Linus Torvalds | 1da177e | 2005-04-16 15:20:36 -0700 | [diff] [blame] | 1 | /* inflate.c -- zlib interface to inflate modules |
| 2 | * Copyright (C) 1995-1998 Mark Adler |
| 3 | * For conditions of distribution and use, see copyright notice in zlib.h |
| 4 | */ |
| 5 | |
| 6 | #include <linux/zutil.h> |
| 7 | #include "infblock.h" |
| 8 | #include "infutil.h" |
| 9 | |
Adrian Bunk | 87c2ce3 | 2006-01-09 20:54:07 -0800 | [diff] [blame] | 10 | #if 0 |
Linus Torvalds | 1da177e | 2005-04-16 15:20:36 -0700 | [diff] [blame] | 11 | int zlib_inflateSync( |
| 12 | z_streamp z |
| 13 | ) |
| 14 | { |
| 15 | uInt n; /* number of bytes to look at */ |
| 16 | Byte *p; /* pointer to bytes */ |
| 17 | uInt m; /* number of marker bytes found in a row */ |
| 18 | uLong r, w; /* temporaries to save total_in and total_out */ |
| 19 | |
| 20 | /* set up */ |
| 21 | if (z == NULL || z->state == NULL) |
| 22 | return Z_STREAM_ERROR; |
| 23 | if (z->state->mode != I_BAD) |
| 24 | { |
| 25 | z->state->mode = I_BAD; |
| 26 | z->state->sub.marker = 0; |
| 27 | } |
| 28 | if ((n = z->avail_in) == 0) |
| 29 | return Z_BUF_ERROR; |
| 30 | p = z->next_in; |
| 31 | m = z->state->sub.marker; |
| 32 | |
| 33 | /* search */ |
| 34 | while (n && m < 4) |
| 35 | { |
| 36 | static const Byte mark[4] = {0, 0, 0xff, 0xff}; |
| 37 | if (*p == mark[m]) |
| 38 | m++; |
| 39 | else if (*p) |
| 40 | m = 0; |
| 41 | else |
| 42 | m = 4 - m; |
| 43 | p++, n--; |
| 44 | } |
| 45 | |
| 46 | /* restore */ |
| 47 | z->total_in += p - z->next_in; |
| 48 | z->next_in = p; |
| 49 | z->avail_in = n; |
| 50 | z->state->sub.marker = m; |
| 51 | |
| 52 | /* return no joy or set up to restart on a new block */ |
| 53 | if (m != 4) |
| 54 | return Z_DATA_ERROR; |
| 55 | r = z->total_in; w = z->total_out; |
| 56 | zlib_inflateReset(z); |
| 57 | z->total_in = r; z->total_out = w; |
| 58 | z->state->mode = BLOCKS; |
| 59 | return Z_OK; |
| 60 | } |
Adrian Bunk | 87c2ce3 | 2006-01-09 20:54:07 -0800 | [diff] [blame] | 61 | #endif /* 0 */ |
Linus Torvalds | 1da177e | 2005-04-16 15:20:36 -0700 | [diff] [blame] | 62 | |
| 63 | |
| 64 | /* Returns true if inflate is currently at the end of a block generated |
| 65 | * by Z_SYNC_FLUSH or Z_FULL_FLUSH. This function is used by one PPP |
| 66 | * implementation to provide an additional safety check. PPP uses Z_SYNC_FLUSH |
| 67 | * but removes the length bytes of the resulting empty stored block. When |
| 68 | * decompressing, PPP checks that at the end of input packet, inflate is |
| 69 | * waiting for these length bytes. |
| 70 | */ |
Adrian Bunk | 87c2ce3 | 2006-01-09 20:54:07 -0800 | [diff] [blame] | 71 | #if 0 |
Linus Torvalds | 1da177e | 2005-04-16 15:20:36 -0700 | [diff] [blame] | 72 | int zlib_inflateSyncPoint( |
| 73 | z_streamp z |
| 74 | ) |
| 75 | { |
| 76 | if (z == NULL || z->state == NULL || z->state->blocks == NULL) |
| 77 | return Z_STREAM_ERROR; |
