usb: gadget: s3c-hsotg: get phy bus width from phy subsystem
Adds support for querying the phy bus width from the generic phy
subsystem. Configure UTMI bus width in GUSBCFG based on this value.
Signed-off-by: Matt Porter <mporter@linaro.org>
Acked-by: Kishon Vijay Abraham I <kishon@ti.com>
Signed-off-by: Felipe Balbi <balbi@ti.com>
diff --git a/drivers/usb/gadget/s3c-hsotg.c b/drivers/usb/gadget/s3c-hsotg.c
index f39daf7..c0ff1cb 100644
--- a/drivers/usb/gadget/s3c-hsotg.c
+++ b/drivers/usb/gadget/s3c-hsotg.c
@@ -146,6 +146,7 @@
* @regs: The memory area mapped for accessing registers.
* @irq: The IRQ number we are using
* @supplies: Definition of USB power supplies
+ * @phyif: PHY interface width
* @dedicated_fifos: Set if the hardware has dedicated IN-EP fifos.
* @num_of_eps: Number of available EPs (excluding EP0)
* @debug_root: root directrory for debugfs.
@@ -174,6 +175,7 @@
struct regulator_bulk_data supplies[ARRAY_SIZE(s3c_hsotg_supply_names)];
+ u32 phyif;
unsigned int dedicated_fifos:1;
unsigned char num_of_eps;
@@ -2288,7 +2290,7 @@
*/
/* set the PLL on, remove the HNP/SRP and set the PHY */
- writel(GUSBCFG_PHYIf16 | GUSBCFG_TOutCal(7) |
+ writel(hsotg->phyif | GUSBCFG_TOutCal(7) |
(0x5 << 10), hsotg->regs + GUSBCFG);
s3c_hsotg_init_fifo(hsotg);
@@ -3646,6 +3648,16 @@
goto err_supplies;
}
+ /* Set default UTMI width */
+ hsotg->phyif = GUSBCFG_PHYIf16;
+
+ /*
+ * If using the generic PHY framework, check if the PHY bus
+ * width is 8-bit and set the phyif appropriately.
+ */
+ if (hsotg->phy && (phy_get_bus_width(phy) == 8))
+ hsotg->phyif = GUSBCFG_PHYIf8;
+
if (hsotg->phy)
phy_init(hsotg->phy);