| /* Copyright (c) 2012-2016, The Linux Foundation. All rights reserved. |
| * |
| * This program is free software; you can redistribute it and/or modify |
| * it under the terms of the GNU General Public License version 2 and |
| * only version 2 as published by the Free Software Foundation. |
| * |
| * This program is distributed in the hope that it will be useful, |
| * but WITHOUT ANY WARRANTY; without even the implied warranty of |
| * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the |
| * GNU General Public License for more details. |
| */ |
| |
| #ifndef __QPNP_PWM_H__ |
| #define __QPNP_PWM_H__ |
| |
| #include <linux/pwm.h> |
| |
| /* usec: 19.2M, n=6, m=0, pre=2 */ |
| #define PM_PWM_PERIOD_MIN 7 |
| /* 1K, n=9, m=7, pre=6 */ |
| #define PM_PWM_PERIOD_MAX (384 * USEC_PER_SEC) |
| #define PM_PWM_LUT_RAMP_STEP_TIME_MAX 499 |
| #define PM_PWM_MAX_PAUSE_CNT 8191 |
| /* |
| * Formula from HSID, |
| * pause_time (hi/lo) = (pause_code - 1)*(duty_ms) |
| */ |
| #define PM_PWM_LUT_PAUSE_MAX \ |
| ((PM_PWM_MAX_PAUSE_CNT - 1) * PM_PWM_LUT_RAMP_STEP_TIME_MAX) /* ms */ |
| |
| /* Flags for Look Up Table */ |
| #define PM_PWM_LUT_LOOP 0x01 |
| #define PM_PWM_LUT_RAMP_UP 0x02 |
| #define PM_PWM_LUT_REVERSE 0x04 |
| #define PM_PWM_LUT_PAUSE_HI_EN 0x08 |
| #define PM_PWM_LUT_PAUSE_LO_EN 0x10 |
| |
| #define PM_PWM_LUT_NO_TABLE 0x20 |
| #define PM_PWM_LUT_USE_RAW_VALUE 0x40 |
| |
| /* |
| * PWM frequency/period control |
| * |
| * PWM Frequency = ClockFrequency / (N * T) |
| * or |
| * PWM Period = Clock Period * (N * T) |
| * where |
| * N = 2^9 or 2^6 for 9-bit or 6-bit PWM size |
| * T = Pre-divide * 2^m, m = 0..7 (exponent) |
| */ |
| |
| /* |
| * enum pm_pwm_size - PWM bit mode selection |
| * %PM_PWM_SIZE_6BIT - Select 6 bit mode; 64 levels |
| * %PM_PWM_SIZE_9BIT - Select 9 bit mode; 512 levels |
| */ |
| enum pm_pwm_size { |
| PM_PWM_SIZE_6BIT = 6, |
| PM_PWM_SIZE_9BIT = 9, |
| }; |
| |
| /* |
| * enum pm_pwm_clk - PWM clock selection |
| * %PM_PWM_CLK_1KHZ - 1KHz clock |
| * %PM_PWM_CLK_32KHZ - 32KHz clock |
| * %PM_PWM_CLK_19P2MHZ - 19.2MHz clock |
| * Note: Here 1KHz = 1024Hz |
| */ |
| enum pm_pwm_clk { |
| PM_PWM_CLK_1KHZ, |
| PM_PWM_CLK_32KHZ, |
| PM_PWM_CLK_19P2MHZ, |
| }; |
| |
| /* PWM pre-divider selection */ |
| enum pm_pwm_pre_div { |
| PM_PWM_PDIV_2, |
| PM_PWM_PDIV_3, |
| PM_PWM_PDIV_5, |
| PM_PWM_PDIV_6, |
| }; |
| |
| /* |
| * struct pwm_period_config - PWM period configuration |
| * @pwm_size: enum pm_pwm_size |
| * @clk: enum pm_pwm_clk |
| * @pre_div: enum pm_pwm_pre_div |
| * @pre_div_exp: exponent of 2 as part of pre-divider: 0..7 |
| */ |
| struct pwm_period_config { |
| enum pm_pwm_size pwm_size; |
| enum pm_pwm_clk clk; |
| enum pm_pwm_pre_div pre_div; |
| int pre_div_exp; |
| }; |
| |
| /* |
| * struct pwm_duty_cycles - PWM duty cycle info |
| * duty_pcts - pointer to an array of duty percentage for a pwm period |
