blob: b77ae679427503447b26c228d7356b5d1bb9070e [file] [log] [blame]
#
# Makefile for the PCI bus specific drivers.
#
obj-y += access.o bus.o probe.o remove.o pci.o quirks.o slot.o \
pci-driver.o search.o pci-sysfs.o rom.o setup-res.o \
irq.o
obj-$(CONFIG_PROC_FS) += proc.o
# Build PCI Express stuff if needed
obj-$(CONFIG_PCIEPORTBUS) += pcie/
obj-$(CONFIG_HOTPLUG) += hotplug.o
# Build the PCI Hotplug drivers if we were asked to
obj-$(CONFIG_HOTPLUG_PCI) += hotplug/
ifdef CONFIG_HOTPLUG_PCI
obj-y += hotplug-pci.o
endif
# Build the PCI MSI interrupt support
obj-$(CONFIG_PCI_MSI) += msi.o
# Build the Hypertransport interrupt support
obj-$(CONFIG_HT_IRQ) += htirq.o
# Build Intel IOMMU support
obj-$(CONFIG_DMAR) += dmar.o iova.o intel-iommu.o
obj-$(CONFIG_INTR_REMAP) += dmar.o intr_remapping.o
obj-$(CONFIG_PCI_IOV) += iov.o
#
# Some architectures use the generic PCI setup functions
#
obj-$(CONFIG_X86) += setup-bus.o
obj-$(CONFIG_ALPHA) += setup-bus.o setup-irq.o
obj-$(CONFIG_ARM) += setup-bus.o setup-irq.o
obj-$(CONFIG_PARISC) += setup-bus.o
obj-$(CONFIG_SUPERH) += setup-bus.o setup-irq.o
obj-$(CONFIG_PPC) += setup-bus.o
obj-$(CONFIG_MIPS) += setup-bus.o setup-irq.o
obj-$(CONFIG_X86_VISWS) += setup-irq.o
obj-$(CONFIG_MN10300) += setup-bus.o
#
# ACPI Related PCI FW Functions
#
obj-$(CONFIG_ACPI) += pci-acpi.o
# Cardbus & CompactPCI use setup-bus
obj-$(CONFIG_HOTPLUG) += setup-bus.o
obj-$(CONFIG_PCI_SYSCALL) += syscall.o
obj-$(CONFIG_PCI_STUB) += pci-stub.o
ifeq ($(CONFIG_PCI_DEBUG),y)
EXTRA_CFLAGS += -DDEBUG
endif