap->ioaddr.cmd_addr = cmd_addr; |
| ap->ioaddr.altstatus_addr = ctl_addr; |
| ap->ioaddr.ctl_addr = ctl_addr; |
| ata_std_ports(&ap->ioaddr); |
| |
| /* hook in a private data structure per channel */ |
| host->private_data = &winbond_data[nr_winbond_host]; |
| winbond_data[nr_winbond_host].config = port; |
| winbond_data[nr_winbond_host].platform_dev = pdev; |
| |
| /* activate */ |
| rc = ata_host_activate(host, 14 + i, ata_interrupt, 0, |
| &winbond_sht); |
| if (rc) |
| goto err_unregister; |
| |
| winbond_host[nr_winbond_host++] = dev_get_drvdata(&pdev->dev); |
| } |
| |
| return 0; |
| |
| err_unregister: |
| platform_device_unregister(pdev); |
| return rc; |
| } |
| |
| /** |
| * winbond_init - attach winbond interfaces |
| * |
| * Attach winbond IDE interfaces by scanning the ports it may occupy. |
| */ |
| |
| static __init int winbond_init(void) |
| { |
| static const unsigned long config[2] = { 0x130, 0x1B0 }; |
| |
| int ct = 0; |
| int i; |
| |
| if (probe_winbond == 0) |
| return -ENODEV; |
| |
| /* |
| * Check both base addresses |
| */ |
| |
| for (i = 0; i < 2; i++) { |
| if (probe_winbond & (1<<i)) { |
| int ret = 0; |
| unsigned long port = config[i]; |
| |
| if (request_region(port, 2, "pata_winbond")) { |
| ret = winbond_init_one(port); |
| if(ret <= 0) |
| release_region(port, 2); |
| else ct+= ret; |
| } |
| } |
| } |
| if (ct != 0) |
| return 0; |
| return -ENODEV; |
| } |
| |
| static __exit void winbond_exit(void) |
| { |
| int i; |
| |
| for (i = 0; i < nr_winbond_host; i++) { |
| ata_host_detach(winbond_host[i]); |
| release_region(winbond_data[i].config, 2); |
| platform_device_unregister(winbond_data[i].platform_dev); |
| } |
| } |
| |
| MODULE_AUTHOR("Alan Cox"); |
| MODULE_DESCRIPTION("low-level driver for Winbond VL ATA"); |
| MODULE_LICENSE("GPL"); |
| MODULE_VERSION(DRV_VERSION); |
| |
| module_init(winbond_init); |
| module_exit(winbond_exit); |
| |
| module_param(probe_winbond, int, 0); |
| |