| * num_duty_pcts - total entries in duty_pcts array |
| * duty_ms - duty cycle time in ms |
| * start_idx - index in the LUT |
| */ |
| struct pwm_duty_cycles { |
| int *duty_pcts; |
| int num_duty_pcts; |
| int duty_ms; |
| int start_idx; |
| }; |
| |
| /* |
| * enum pm_pwm_mode - PWM mode selection |
| * %PM_PWM_MODE_PWM - Select PWM mode |
| * %PM_PWM_MODE_LPG - Select LPG mode |
| */ |
| enum pm_pwm_mode { |
| PM_PWM_MODE_PWM, |
| PM_PWM_MODE_LPG, |
| }; |
| |
| /* |
| * lut_params: Lookup table (LUT) parameters |
| * @start_idx: start index in lookup table from 0 to MAX-1 |
| * @idx_len: number of index |
| * @pause_lo: pause time in millisecond at low index |
| * @pause_hi: pause time in millisecond at high index |
| * @ramp_step_ms: time before loading next LUT pattern in millisecond |
| * @flags: control flags |
| */ |
| struct lut_params { |
| int start_idx; |
| int idx_len; |
| int lut_pause_hi; |
| int lut_pause_lo; |
| int ramp_step_ms; |
| int flags; |
| }; |
| |
| #if IS_ENABLED(CONFIG_PWM_QPNP) |
| int pwm_config_period(struct pwm_device *pwm, |
| struct pwm_period_config *pwm_p); |
| |
| int pwm_config_pwm_value(struct pwm_device *pwm, int pwm_value); |
| |
| |
| int pwm_change_mode(struct pwm_device *pwm, enum pm_pwm_mode mode); |
| |
| |
| int pwm_lut_config(struct pwm_device *pwm, int period_us, |
| int duty_pct[], struct lut_params lut_params); |
| |
| /* |
| * support microsecond level configuration |
| */ |
| int pwm_config_us(struct pwm_device *pwm, |
| int duty_us, int period_us); |
| |
| #else |
| static inline int pwm_config_period(struct pwm_device *pwm, |
| struct pwm_period_config *pwm_p) |
| { |
| return -EINVAL; |
| } |
| |
| static inline int pwm_config_pwm_value(struct pwm_device *pwm, int pwm_value) |
| { |
| return -EINVAL; |
| } |
| |
| static inline int pwm_change_mode(struct pwm_device *pwm, enum pm_pwm_mode mode) |
| { |
| return -EINVAL; |
| } |
| |
| static inline int pwm_lut_config(struct pwm_device *pwm, int period_us, |
| int duty_pct[], struct lut_params lut_params) |
| { |
| return -EINVAL; |
| } |
| |
| static inline int pwm_config_us(struct pwm_device *pwm, |
| int duty_us, int period_us) |
| { |
| return -EINVAL; |
| } |
| #endif |
| |
| /* Standard APIs supported */ |
| /* |
| * pwm_request - request a PWM device |
| * @pwm_id: PWM id or channel |
| * @label: the label to identify the user |
| */ |
| |
| /* |
| * pwm_free - free a PWM device |
| * @pwm: the PWM device |
| */ |
| |
| /* |
| * pwm_config - change a PWM device configuration |
| * @pwm: the PWM device |
| * @period_ns: period in nanosecond |
| * @duty_ns: duty cycle in nanosecond |
| */ |
| |
| /* |
| * pwm_enable - start a PWM output toggling |
| * @pwm: the PWM device |
| */ |
| |
| /* |
| * pwm_disable - stop a PWM output toggling |
| * @pwm: the PWM device |
| */ |
| |
| #endif /* __QPNP_PWM_H__ */ |