mtd: fsmc_nand: Add clk_{un}prepare() support
clk_{un}prepare is mandatory for platforms using common clock framework. Since
this driver is used by SPEAr platform, which supports common clock framework,
add clk_{un}prepare() support for it.
Signed-off-by: Viresh Kumar <viresh.kumar@st.com>
Acked-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Artem Bityutskiy <artem.bityutskiy@linux.intel.com>
Signed-off-by: David Woodhouse <David.Woodhouse@intel.com>
diff --git a/drivers/mtd/nand/fsmc_nand.c b/drivers/mtd/nand/fsmc_nand.c
index 1b8330e..9d7f417 100644
--- a/drivers/mtd/nand/fsmc_nand.c
+++ b/drivers/mtd/nand/fsmc_nand.c
@@ -994,9 +994,9 @@
return PTR_ERR(host->clk);
}
- ret = clk_enable(host->clk);
+ ret = clk_prepare_enable(host->clk);
if (ret)
- goto err_clk_enable;
+ goto err_clk_prepare_enable;
/*
* This device ID is actually a common AMBA ID as used on the
@@ -1176,8 +1176,8 @@
if (host->mode == USE_DMA_ACCESS)
dma_release_channel(host->read_dma_chan);
err_req_read_chnl:
- clk_disable(host->clk);
-err_clk_enable:
+ clk_disable_unprepare(host->clk);
+err_clk_prepare_enable:
clk_put(host->clk);
return ret;
}
@@ -1198,7 +1198,7 @@
dma_release_channel(host->write_dma_chan);
dma_release_channel(host->read_dma_chan);
}
- clk_disable(host->clk);
+ clk_disable_unprepare(host->clk);
clk_put(host->clk);
}
@@ -1210,7 +1210,7 @@
{
struct fsmc_nand_data *host = dev_get_drvdata(dev);
if (host)
- clk_disable(host->clk);
+ clk_disable_unprepare(host->clk);
return 0;
}
@@ -1218,7 +1218,7 @@
{
struct fsmc_nand_data *host = dev_get_drvdata(dev);
if (host) {
- clk_enable(host->clk);
+ clk_prepare_enable(host->clk);
fsmc_nand_setup(host->regs_va, host->bank,
host->nand.options & NAND_BUSWIDTH_16,
host->dev_timings);