blob: 33350f9dd34f302f86d916a40a0cb627c636bf1b [file] [log] [blame]
Linus Torvalds1da177e2005-04-16 15:20:36 -07001#
Matt LaPlante01dd2fb2007-10-20 01:34:40 +02002# USB Imaging devices configuration
Linus Torvalds1da177e2005-04-16 15:20:36 -07003#
4comment "USB Imaging devices"
5 depends on USB
6
7config USB_MDC800
Robert P. J. Day528e4c12008-03-08 03:04:05 -05008 tristate "USB Mustek MDC800 Digital Camera support"
9 depends on USB
Linus Torvalds1da177e2005-04-16 15:20:36 -070010 ---help---
11 Say Y here if you want to connect this type of still camera to
12 your computer's USB port. This driver can be used with gphoto 0.4.3
13 and higher (look at <http://www.gphoto.org/>).
14 To use it create a device node with "mknod /dev/mustek c 180 32" and
15 configure it in your software.
16
17 To compile this driver as a module, choose M here: the
18 module will be called mdc800.
19
20config USB_MICROTEK
21 tristate "Microtek X6USB scanner support"
22 depends on USB && SCSI
23 help
24 Say Y here if you want support for the Microtek X6USB and
25 possibly the Phantom 336CX, Phantom C6 and ScanMaker V6U(S)L.
26 Support for anything but the X6 is experimental.
27 Please report failures and successes.
28 The scanner will appear as a scsi generic device to the rest
29 of the system. Scsi support is required.
30 This driver can be compiled as a module, called microtek.