| /* |
| * This file is subject to the terms and conditions of the GNU General Public |
| * License. See the file "COPYING" in the main directory of this archive |
| * for more details. |
| * |
| * Copyright (C) 2005-2007 Cavium Networks |
| */ |
| #include <linux/kernel.h> |
| #include <linux/init.h> |
| #include <linux/pci.h> |
| #include <linux/interrupt.h> |
| #include <linux/time.h> |
| #include <linux/delay.h> |
| #include "pci-common.h" |
| |
| typeof(pcibios_map_irq) *octeon_pcibios_map_irq; |
| enum octeon_dma_bar_type octeon_dma_bar_type = OCTEON_DMA_BAR_TYPE_INVALID; |
| |
| /** |
| * Map a PCI device to the appropriate interrupt line |
| * |
| * @param dev The Linux PCI device structure for the device to map |
| * @param slot The slot number for this device on __BUS 0__. Linux |
| * enumerates through all the bridges and figures out the |
| * slot on Bus 0 where this device eventually hooks to. |
| * @param pin The PCI interrupt pin read from the device, then swizzled |
| * as it goes through each bridge. |
| * @return Interrupt number for the device |
| */ |
| int __init pcibios_map_irq(const struct pci_dev *dev, u8 slot, u8 pin) |
| { |
| if (octeon_pcibios_map_irq) |
| return octeon_pcibios_map_irq(dev, slot, pin); |
| else |
| panic("octeon_pcibios_map_irq doesn't point to a " |
| "pcibios_map_irq() function"); |
| } |
| |
| |
| /** |
| * Called to perform platform specific PCI setup |
| * |
| * @param dev |
| * @return |
| */ |
| int pcibios_plat_dev_init(struct pci_dev *dev) |
| { |
| uint16_t config; |
| uint32_t dconfig; |
| int pos; |
| /* |
| * Force the Cache line setting to 64 bytes. The standard |
| * Linux bus scan doesn't seem to set it. Octeon really has |
| * 128 byte lines, but Intel bridges get really upset if you |
| * try and set values above 64 bytes. Value is specified in |
| * 32bit words. |
| */ |
| pci_write_config_byte(dev, PCI_CACHE_LINE_SIZE, 64 / 4); |
| /* Set latency timers for all devices */ |
| pci_write_config_byte(dev, PCI_LATENCY_TIMER, 48); |
| |
| /* Enable reporting System errors and parity errors on all devices */ |
| /* Enable parity checking and error reporting */ |
| pci_read_config_word(dev, PCI_COMMAND, &config); |
| config |= PCI_COMMAND_PARITY | PCI_COMMAND_SERR; |
| pci_write_config_word(dev, PCI_COMMAND, config); |
| |
| if (dev->subordinate) { |
| /* Set latency timers on sub bridges */ |
| pci_write_config_byte(dev, PCI_SEC_LATENCY_TIMER, 48); |
| /* More bridge error detection */ |
| pci_read_config_word(dev, PCI_BRIDGE_CONTROL, &config); |
| config |= PCI_BRIDGE_CTL_PARITY | PCI_BRIDGE_CTL_SERR; |
| pci_write_config_word(dev, PCI_BRIDGE_CONTROL, config); |
| } |
| |
| /* Enable the PCIe normal error reporting */ |
| pos = pci_find_capability(dev, PCI_CAP_ID_EXP); |
| if (pos) { |
| /* Update Device Control */ |
| pci_read_config_word(dev, pos + PCI_EXP_DEVCTL, &config); |
| /* Correctable Error Reporting */ |
| config |= PCI_EXP_DEVCTL_CERE; |
| /* Non-Fatal Error Reporting */ |
| config |= PCI_EXP_DEVCTL_NFERE; |
| /* Fatal Error Reporting */ |
| config |= PCI_EXP_DEVCTL_FERE; |
| /* Unsupported Request */ |
| config |= PCI_EXP_DEVCTL_URRE; |
| pci_write_config_word(dev, pos + PCI_EXP_DEVCTL, config); |
| } |
| |
| /* Find the Advanced Error Reporting capability */ |
| pos = pci_find_ext_capability(dev, PCI_EXT_CAP_ID_ERR); |
| if (pos) { |
| /* Clear Uncorrectable Error Status */ |
| pci_read_config_dword(dev, pos + PCI_ERR_UNCOR_STATUS, |
| &dconfig); |
| pci_write_config_dword(dev, pos + PCI_ERR_UNCOR_STATUS, |
| dconfig); |
| /* Enable reporting of all uncorrectable errors */ |
| /* Uncorrectable Error Mask - turned on bits disable errors */ |
| pci_write_config_dword(dev, pos + PCI_ERR_UNCOR_MASK, 0); |
| /* |
| * Leave severity at HW default. This only controls if |
| * errors are reported as uncorrectable or |
| * correctable, not if the error is reported. |
| */ |
| /* PCI_ERR_UNCOR_SEVER - Uncorrectable Error Severity */ |
| /* Clear Correctable Error Status */ |
| pci_read_config_dword(dev, pos + PCI_ERR_COR_STATUS, &dconfig); |
| pci_write_config_dword(dev, pos + PCI_ERR_COR_STATUS, dconfig); |
| /* Enable reporting of all correctable errors */ |
| /* Correctable Error Mask - turned on bits disable errors */ |
| pci_write_config_dword(dev, pos + PCI_ERR_COR_MASK, 0); |
| /* Advanced Error Capabilities */ |
| pci_read_config_dword(dev, pos + PCI_ERR_CAP, &dconfig); |
| /* ECRC Generation Enable */ |
| if (config & PCI_ERR_CAP_ECRC_GENC) |
| config |= PCI_ERR_CAP_ECRC_GENE; |
| /* ECRC Check Enable */ |
| if (config & PCI_ERR_CAP_ECRC_CHKC) |
| config |= PCI_ERR_CAP_ECRC_CHKE; |
| pci_write_config_dword(dev, pos + PCI_ERR_CAP, dconfig); |
| /* PCI_ERR_HEADER_LOG - Header Log Register (16 bytes) */ |
| /* Report all errors to the root complex */ |
| pci_write_config_dword(dev, pos + PCI_ERR_ROOT_COMMAND, |
| PCI_ERR_ROOT_CMD_COR_EN | |
| PCI_ERR_ROOT_CMD_NONFATAL_EN | |
| PCI_ERR_ROOT_CMD_FATAL_EN); |
| /* Clear the Root status register */ |
| pci_read_config_dword(dev, pos + PCI_ERR_ROOT_STATUS, &dconfig); |
| pci_write_config_dword(dev, pos + PCI_ERR_ROOT_STATUS, dconfig); |
| } |
| |
| return 0; |
| } |