| #ifndef __ASMARM_ELF_H |
| #define __ASMARM_ELF_H |
| |
| #include <linux/config.h> |
| |
| /* |
| * ELF register definitions.. |
| */ |
| |
| #include <asm/ptrace.h> |
| #include <asm/user.h> |
| #include <asm/procinfo.h> |
| |
| typedef unsigned long elf_greg_t; |
| typedef unsigned long elf_freg_t[3]; |
| |
| #define EM_ARM 40 |
| #define EF_ARM_APCS26 0x08 |
| #define EF_ARM_SOFT_FLOAT 0x200 |
| #define EF_ARM_EABI_MASK 0xFF000000 |
| |
| #define R_ARM_NONE 0 |
| #define R_ARM_PC24 1 |
| #define R_ARM_ABS32 2 |
| #define R_ARM_CALL 28 |
| #define R_ARM_JUMP24 29 |
| |
| #define ELF_NGREG (sizeof (struct pt_regs) / sizeof(elf_greg_t)) |
| typedef elf_greg_t elf_gregset_t[ELF_NGREG]; |
| |
| typedef struct user_fp elf_fpregset_t; |
| |
| /* |
| * This is used to ensure we don't load something for the wrong architecture. |
| */ |
| #define elf_check_arch(x) ( ((x)->e_machine == EM_ARM) && (ELF_PROC_OK((x))) ) |
| |
| /* |
| * These are used to set parameters in the core dumps. |
| */ |
| #define ELF_CLASS ELFCLASS32 |
| #ifdef __ARMEB__ |
| #define ELF_DATA ELFDATA2MSB |
| #else |
| #define ELF_DATA ELFDATA2LSB |
| #endif |
| #define ELF_ARCH EM_ARM |
| |
| #define USE_ELF_CORE_DUMP |
| #define ELF_EXEC_PAGESIZE 4096 |
| |
| /* This is the location that an ET_DYN program is loaded if exec'ed. Typical |
| use of this is to invoke "./ld.so someprog" to test out a new version of |
| the loader. We need to make sure that it is out of the way of the program |
| that it will "exec", and that there is sufficient room for the brk. */ |
| |
| #define ELF_ET_DYN_BASE (2 * TASK_SIZE / 3) |
| |
| /* When the program starts, a1 contains a pointer to a function to be |
| registered with atexit, as per the SVR4 ABI. A value of 0 means we |
| have no such handler. */ |
| #define ELF_PLAT_INIT(_r, load_addr) (_r)->ARM_r0 = 0 |
| |
| /* This yields a mask that user programs can use to figure out what |
| instruction set this cpu supports. */ |
| |
| #define ELF_HWCAP (elf_hwcap) |
| |
| /* This yields a string that ld.so will use to load implementation |
| specific libraries for optimization. This is more specific in |
| intent than poking at uname or /proc/cpuinfo. */ |
| |
| /* For now we just provide a fairly general string that describes the |
| processor family. This could be made more specific later if someone |
| implemented optimisations that require it. 26-bit CPUs give you |
| "v1l" for ARM2 (no SWP) and "v2l" for anything else (ARM1 isn't |
| supported). 32-bit CPUs give you "v3[lb]" for anything based on an |
| ARM6 or ARM7 core and "armv4[lb]" for anything based on a StrongARM-1 |
| core. */ |
| |
| #define ELF_PLATFORM_SIZE 8 |
| extern char elf_platform[]; |
| #define ELF_PLATFORM (elf_platform) |
| |
| #ifdef __KERNEL__ |
| |
| /* |
| * 32-bit code is always OK. Some cpus can do 26-bit, some can't. |
| */ |
| #define ELF_PROC_OK(x) (ELF_THUMB_OK(x) && ELF_26BIT_OK(x)) |
| |
| #define ELF_THUMB_OK(x) \ |
| (( (elf_hwcap & HWCAP_THUMB) && ((x)->e_entry & 1) == 1) || \ |
| ((x)->e_entry & 3) == 0) |
| |
| #define ELF_26BIT_OK(x) \ |
| (( (elf_hwcap & HWCAP_26BIT) && (x)->e_flags & EF_ARM_APCS26) || \ |
| ((x)->e_flags & EF_ARM_APCS26) == 0) |
| |
| #ifndef CONFIG_IWMMXT |
| |
| /* Old NetWinder binaries were compiled in such a way that the iBCS |
| heuristic always trips on them. Until these binaries become uncommon |
| enough not to care, don't trust the `ibcs' flag here. In any case |
| there is no other ELF system currently supported by iBCS. |
| @@ Could print a warning message to encourage users to upgrade. */ |
| #define SET_PERSONALITY(ex,ibcs2) \ |
| set_personality(((ex).e_flags&EF_ARM_APCS26 ?PER_LINUX :PER_LINUX_32BIT)) |
| |
| #else |
| |
| /* |
| * All iWMMXt capable CPUs don't support 26-bit mode. Yet they can run |
| * legacy binaries which used to contain FPA11 floating point instructions |
| * that have always been emulated by the kernel. PFA11 and iWMMXt overlap |
| * on coprocessor 1 space though. We therefore must decide if given task |
| * is allowed to use CP 0 and 1 for iWMMXt, or if they should be blocked |
| * at all times for the prefetch exception handler to catch FPA11 opcodes |
| * and emulate them. The best indication to discriminate those two cases |
| * is the SOFT_FLOAT flag in the ELF header. |
| */ |
| |
| #define SET_PERSONALITY(ex,ibcs2) \ |
| do { \ |
| set_personality(PER_LINUX_32BIT); \ |
| if (((ex).e_flags & EF_ARM_EABI_MASK) || \ |
| ((ex).e_flags & EF_ARM_SOFT_FLOAT)) \ |
| set_thread_flag(TIF_USING_IWMMXT); \ |
| else \ |
| clear_thread_flag(TIF_USING_IWMMXT); \ |
| } while (0) |
| |
| #endif |
| |
| #endif |
| |
| #endif |