| #ifndef FWH_LOCK_H |
| #define FWH_LOCK_H |
| |
| |
| enum fwh_lock_state { |
| FWH_UNLOCKED = 0, |
| FWH_DENY_WRITE = 1, |
| FWH_IMMUTABLE = 2, |
| FWH_DENY_READ = 4, |
| }; |
| |
| struct fwh_xxlock_thunk { |
| enum fwh_lock_state val; |
| flstate_t state; |
| }; |
| |
| |
| #define FWH_XXLOCK_ONEBLOCK_LOCK ((struct fwh_xxlock_thunk){ FWH_DENY_WRITE, FL_LOCKING}) |
| #define FWH_XXLOCK_ONEBLOCK_UNLOCK ((struct fwh_xxlock_thunk){ FWH_UNLOCKED, FL_UNLOCKING}) |
| |
| /* |
| * This locking/unlock is specific to firmware hub parts. Only one |
| * is known that supports the Intel command set. Firmware |
| * hub parts cannot be interleaved as they are on the LPC bus |
| * so this code has not been tested with interleaved chips, |
| * and will likely fail in that context. |
| */ |
| static int fwh_xxlock_oneblock(struct map_info *map, struct flchip *chip, |
| unsigned long adr, int len, void *thunk) |
| { |
| struct cfi_private *cfi = map->fldrv_priv; |
| struct fwh_xxlock_thunk *xxlt = (struct fwh_xxlock_thunk *)thunk; |
| int ret; |
| |
| /* Refuse the operation if the we cannot look behind the chip */ |
| if (chip->start < 0x400000) { |
| pr_debug( "MTD %s(): chip->start: %lx wanted >= 0x400000\n", |
| __func__, chip->start ); |
| return -EIO; |
| } |
| /* |
| * lock block registers: |
| * - on 64k boundariesand |
| * - bit 1 set high |
| * - block lock registers are 4MiB lower - overflow subtract (danger) |
| * |
| * The address manipulation is first done on the logical address |
| * which is 0 at the start of the chip, and then the offset of |
| * the individual chip is addted to it. Any other order a weird |
| * map offset could cause problems. |
| */ |
| adr = (adr & ~0xffffUL) | 0x2; |
| adr += chip->start - 0x400000; |
| |
| /* |
| * This is easy because these are writes to registers and not writes |
| * to flash memory - that means that we don't have to check status |
| * and timeout. |
| */ |
| mutex_lock(&chip->mutex); |
| ret = get_chip(map, chip, adr, FL_LOCKING); |
| if (ret) { |
| mutex_unlock(&chip->mutex); |
| return ret; |
| } |
| |
| chip->oldstate = chip->state; |
| chip->state = xxlt->state; |
| map_write(map, CMD(xxlt->val), adr); |
| |
| /* Done and happy. */ |
| chip->state = chip->oldstate; |
| put_chip(map, chip, adr); |
| mutex_unlock(&chip->mutex); |
| return 0; |
| } |
| |
| |
| static int fwh_lock_varsize(struct mtd_info *mtd, loff_t ofs, uint64_t len) |
| { |
| int ret; |
| |
| ret = cfi_varsize_frob(mtd, fwh_xxlock_oneblock, ofs, len, |
| (void *)&FWH_XXLOCK_ONEBLOCK_LOCK); |
| |
| return ret; |
| } |
| |
| |
| static int fwh_unlock_varsize(struct mtd_info *mtd, loff_t ofs, uint64_t len) |
| { |
| int ret; |
| |
| ret = cfi_varsize_frob(mtd, fwh_xxlock_oneblock, ofs, len, |
| (void *)&FWH_XXLOCK_ONEBLOCK_UNLOCK); |
| |
| return ret; |
| } |
| |
| static void fixup_use_fwh_lock(struct mtd_info *mtd) |
| { |
| printk(KERN_NOTICE "using fwh lock/unlock method\n"); |
| /* Setup for the chips with the fwh lock method */ |
| mtd->_lock = fwh_lock_varsize; |
| mtd->_unlock = fwh_unlock_varsize; |
| } |
| #endif /* FWH_LOCK_H */ |