| /* |
| * Versatile Express Core Tile Cortex A9x4 Support |
| */ |
| #include <linux/init.h> |
| #include <linux/gfp.h> |
| #include <linux/device.h> |
| #include <linux/dma-mapping.h> |
| #include <linux/platform_device.h> |
| #include <linux/amba/bus.h> |
| #include <linux/amba/clcd.h> |
| |
| #include <asm/clkdev.h> |
| #include <asm/hardware/arm_timer.h> |
| #include <asm/hardware/cache-l2x0.h> |
| #include <asm/hardware/gic.h> |
| #include <asm/mach-types.h> |
| #include <asm/pmu.h> |
| |
| #include <mach/clkdev.h> |
| #include <mach/ct-ca9x4.h> |
| |
| #include <plat/timer-sp.h> |
| |
| #include <asm/mach/arch.h> |
| #include <asm/mach/map.h> |
| #include <asm/mach/time.h> |
| |
| #include "core.h" |
| |
| #include <mach/motherboard.h> |
| |
| #define V2M_PA_CS7 0x10000000 |
| |
| static struct map_desc ct_ca9x4_io_desc[] __initdata = { |
| { |
| .virtual = __MMIO_P2V(CT_CA9X4_MPIC), |
| .pfn = __phys_to_pfn(CT_CA9X4_MPIC), |
| .length = SZ_16K, |
| .type = MT_DEVICE, |
| }, { |
| .virtual = __MMIO_P2V(CT_CA9X4_SP804_TIMER), |
| .pfn = __phys_to_pfn(CT_CA9X4_SP804_TIMER), |
| .length = SZ_4K, |
| .type = MT_DEVICE, |
| }, { |
| .virtual = __MMIO_P2V(CT_CA9X4_L2CC), |
| .pfn = __phys_to_pfn(CT_CA9X4_L2CC), |
| .length = SZ_4K, |
| .type = MT_DEVICE, |
| }, |
| }; |
| |
| static void __init ct_ca9x4_map_io(void) |
| { |
| v2m_map_io(ct_ca9x4_io_desc, ARRAY_SIZE(ct_ca9x4_io_desc)); |
| } |
| |
| void __iomem *gic_cpu_base_addr; |
| |
| static void __init ct_ca9x4_init_irq(void) |
| { |
| gic_cpu_base_addr = MMIO_P2V(A9_MPCORE_GIC_CPU); |
| gic_dist_init(0, MMIO_P2V(A9_MPCORE_GIC_DIST), 29); |
| gic_cpu_init(0, gic_cpu_base_addr); |
| } |
| |
| #if 0 |
| static void ct_ca9x4_timer_init(void) |
| { |
| writel(0, MMIO_P2V(CT_CA9X4_TIMER0) + TIMER_CTRL); |
| writel(0, MMIO_P2V(CT_CA9X4_TIMER1) + TIMER_CTRL); |
| |
| sp804_clocksource_init(MMIO_P2V(CT_CA9X4_TIMER1)); |
| sp804_clockevents_init(MMIO_P2V(CT_CA9X4_TIMER0), IRQ_CT_CA9X4_TIMER0); |
| } |
| |
| static struct sys_timer ct_ca9x4_timer = { |
| .init = ct_ca9x4_timer_init, |
| }; |
| #endif |
| |
| static struct clcd_panel xvga_panel = { |
| .mode = { |
| .name = "XVGA", |
| .refresh = 60, |
| .xres = 1024, |
| .yres = 768, |
| .pixclock = 15384, |
| .left_margin = 168, |
| .right_margin = 8, |
| .upper_margin = 29, |
| .lower_margin = 3, |
| .hsync_len = 144, |
| .vsync_len = 6, |
| .sync = 0, |
| .vmode = FB_VMODE_NONINTERLACED, |
| }, |
| .width = -1, |
| .height = -1, |
| .tim2 = TIM2_BCD | TIM2_IPC, |
| .cntl = CNTL_LCDTFT | CNTL_BGR | CNTL_LCDVCOMP(1), |
| .bpp = 16, |
| }; |
| |
| static void ct_ca9x4_clcd_enable(struct clcd_fb *fb) |
| { |
| v2m_cfg_write(SYS_CFG_MUXFPGA | SYS_CFG_SITE_DB1, 0); |
| v2m_cfg_write(SYS_CFG_DVIMODE | SYS_CFG_SITE_DB1, 2); |
| } |
| |
| static int ct_ca9x4_clcd_setup(struct clcd_fb *fb) |
| { |
| unsigned long framesize = 1024 * 768 * 2; |
| dma_addr_t dma; |
| |
| fb->panel = &xvga_panel; |
| |
| fb->fb.screen_base = dma_alloc_writecombine(&fb->dev->dev, framesize, |
| &dma, GFP_KERNEL); |
| if (!fb->fb.screen_base) { |
| printk(KERN_ERR "CLCD: unable to map frame buffer\n"); |
| return -ENOMEM; |
| } |
| fb->fb.fix.smem_start = dma; |
| fb->fb.fix.smem_len = framesize; |
