microblaze: Add linux.bin.ub target
Currently the linux.bin target creates both linux.bin and linux.bin.ub.
Add linux.bin.ub as separate target to generate linux.bin.ub.
Signed-off-by: Jason Wu <huanyu@xilinx.com>
Signed-off-by: Michal Simek <michal.simek@xilinx.com>
diff --git a/arch/microblaze/Makefile b/arch/microblaze/Makefile
index 0a603d3..40350a3 100644
--- a/arch/microblaze/Makefile
+++ b/arch/microblaze/Makefile
@@ -72,7 +72,7 @@
archclean:
$(Q)$(MAKE) $(clean)=$(boot)
-linux.bin linux.bin.gz: vmlinux
+linux.bin linux.bin.gz linux.bin.ub: vmlinux
$(Q)$(MAKE) $(build)=$(boot) $(boot)/$@
simpleImage.%: vmlinux
@@ -81,6 +81,7 @@
define archhelp
echo '* linux.bin - Create raw binary'
echo ' linux.bin.gz - Create compressed raw binary'
+ echo ' linux.bin.ub - Create U-Boot wrapped raw binary'
echo ' simpleImage.<dt> - ELF image with $(arch)/boot/dts/<dt>.dts linked in'
echo ' - stripped elf with fdt blob'
echo ' simpleImage.<dt>.unstrip - full ELF image with fdt blob'
diff --git a/arch/microblaze/boot/Makefile b/arch/microblaze/boot/Makefile
index 80fe54f..8e211cc 100644
--- a/arch/microblaze/boot/Makefile
+++ b/arch/microblaze/boot/Makefile
@@ -2,12 +2,15 @@
# arch/microblaze/boot/Makefile
#
-targets := linux.bin linux.bin.gz simpleImage.%
+targets := linux.bin linux.bin.gz linux.bin.ub simpleImage.%
OBJCOPYFLAGS := -R .note -R .comment -R .note.gnu.build-id -O binary
$(obj)/linux.bin: vmlinux FORCE
$(call if_changed,objcopy)
+ @echo 'Kernel: $@ is ready' ' (#'`cat .version`')'
+
+$(obj)/linux.bin.ub: $(obj)/linux.bin FORCE
$(call if_changed,uimage)
@echo 'Kernel: $@ is ready' ' (#'`cat .version`')'
@@ -22,8 +25,6 @@
cmd_strip = $(STRIP) -K microblaze_start -K _end -K __log_buf \
-K _fdt_start vmlinux -o $@
-UIMAGE_IN = $@
-UIMAGE_OUT = $@.ub
UIMAGE_LOADADDR = $(CONFIG_KERNEL_BASE_ADDR)
$(obj)/simpleImage.%: vmlinux FORCE