| 78 | return zlib_inflate_blocks_sync_point(z->state->blocks); |
| 79 | } |
Adrian Bunk | 87c2ce3 | 2006-01-09 20:54:07 -0800 | [diff] [blame] | 80 | #endif /* 0 */ |
Linus Torvalds | 1da177e | 2005-04-16 15:20:36 -0700 | [diff] [blame] | 81 | |
| 82 | /* |
| 83 | * This subroutine adds the data at next_in/avail_in to the output history |
| 84 | * without performing any output. The output buffer must be "caught up"; |
| 85 | * i.e. no pending output (hence s->read equals s->write), and the state must |
| 86 | * be BLOCKS (i.e. we should be willing to see the start of a series of |
| 87 | * BLOCKS). On exit, the output will also be caught up, and the checksum |
| 88 | * will have been updated if need be. |
| 89 | */ |
| 90 | static int zlib_inflate_addhistory(inflate_blocks_statef *s, |
| 91 | z_stream *z) |
| 92 | { |
| 93 | uLong b; /* bit buffer */ /* NOT USED HERE */ |
| 94 | uInt k; /* bits in bit buffer */ /* NOT USED HERE */ |
| 95 | uInt t; /* temporary storage */ |
| 96 | Byte *p; /* input data pointer */ |
| 97 | uInt n; /* bytes available there */ |
| 98 | Byte *q; /* output window write pointer */ |
| 99 | uInt m; /* bytes to end of window or read pointer */ |
| 100 | |
| 101 | if (s->read != s->write) |
| 102 | return Z_STREAM_ERROR; |
| 103 | if (s->mode != TYPE) |
| 104 | return Z_DATA_ERROR; |
| 105 | |
| 106 | /* we're ready to rock */ |
| 107 | LOAD |
| 108 | /* while there is input ready, copy to output buffer, moving |
| 109 | * pointers as needed. |
| 110 | */ |
| 111 | while (n) { |
| 112 | t = n; /* how many to do */ |
| 113 | /* is there room until end of buffer? */ |
| 114 | if (t > m) t = m; |
| 115 | /* update check information */ |
| 116 | if (s->checkfn != NULL) |
| 117 | s->check = (*s->checkfn)(s->check, q, t); |
| 118 | memcpy(q, p, t); |
| 119 | q += t; |
| 120 | p += t; |
| 121 | n -= t; |
| 122 | z->total_out += t; |
| 123 | s->read = q; /* drag read pointer forward */ |
| 124 | /* WWRAP */ /* expand WWRAP macro by hand to handle s->read */ |
| 125 | if (q == s->end) { |
| 126 | s->read = q = s->window; |
| 127 | m = WAVAIL; |
| 128 | } |
| 129 | } |
| 130 | UPDATE |
| 131 | return Z_OK; |
| 132 | } |
| 133 | |
| 134 | |
| 135 | /* |
| 136 | * This subroutine adds the data at next_in/avail_in to the output history |
| 137 | * without performing any output. The output buffer must be "caught up"; |
| 138 | * i.e. no pending output (hence s->read equals s->write), and the state must |
| 139 | * be BLOCKS (i.e. we should be willing to see the start of a series of |
| 140 | * BLOCKS). On exit, the output will also be caught up, and the checksum |
| 141 | * will have been updated if need be. |
| 142 | */ |
| 143 | |
| 144 | int zlib_inflateIncomp( |
| 145 | z_stream *z |
| 146 | |
| 147 | ) |
| 148 | { |
| 149 | if (z->state->mode != BLOCKS) |
| 150 | return Z_DATA_ERROR; |
| 151 | return zlib_inflate_addhistory(z->state->blocks, z); |
| 152 | } |