bnx2x: Rework power state handling code
Move "don't shut down the power" logic into bnx2x_set_power_state() to make the code cleaner.
Signed-off-by: Vladislav Zolotarov <vladz@broadcom.com>
Signed-off-by: Eilon Greenstein <eilong@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/bnx2x_main.c b/drivers/net/bnx2x_main.c
index d7c0074..c4bc006 100644
--- a/drivers/net/bnx2x_main.c
+++ b/drivers/net/bnx2x_main.c
@@ -11935,6 +11935,14 @@
break;
case PCI_D3hot:
+ /* If there are other clients above don't
+ shut down the power */
+ if (atomic_read(&bp->pdev->enable_cnt) != 1)
+ return 0;
+ /* Don't shut down the power for emulation and FPGA */
+ if (CHIP_REV_IS_SLOW(bp))
+ return 0;
+
pmcsr &= ~PCI_PM_CTRL_STATE_MASK;
pmcsr |= 3;
@@ -12551,9 +12559,7 @@
/* Unload the driver, release IRQs */
bnx2x_nic_unload(bp, UNLOAD_CLOSE);
- if (atomic_read(&bp->pdev->enable_cnt) == 1)
- if (!CHIP_REV_IS_SLOW(bp))
- bnx2x_set_power_state(bp, PCI_D3hot);
+ bnx2x_set_power_state(bp, PCI_D3hot);
return 0;
}