blob: 5d685df427b45a28a75332ac18f7096dc4740f2b [file] [log] [blame]
Sam Ravnborga439fe52008-07-27 23:00:59 +02001/*
2 * auxio.h: Definitions and code for the Auxiliary I/O register.
3 *
4 * Copyright (C) 1995 David S. Miller (davem@caip.rutgers.edu)
5 */
6#ifndef _SPARC_AUXIO_H
7#define _SPARC_AUXIO_H
8
Sam Ravnborga439fe52008-07-27 23:00:59 +02009#include <asm/vaddrs.h>
10
11/* This register is an unsigned char in IO space. It does two things.
12 * First, it is used to control the front panel LED light on machines
13 * that have it (good for testing entry points to trap handlers and irq's)
14 * Secondly, it controls various floppy drive parameters.
15 */
16#define AUXIO_ORMEIN 0xf0 /* All writes must set these bits. */
17#define AUXIO_ORMEIN4M 0xc0 /* sun4m - All writes must set these bits. */
18#define AUXIO_FLPY_DENS 0x20 /* Floppy density, high if set. Read only. */
19#define AUXIO_FLPY_DCHG 0x10 /* A disk change occurred. Read only. */
20#define AUXIO_EDGE_ON 0x10 /* sun4m - On means Jumper block is in. */
21#define AUXIO_FLPY_DSEL 0x08 /* Drive select/start-motor. Write only. */
22#define AUXIO_LINK_TEST 0x08 /* sun4m - On means TPE Carrier detect. */
23
24/* Set the following to one, then zero, after doing a pseudo DMA transfer. */
25#define AUXIO_FLPY_TCNT 0x04 /* Floppy terminal count. Write only. */
26
27/* Set the following to zero to eject the floppy. */
28#define AUXIO_FLPY_EJCT 0x02 /* Eject floppy disk. Write only. */
29#define AUXIO_LED 0x01 /* On if set, off if unset. Read/Write */
30
31#ifndef __ASSEMBLY__
32
33/*
34 * NOTE: these routines are implementation dependent--
35 * understand the hardware you are querying!
36 */
Sam Ravnborgf05a6862014-05-16 23:25:50 +020037void set_auxio(unsigned char bits_on, unsigned char bits_off);
38unsigned char get_auxio(void); /* .../asm/floppy.h */
Sam Ravnborga439fe52008-07-27 23:00:59 +020039
40/*
41 * The following routines are provided for driver-compatibility
42 * with sparc64 (primarily sunlance.c)
43 */
44
45#define AUXIO_LTE_ON 1
46#define AUXIO_LTE_OFF 0
47
48/* auxio_set_lte - Set Link Test Enable (TPE Link Detect)
49 *
50 * on - AUXIO_LTE_ON or AUXIO_LTE_OFF
51 */
52#define auxio_set_lte(on) \
53do { \
54 if(on) { \
55 set_auxio(AUXIO_LINK_TEST, 0); \
56 } else { \
57 set_auxio(0, AUXIO_LINK_TEST); \
58 } \
59} while (0)
60
61#define AUXIO_LED_ON 1
62#define AUXIO_LED_OFF 0
63
64/* auxio_set_led - Set system front panel LED
65 *
66 * on - AUXIO_LED_ON or AUXIO_LED_OFF
67 */
68#define auxio_set_led(on) \
69do { \
70 if(on) { \
71 set_auxio(AUXIO_LED, 0); \
72 } else { \
73 set_auxio(0, AUXIO_LED); \
74 } \
75} while (0)
76
77#endif /* !(__ASSEMBLY__) */
78
79
80/* AUXIO2 (Power Off Control) */
Sam Ravnborgd2aca8f2014-05-16 23:25:43 +020081extern volatile u8 __iomem *auxio_power_register;
Sam Ravnborga439fe52008-07-27 23:00:59 +020082
83#define AUXIO_POWER_DETECT_FAILURE 32
84#define AUXIO_POWER_CLEAR_FAILURE 2
85#define AUXIO_POWER_OFF 1
86
87
88#endif /* !(_SPARC_AUXIO_H) */