i2c: busses: make use of i2c_8bit_addr_from_msg
Because it looks neater.
For diolan, this allows factoring out some code that is now common
between if and else.
For eg20t, pch_i2c_writebytes is always called with a write in
msgs->flags, and pch_i2c_readbytes with a read.
For imx, i2c_imx_dma_write and i2c_imx_write are always called with a
write in msgs->flags, and i2c_imx_read with a read.
For qup, qup_i2c_write_tx_fifo_v1 is always called with a write in
qup->msg->flags.
For stu300, also restructure debug output for resends, since that
code as a result is only handling debug output.
Reviewed-by: Guenter Roeck <linux@roeck-us.net> [diolan]
Acked-by: Uwe Kleine-König <u.kleine-koenig@pengutronix.de> [efm32 and imx]
Acked-by: Linus Walleij <linus.walleij@linaro.org> [stu300]
Signed-off-by: Peter Rosin <peda@axentia.se>
Signed-off-by: Wolfram Sang <wsa@the-dreams.de>
diff --git a/drivers/i2c/busses/i2c-kempld.c b/drivers/i2c/busses/i2c-kempld.c
index e879190..1c874aa 100644
--- a/drivers/i2c/busses/i2c-kempld.c
+++ b/drivers/i2c/busses/i2c-kempld.c
@@ -124,15 +124,14 @@ static int kempld_i2c_process(struct kempld_i2c_data *i2c)
/* 10 bit address? */
if (i2c->msg->flags & I2C_M_TEN) {
addr = 0xf0 | ((i2c->msg->addr >> 7) & 0x6);
+ /* Set read bit if necessary */
+ addr |= (i2c->msg->flags & I2C_M_RD) ? 1 : 0;
i2c->state = STATE_ADDR10;
} else {
- addr = (i2c->msg->addr << 1);
+ addr = i2c_8bit_addr_from_msg(i2c->msg);
i2c->state = STATE_START;
}
- /* Set read bit if necessary */
- addr |= (i2c->msg->flags & I2C_M_RD) ? 1 : 0;
-
kempld_write8(pld, KEMPLD_I2C_DATA, addr);
kempld_write8(pld, KEMPLD_I2C_CMD, I2C_CMD_START);