blob: b554927bbaf668102be8950d25fac53bca79f954 [file] [log] [blame]
David S. Miller334ae612008-08-27 17:01:57 -07001#ifndef _ASM_SPARC_DMA_H
2#define _ASM_SPARC_DMA_H
3
4/* These are irrelevant for Sparc DMA, but we leave it in so that
5 * things can compile.
6 */
7#define MAX_DMA_CHANNELS 8
8#define DMA_MODE_READ 1
9#define DMA_MODE_WRITE 2
10#define MAX_DMA_ADDRESS (~0UL)
11
12/* Useful constants */
13#define SIZE_16MB (16*1024*1024)
14#define SIZE_64K (64*1024)
15
16/* SBUS DMA controller reg offsets */
17#define DMA_CSR 0x00UL /* rw DMA control/status register 0x00 */
18#define DMA_ADDR 0x04UL /* rw DMA transfer address register 0x04 */
19#define DMA_COUNT 0x08UL /* rw DMA transfer count register 0x08 */
20#define DMA_TEST 0x0cUL /* rw DMA test/debug register 0x0c */
21
22/* Fields in the cond_reg register */
23/* First, the version identification bits */
24#define DMA_DEVICE_ID 0xf0000000 /* Device identification bits */
25#define DMA_VERS0 0x00000000 /* Sunray DMA version */
26#define DMA_ESCV1 0x40000000 /* DMA ESC Version 1 */
27#define DMA_VERS1 0x80000000 /* DMA rev 1 */
28#define DMA_VERS2 0xa0000000 /* DMA rev 2 */
29#define DMA_VERHME 0xb0000000 /* DMA hme gate array */
30#define DMA_VERSPLUS 0x90000000 /* DMA rev 1 PLUS */
31
32#define DMA_HNDL_INTR 0x00000001 /* An IRQ needs to be handled */
33#define DMA_HNDL_ERROR 0x00000002 /* We need to take an error */
34#define DMA_FIFO_ISDRAIN 0x0000000c /* The DMA FIFO is draining */
35#define DMA_INT_ENAB 0x00000010 /* Turn on interrupts */
36#define DMA_FIFO_INV 0x00000020 /* Invalidate the FIFO */
37#define DMA_ACC_SZ_ERR 0x00000040 /* The access size was bad */
38#define DMA_FIFO_STDRAIN 0x00000040 /* DMA_VERS1 Drain the FIFO */
39#define DMA_RST_SCSI 0x00000080 /* Reset the SCSI controller */
40#define DMA_RST_ENET DMA_RST_SCSI /* Reset the ENET controller */
41#define DMA_ST_WRITE 0x00000100 /* write from device to memory */
42#define DMA_ENABLE 0x00000200 /* Fire up DMA, handle requests */
43#define DMA_PEND_READ 0x00000400 /* DMA_VERS1/0/PLUS Pending Read */
44#define DMA_ESC_BURST 0x00000800 /* 1=16byte 0=32byte */
45#define DMA_READ_AHEAD 0x00001800 /* DMA read ahead partial longword */
46#define DMA_DSBL_RD_DRN 0x00001000 /* No EC drain on slave reads */
47#define DMA_BCNT_ENAB 0x00002000 /* If on, use the byte counter */
48#define DMA_TERM_CNTR 0x00004000 /* Terminal counter */
49#define DMA_SCSI_SBUS64 0x00008000 /* HME: Enable 64-bit SBUS mode. */
50#define DMA_CSR_DISAB 0x00010000 /* No FIFO drains during csr */
51#define DMA_SCSI_DISAB 0x00020000 /* No FIFO drains during reg */
52#define DMA_DSBL_WR_INV 0x00020000 /* No EC inval. on slave writes */
53#define DMA_ADD_ENABLE 0x00040000 /* Special ESC DVMA optimization */
54#define DMA_E_BURSTS 0x000c0000 /* ENET: SBUS r/w burst mask */
55#define DMA_E_BURST32 0x00040000 /* ENET: SBUS 32 byte r/w burst */
56#define DMA_E_BURST16 0x00000000 /* ENET: SBUS 16 byte r/w burst */
57#define DMA_BRST_SZ 0x000c0000 /* SCSI: SBUS r/w burst size */
58#define DMA_BRST64 0x000c0000 /* SCSI: 64byte bursts (HME on UltraSparc only) */
59#define DMA_BRST32 0x00040000 /* SCSI: 32byte bursts */
60#define DMA_BRST16 0x00000000 /* SCSI: 16byte bursts */
61#define DMA_BRST0 0x00080000 /* SCSI: no bursts (non-HME gate arrays) */
62#define DMA_ADDR_DISAB 0x00100000 /* No FIFO drains during addr */
63#define DMA_2CLKS 0x00200000 /* Each transfer = 2 clock ticks */
64#define DMA_3CLKS 0x00400000 /* Each transfer = 3 clock ticks */
65#define DMA_EN_ENETAUI DMA_3CLKS /* Put lance into AUI-cable mode */
66#define DMA_CNTR_DISAB 0x00800000 /* No IRQ when DMA_TERM_CNTR set */
67#define DMA_AUTO_NADDR 0x01000000 /* Use "auto nxt addr" feature */
68#define DMA_SCSI_ON 0x02000000 /* Enable SCSI dma */
69#define DMA_PARITY_OFF 0x02000000 /* HME: disable parity checking */
