arch/arm64/boot/dts/qcom/sdm670-qrd.dtsi

/* Copyright (c) 2017, The Linux Foundation. All rights reserved.
 *
 * This program is free software; you can redistribute it and/or modify
 * it under the terms of the GNU General Public License version 2 and
 * only version 2 as published by the Free Software Foundation.
 *
 * This program is distributed in the hope that it will be useful,
 * but WITHOUT ANY WARRANTY; without even the implied warranty of
 * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.  See the
 * GNU General Public License for more details.
 */

#include <dt-bindings/gpio/gpio.h>
#include "sdm670-pmic-overlay.dtsi"
#include "sdm670-audio-overlay.dtsi"
#include "smb1355.dtsi"

&qupv3_se9_2uart {
	status = "disabled";
};

&qupv3_se12_2uart {
	status = "ok";
};

&qupv3_se8_spi {
	status = "disabled";
};

&qupv3_se3_i2c {
	status = "ok";
	nq@28 {
		compatible = "qcom,nq-nci";
		reg = <0x28>;
		qcom,nq-irq = <&tlmm 44 0x00>;
		qcom,nq-ven = <&tlmm 12 0x00>;
		qcom,nq-firm = <&tlmm 43 0x00>;
		qcom,nq-clkreq = <&pm660_gpios 4 0x00>;
		qcom,nq-esepwr = <&tlmm 116 0x00>;
		interrupt-parent = <&tlmm>;
		qcom,clk-src = "BBCLK3";
		interrupts = <44 0>;
		interrupt-names = "nfc_irq";
		pinctrl-names = "nfc_active", "nfc_suspend";
		pinctrl-0 = <&nfc_int_active
			     &nfc_enable_active
			     &nfc_clk_default>;
		pinctrl-1 = <&nfc_int_suspend &nfc_enable_suspend>;
		clocks = <&clock_rpmh RPMH_LN_BB_CLK3>;
		clock-names = "ref_clk";
	};
};

&qupv3_se10_i2c {
	status = "ok";
};

&qupv3_se6_4uart {
	status = "ok";
};

&vendor {
	qrd_batterydata: qcom,battery-data {
		qcom,batt-id-range-pct = <15>;
		#include "fg-gen3-batterydata-mlp356477-2800mah.dtsi"
	};
};

&pm660_fg {
	qcom,battery-data = <&qrd_batterydata>;
	qcom,fg-bmd-en-delay-ms = <300>;
};

&tlmm {
	smb_int_default: smb_int_default {
		mux {
			pins = "gpio54";
			function = "gpio";
		};
		config {
			pins = "gpio54";
			drive-strength = <2>;
			bias-pull-up;
			input-enable;
		};
	};
};

&smb1355_0 {
	pinctrl-names = "default";
	pinctrl-0 = <&smb_int_default
		     &smb_shutdown_default>;
	interrupt-parent = <&tlmm>;
	interrupts = <54 IRQ_TYPE_LEVEL_LOW>;
	smb1355_charger_0: qcom,smb1355-charger@1000 {
		io-channels = <&pm660_rradc 2>,
				<&pm660_rradc 12>;
		io-channel-names = "charger_temp",
				   "charger_temp_max";
		status = "ok";
	};
};

&smb1355_1 {
	pinctrl-names = "default";
	pinctrl-0 = <&smb_int_default
		     &smb_shutdown_default>;
	interrupt-parent = <&tlmm>;
	interrupts = <54 IRQ_TYPE_LEVEL_LOW>;
	smb1355_charger_1: qcom,smb1355-charger@1000 {
		io-channels = <&pm660_rradc 2>,
				<&pm660_rradc 12>;
		io-channel-names = "charger_temp",
				   "charger_temp_max";
		status = "ok";
	};
};

&soc {
	gpio_keys {
		compatible = "gpio-keys";
		label = "gpio-keys";
		pinctrl-names = "default";
		pinctrl-0 = <&key_vol_up_default>;

		vol_up {
			label = "volume_up";
			gpios = <&pm660l_gpios 7 GPIO_ACTIVE_LOW>;
			linux,input-type = <1>;
			linux,code = <115>;
			gpio-key,wakeup;
			debounce-interval = <15>;
			linux,can-disable;
		};
	};
};

&pm660_haptics {
	qcom,vmax-mv = <1800>;
	qcom,wave-play-rate-us = <4255>;
	qcom,lra-auto-mode;
	status = "okay";
};

&int_codec {
	qcom,model = "sdm670-skuw-snd-card";
	qcom,audio-routing =
		"RX_BIAS", "INT_MCLK0",
		"SPK_RX_BIAS", "INT_MCLK0",
		"INT_LDO_H", "INT_MCLK0",
		"MIC BIAS External2", "Headset Mic",
		"AMIC2", "MIC BIAS External2",
		"MIC BIAS External", "Handset Mic",
		"AMIC1", "MIC BIAS External",
		"MIC BIAS External", "Secondary Mic",
		"AMIC3", "MIC BIAS External",
		"SpkrLeft IN", "SPK1 OUT",
		"PDM_IN_RX1", "PDM_OUT_RX1",
		"PDM_IN_RX2", "PDM_OUT_RX2",
		"PDM_IN_RX3", "PDM_OUT_RX3",
		"ADC1_IN", "ADC1_OUT",
		"ADC2_IN", "ADC2_OUT",
		"ADC3_IN", "ADC3_OUT";
	qcom,wsa-max-devs = <1>;
	qcom,wsa-devs = <&wsa881x_211_en>, <&wsa881x_213_en>;
	qcom,wsa-aux-dev-prefix = "SpkrLeft", "SpkrLeft";
};

&sdhc_1 {
	vdd-supply = <&pm660l_l4>;
	qcom,vdd-voltage-level = <2960000 2960000>;
	qcom,vdd-current-level = <200 570000>;

	vdd-io-supply = <&pm660_l8>;
	qcom,vdd-io-always-on;
	qcom,vdd-io-lpm-sup;
	qcom,vdd-io-voltage-level = <1800000 1800000>;
	qcom,vdd-io-current-level = <200 325000>;

	pinctrl-names = "active", "sleep";
	pinctrl-0 = <&sdc1_clk_on  &sdc1_cmd_on &sdc1_data_on &sdc1_rclk_on>;
	pinctrl-1 = <&sdc1_clk_off &sdc1_cmd_off &sdc1_data_off &sdc1_rclk_off>;

	status = "ok";
};

&sdhc_2 {
	vdd-supply = <&pm660l_l5>;
	qcom,vdd-voltage-level = <2960000 2960000>;
	qcom,vdd-current-level = <200 800000>;

	vdd-io-supply = <&pm660l_l2>;
	qcom,vdd-io-voltage-level = <1800000 2960000>;
	qcom,vdd-io-current-level = <200 22000>;

	pinctrl-names = "active", "sleep";
	pinctrl-0 = <&sdc2_clk_on  &sdc2_cmd_on &sdc2_data_on>;
	pinctrl-1 = <&sdc2_clk_off &sdc2_cmd_off &sdc2_data_off>;

	cd-gpios = <&tlmm 96 0>;

	status = "ok";
};