| menuconfig EXTCON |
| tristate "External Connector Class (extcon) support" |
| help |
| Say Y here to enable external connector class (extcon) support. |
| This allows monitoring external connectors by userspace |
| via sysfs and uevent and supports external connectors with |
| multiple states; i.e., an extcon that may have multiple |
| cables attached. For example, an external connector of a device |
| may be used to connect an HDMI cable and a AC adaptor, and to |
| host USB ports. Many of 30-pin connectors including PDMI are |
| also good examples. |
| |
| if EXTCON |
| |
| comment "Extcon Device Drivers" |
| |
| config EXTCON_GPIO |
| tristate "GPIO extcon support" |
| depends on GENERIC_GPIO |
| help |
| Say Y here to enable GPIO based extcon support. Note that GPIO |
| extcon supports single state per extcon instance. |
| |
| config EXTCON_MAX8997 |
| tristate "MAX8997 EXTCON Support" |
| depends on MFD_MAX8997 |
| help |
| If you say yes here you get support for the MUIC device of |
| Maxim MAX8997 PMIC. The MAX8997 MUIC is a USB port accessory |
| detector and switch. |
| |
| endif # MULTISTATE_SWITCH |