| |
| return 0; |
| } |
| |
| static int ct_ca9x4_clcd_mmap(struct clcd_fb *fb, struct vm_area_struct *vma) |
| { |
| return dma_mmap_writecombine(&fb->dev->dev, vma, fb->fb.screen_base, |
| fb->fb.fix.smem_start, fb->fb.fix.smem_len); |
| } |
| |
| static void ct_ca9x4_clcd_remove(struct clcd_fb *fb) |
| { |
| dma_free_writecombine(&fb->dev->dev, fb->fb.fix.smem_len, |
| fb->fb.screen_base, fb->fb.fix.smem_start); |
| } |
| |
| static struct clcd_board ct_ca9x4_clcd_data = { |
| .name = "CT-CA9X4", |
| .check = clcdfb_check, |
| .decode = clcdfb_decode, |
| .enable = ct_ca9x4_clcd_enable, |
| .setup = ct_ca9x4_clcd_setup, |
| .mmap = ct_ca9x4_clcd_mmap, |
| .remove = ct_ca9x4_clcd_remove, |
| }; |
| |
| static AMBA_DEVICE(clcd, "ct:clcd", CT_CA9X4_CLCDC, &ct_ca9x4_clcd_data); |
| static AMBA_DEVICE(dmc, "ct:dmc", CT_CA9X4_DMC, NULL); |
| static AMBA_DEVICE(smc, "ct:smc", CT_CA9X4_SMC, NULL); |
| static AMBA_DEVICE(gpio, "ct:gpio", CT_CA9X4_GPIO, NULL); |
| |
| static struct amba_device *ct_ca9x4_amba_devs[] __initdata = { |
| &clcd_device, |
| &dmc_device, |
| &smc_device, |
| &gpio_device, |
| }; |
| |
| |
| static long ct_round(struct clk *clk, unsigned long rate) |
| { |
| return rate; |
| } |
| |
| static int ct_set(struct clk *clk, unsigned long rate) |
| { |
| return v2m_cfg_write(SYS_CFG_OSC | SYS_CFG_SITE_DB1 | 1, rate); |
| } |
| |
| static const struct clk_ops osc1_clk_ops = { |
| .round = ct_round, |
| .set = ct_set, |
| }; |
| |
| static struct clk osc1_clk = { |
| .ops = &osc1_clk_ops, |
| .rate = 24000000, |
| }; |
| |
| static struct clk_lookup lookups[] = { |
| { /* CLCD */ |
| .dev_id = "ct:clcd", |
| .clk = &osc1_clk, |
| }, |
| }; |
| |
| static struct resource pmu_resources[] = { |
| [0] = { |
| .start = IRQ_CT_CA9X4_PMU_CPU0, |
| .end = IRQ_CT_CA9X4_PMU_CPU0, |
| .flags = IORESOURCE_IRQ, |
| }, |
| [1] = { |
| .start = IRQ_CT_CA9X4_PMU_CPU1, |
| .end = IRQ_CT_CA9X4_PMU_CPU1, |
| .flags = IORESOURCE_IRQ, |
| }, |
| [2] = { |
| .start = IRQ_CT_CA9X4_PMU_CPU2, |
| .end = IRQ_CT_CA9X4_PMU_CPU2, |
| .flags = IORESOURCE_IRQ, |
| }, |
| [3] = { |
| .start = IRQ_CT_CA9X4_PMU_CPU3, |
| .end = IRQ_CT_CA9X4_PMU_CPU3, |
| .flags = IORESOURCE_IRQ, |
| }, |
| }; |
| |
| static struct platform_device pmu_device = { |
| .name = "arm-pmu", |
| .id = ARM_PMU_DEVICE_CPU, |
| .num_resources = ARRAY_SIZE(pmu_resources), |
| .resource = pmu_resources, |
| }; |
| |
| static void ct_ca9x4_init(void) |
| { |
| int i; |
| |
| #ifdef CONFIG_CACHE_L2X0 |
| l2x0_init(MMIO_P2V(CT_CA9X4_L2CC), 0x00000000, 0xfe0fffff); |
| #endif |
| |
| clkdev_add_table(lookups, ARRAY_SIZE(lookups)); |
| |
| for (i = 0; i < ARRAY_SIZE(ct_ca9x4_amba_devs); i++) |
| amba_device_register(ct_ca9x4_amba_devs[i], &iomem_resource); |
| |
| platform_device_register(&pmu_device); |
| } |
| |
| MACHINE_START(VEXPRESS, "ARM-Versatile Express CA9x4") |
| .phys_io = V2M_UART0, |
| .io_pg_offst = (__MMIO_P2V(V2M_UART0) >> 18) & 0xfffc, |
| .boot_params = PHYS_OFFSET + 0x00000100, |
| .map_io = ct_ca9x4_map_io, |
| .init_irq = ct_ca9x4_init_irq, |
| #if 0 |
| .timer = &ct_ca9x4_timer, |
| #else |
| .timer = &v2m_timer, |
| #endif |
| .init_machine = ct_ca9x4_init, |
| MACHINE_END |