blob: 09d5d4ee3a7709a1ebc4a5328a105f27649ee119 [file] [log] [blame]
Marc Kleine-Buddedf25f9d2008-10-10 12:05:03 +02001#define MMC_REG_STR_STP_CLK 0x00
2#define MMC_REG_STATUS 0x04
3#define MMC_REG_CLK_RATE 0x08
4#define MMC_REG_CMD_DAT_CONT 0x0C
5#define MMC_REG_RES_TO 0x10
6#define MMC_REG_READ_TO 0x14
7#define MMC_REG_BLK_LEN 0x18
8#define MMC_REG_NOB 0x1C
9#define MMC_REG_REV_NO 0x20
10#define MMC_REG_INT_MASK 0x24
11#define MMC_REG_CMD 0x28
12#define MMC_REG_ARGH 0x2C
13#define MMC_REG_ARGL 0x30
14#define MMC_REG_RES_FIFO 0x34
15#define MMC_REG_BUFFER_ACCESS 0x38
Pavel Pisa56ca90402006-04-02 19:27:07 +010016
Marc Kleine-Buddedf25f9d2008-10-10 12:05:03 +020017#define STR_STP_CLK_IPG_CLK_GATE_DIS (1<<15)
18#define STR_STP_CLK_IPG_PERCLK_GATE_DIS (1<<14)
Pavel Pisa56ca90402006-04-02 19:27:07 +010019#define STR_STP_CLK_ENDIAN (1<<5)
20#define STR_STP_CLK_RESET (1<<3)
21#define STR_STP_CLK_ENABLE (1<<2)
22#define STR_STP_CLK_START_CLK (1<<1)
23#define STR_STP_CLK_STOP_CLK (1<<0)
24#define STATUS_CARD_PRESENCE (1<<15)
25#define STATUS_SDIO_INT_ACTIVE (1<<14)
26#define STATUS_END_CMD_RESP (1<<13)
27#define STATUS_WRITE_OP_DONE (1<<12)
28#define STATUS_DATA_TRANS_DONE (1<<11)
29#define STATUS_WR_CRC_ERROR_CODE_MASK (3<<10)
30#define STATUS_CARD_BUS_CLK_RUN (1<<8)
31#define STATUS_APPL_BUFF_FF (1<<7)
32#define STATUS_APPL_BUFF_FE (1<<6)
33#define STATUS_RESP_CRC_ERR (1<<5)
34#define STATUS_CRC_READ_ERR (1<<3)
35#define STATUS_CRC_WRITE_ERR (1<<2)
36#define STATUS_TIME_OUT_RESP (1<<1)
37#define STATUS_TIME_OUT_READ (1<<0)
38#define STATUS_ERR_MASK 0x2f
39#define CLK_RATE_PRESCALER(x) ((x) & 0x7)
40#define CLK_RATE_CLK_RATE(x) (((x) & 0x7) << 3)
41#define CMD_DAT_CONT_CMD_RESP_LONG_OFF (1<<12)
42#define CMD_DAT_CONT_STOP_READWAIT (1<<11)
43#define CMD_DAT_CONT_START_READWAIT (1<<10)
44#define CMD_DAT_CONT_BUS_WIDTH_1 (0<<8)
45#define CMD_DAT_CONT_BUS_WIDTH_4 (2<<8)
46#define CMD_DAT_CONT_INIT (1<<7)
47#define CMD_DAT_CONT_BUSY (1<<6)
48#define CMD_DAT_CONT_STREAM_BLOCK (1<<5)
49#define CMD_DAT_CONT_WRITE (1<<4)
50#define CMD_DAT_CONT_DATA_ENABLE (1<<3)
51#define CMD_DAT_CONT_RESPONSE_FORMAT_R1 (1)
52#define CMD_DAT_CONT_RESPONSE_FORMAT_R2 (2)
53#define CMD_DAT_CONT_RESPONSE_FORMAT_R3 (3)
54#define CMD_DAT_CONT_RESPONSE_FORMAT_R4 (4)
55#define CMD_DAT_CONT_RESPONSE_FORMAT_R5 (5)
56#define CMD_DAT_CONT_RESPONSE_FORMAT_R6 (6)
57#define INT_MASK_AUTO_CARD_DETECT (1<<6)
58#define INT_MASK_DAT0_EN (1<<5)
59#define INT_MASK_SDIO (1<<4)
60#define INT_MASK_BUF_READY (1<<3)
61#define INT_MASK_END_CMD_RES (1<<2)
62#define INT_MASK_WRITE_OP_DONE (1<<1)
63#define INT_MASK_DATA_TRAN (1<<0)
64#define INT_ALL (0x7f)