70#define DMA_LOADED_ADDR 0x04000000 /* Address has been loaded */
71#define DMA_LOADED_NADDR 0x08000000 /* Next address has been loaded */
72#define DMA_RESET_FAS366 0x08000000 /* HME: Assert RESET to FAS366 */
73
74/* Values describing the burst-size property from the PROM */
75#define DMA_BURST1 0x01
76#define DMA_BURST2 0x02
77#define DMA_BURST4 0x04
78#define DMA_BURST8 0x08
79#define DMA_BURST16 0x10
80#define DMA_BURST32 0x20
81#define DMA_BURST64 0x40
82#define DMA_BURSTBITS 0x7f
83
84/* From PCI */
85
86#ifdef CONFIG_PCI
87extern int isa_dma_bridge_buggy;
Sam Ravnborga439fe52008-07-27 23:00:59 +020088#else
David S. Miller334ae612008-08-27 17:01:57 -070089#define isa_dma_bridge_buggy (0)
Sam Ravnborga439fe52008-07-27 23:00:59 +020090#endif
David S. Miller334ae612008-08-27 17:01:57 -070091
92#ifdef CONFIG_SPARC32
93
David S. Miller334ae612008-08-27 17:01:57 -070094/* Routines for data transfer buffers. */
95BTFIXUPDEF_CALL(char *, mmu_lockarea, char *, unsigned long)
96BTFIXUPDEF_CALL(void, mmu_unlockarea, char *, unsigned long)
97
98#define mmu_lockarea(vaddr,len) BTFIXUP_CALL(mmu_lockarea)(vaddr,len)
99#define mmu_unlockarea(vaddr,len) BTFIXUP_CALL(mmu_unlockarea)(vaddr,len)
100
David S. Miller260489f2008-08-26 23:00:58 -0700101struct page;
102struct device;
103struct scatterlist;
David S. Miller334ae612008-08-27 17:01:57 -0700104
David S. Miller260489f2008-08-26 23:00:58 -0700105/* These are implementations for sbus_map_sg/sbus_unmap_sg... collapse later */
106BTFIXUPDEF_CALL(__u32, mmu_get_scsi_one, struct device *, char *, unsigned long)
107BTFIXUPDEF_CALL(void, mmu_get_scsi_sgl, struct device *, struct scatterlist *, int)
108BTFIXUPDEF_CALL(void, mmu_release_scsi_one, struct device *, __u32, unsigned long)
109BTFIXUPDEF_CALL(void, mmu_release_scsi_sgl, struct device *, struct scatterlist *, int)
110
111#define mmu_get_scsi_one(dev,vaddr,len) BTFIXUP_CALL(mmu_get_scsi_one)(dev,vaddr,len)
112#define mmu_get_scsi_sgl(dev,sg,sz) BTFIXUP_CALL(mmu_get_scsi_sgl)(dev,sg,sz)
113#define mmu_release_scsi_one(dev,vaddr,len) BTFIXUP_CALL(mmu_release_scsi_one)(dev,vaddr,len)
114#define mmu_release_scsi_sgl(dev,sg,sz) BTFIXUP_CALL(mmu_release_scsi_sgl)(dev,sg,sz)
David S. Miller334ae612008-08-27 17:01:57 -0700115
116/*
117 * mmu_map/unmap are provided by iommu/iounit; Invalid to call on IIep.
118 *
119 * The mmu_map_dma_area establishes two mappings in one go.
120 * These mappings point to pages normally mapped at 'va' (linear address).
121 * First mapping is for CPU visible address at 'a', uncached.
122 * This is an alias, but it works because it is an uncached mapping.
123 * Second mapping is for device visible address, or "bus" address.
124 * The bus address is returned at '*pba'.
125 *
126 * These functions seem distinct, but are hard to split. On sun4c,
127 * at least for now, 'a' is equal to bus address, and retured in *pba.
128 * On sun4m, page attributes depend on the CPU type, so we have to
129 * know if we are mapping RAM or I/O, so it has to be an additional argument
130 * to a separate mapping function for CPU visible mappings.
131 */
David S. Miller4b1c5df2008-08-27 18:40:38 -0700132BTFIXUPDEF_CALL(int, mmu_map_dma_area, struct device *, dma_addr_t *, unsigned long, unsigned long, int len)
133BTFIXUPDEF_CALL(void, mmu_unmap_dma_area, struct device *, unsigned long busa, int len)
David S. Miller334ae612008-08-27 17:01:57 -0700134
David S. Miller4b1c5df2008-08-27 18:40:38 -0700135#define mmu_map_dma_area(dev,pba,va,a,len) BTFIXUP_CALL(mmu_map_dma_area)(dev,pba,va,a,len)
136#define mmu_unmap_dma_area(dev,ba,len) BTFIXUP_CALL(mmu_unmap_dma_area)(dev,ba,len)
Sam Ravnborga439fe52008-07-27 23:00:59 +0200137#endif
David S. Miller334ae612008-08-27 17:01:57 -0700138
139#endif /* !(_ASM_SPARC_DMA_H) */