rtlwifi: Use 6 bits as sequence number of TX report
In new design, SW_DEFINE[1:0] of tx desc are used by firmware, and the TX
report only contains SW_DEFINE[7:0]. To satisfy with all cases, driver uses
SW_DEFINE[7:2] as sequence number.
Besides, the format of tx report have been changed, so a new flag
RTL_SPEC_EXT_C2H is used to access report.
Signed-off-by: Ping-Ke Shih <pkshih@realtek.com>
Acked-by: Larry Finger <Larry.Finger@lwfinger.net>
Signed-off-by: Kalle Valo <kvalo@codeaurora.org>
diff --git a/drivers/net/wireless/realtek/rtlwifi/wifi.h b/drivers/net/wireless/realtek/rtlwifi/wifi.h
index f6fe7ca..31ef9f7 100644
--- a/drivers/net/wireless/realtek/rtlwifi/wifi.h
+++ b/drivers/net/wireless/realtek/rtlwifi/wifi.h
@@ -154,6 +154,13 @@ enum rtl8192c_h2c_cmd {
MAX_H2CCMD
};
+#define GET_TX_REPORT_SN_V1(c2h) (c2h[6])
+#define GET_TX_REPORT_ST_V1(c2h) (c2h[0] & 0xC0)
+#define GET_TX_REPORT_RETRY_V1(c2h) (c2h[2] & 0x3F)
+#define GET_TX_REPORT_SN_V2(c2h) (c2h[6])
+#define GET_TX_REPORT_ST_V2(c2h) (c2h[7] & 0xC0)
+#define GET_TX_REPORT_RETRY_V2(c2h) (c2h[8] & 0x3F)
+
#define MAX_TX_COUNT 4
#define MAX_REGULATION_NUM 4
#define MAX_RF_PATH_NUM 4
@@ -953,6 +960,7 @@ enum package_type {
enum rtl_spec_ver {
RTL_SPEC_NEW_RATEID = BIT(0), /* use ratr_table_mode_new */
RTL_SPEC_SUPPORT_VHT = BIT(1), /* support VHT */
+ RTL_SPEC_EXT_C2H = BIT(2), /* extend FW C2H (e.g. TX REPORT) */
};
struct octet_string {