| /* arch/arm/mach-msm/include/mach/proc_comm.h |
| * |
| * Copyright (c) 2007-2009,2011 The Linux Foundation. All rights reserved. |
| * |
| * This software is licensed under the terms of the GNU General Public |
| * License version 2, as published by the Free Software Foundation, and |
| * may be copied, distributed, and modified under those terms. |
| * |
| * This program is distributed in the hope that it will be useful, |
| * but WITHOUT ANY WARRANTY; without even the implied warranty of |
| * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the |
| * GNU General Public License for more details. |
| * |
| */ |
| |
| #ifndef _ARCH_ARM_MACH_MSM_MSM_PROC_COMM_H_ |
| #define _ARCH_ARM_MACH_MSM_MSM_PROC_COMM_H_ |
| |
| enum { |
| PCOM_CMD_IDLE = 0x0, |
| PCOM_CMD_DONE, |
| PCOM_RESET_APPS, |
| PCOM_RESET_CHIP, |
| PCOM_CONFIG_NAND_MPU, |
| PCOM_CONFIG_USB_CLKS, |
| PCOM_GET_POWER_ON_STATUS, |
| PCOM_GET_WAKE_UP_STATUS, |
| PCOM_GET_BATT_LEVEL, |
| PCOM_CHG_IS_CHARGING, |
| PCOM_POWER_DOWN, |
| PCOM_USB_PIN_CONFIG, |
| PCOM_USB_PIN_SEL, |
| PCOM_SET_RTC_ALARM, |
| PCOM_NV_READ, |
| PCOM_NV_WRITE, |
| PCOM_GET_UUID_HIGH, |
| PCOM_GET_UUID_LOW, |
| PCOM_GET_HW_ENTROPY, |
| PCOM_RPC_GPIO_TLMM_CONFIG_REMOTE, |
| PCOM_CLKCTL_RPC_ENABLE, |
| PCOM_CLKCTL_RPC_DISABLE, |
| PCOM_CLKCTL_RPC_RESET, |
| PCOM_CLKCTL_RPC_SET_FLAGS, |
| PCOM_CLKCTL_RPC_SET_RATE, |
| PCOM_CLKCTL_RPC_MIN_RATE, |
| PCOM_CLKCTL_RPC_MAX_RATE, |
| PCOM_CLKCTL_RPC_RATE, |
| PCOM_CLKCTL_RPC_PLL_REQUEST, |
| PCOM_CLKCTL_RPC_ENABLED, |
| PCOM_VREG_SWITCH, |
| PCOM_VREG_SET_LEVEL, |
| PCOM_GPIO_TLMM_CONFIG_GROUP, |
| PCOM_GPIO_TLMM_UNCONFIG_GROUP, |
| PCOM_NV_WRITE_BYTES_4_7, |
| PCOM_CONFIG_DISP, |
| PCOM_GET_FTM_BOOT_COUNT, |
| PCOM_RPC_GPIO_TLMM_CONFIG_EX, |
| PCOM_PM_MPP_CONFIG, |
| PCOM_GPIO_IN, |
| PCOM_GPIO_OUT, |
| PCOM_RESET_MODEM, |
| PCOM_RESET_CHIP_IMM, |
| PCOM_PM_VID_EN, |
| PCOM_VREG_PULLDOWN, |
| PCOM_GET_MODEM_VERSION, |
| PCOM_CLK_REGIME_SEC_RESET, |
| PCOM_CLK_REGIME_SEC_RESET_ASSERT, |
| PCOM_CLK_REGIME_SEC_RESET_DEASSERT, |
| PCOM_CLK_REGIME_SEC_PLL_REQUEST_WRP, |
| PCOM_CLK_REGIME_SEC_ENABLE, |
| PCOM_CLK_REGIME_SEC_DISABLE, |
| PCOM_CLK_REGIME_SEC_IS_ON, |
| PCOM_CLK_REGIME_SEC_SEL_CLK_INV, |
| PCOM_CLK_REGIME_SEC_SEL_CLK_SRC, |
| PCOM_CLK_REGIME_SEC_SEL_CLK_DIV, |
| PCOM_CLK_REGIME_SEC_ICODEC_CLK_ENABLE, |
| PCOM_CLK_REGIME_SEC_ICODEC_CLK_DISABLE, |
| PCOM_CLK_REGIME_SEC_SEL_SPEED, |
| PCOM_CLK_REGIME_SEC_CONFIG_GP_CLK_WRP, |
| PCOM_CLK_REGIME_SEC_CONFIG_MDH_CLK_WRP, |
| PCOM_CLK_REGIME_SEC_USB_XTAL_ON, |
| PCOM_CLK_REGIME_SEC_USB_XTAL_OFF, |
| PCOM_CLK_REGIME_SEC_SET_QDSP_DME_MODE, |
| PCOM_CLK_REGIME_SEC_SWITCH_ADSP_CLK, |
| PCOM_CLK_REGIME_SEC_GET_MAX_ADSP_CLK_KHZ, |
| PCOM_CLK_REGIME_SEC_GET_I2C_CLK_KHZ, |
| PCOM_CLK_REGIME_SEC_MSM_GET_CLK_FREQ_KHZ, |
| PCOM_CLK_REGIME_SEC_SEL_VFE_SRC, |
| PCOM_CLK_REGIME_SEC_MSM_SEL_CAMCLK, |
| PCOM_CLK_REGIME_SEC_MSM_SEL_LCDCLK, |
| PCOM_CLK_REGIME_SEC_VFE_RAIL_OFF, |
| PCOM_CLK_REGIME_SEC_VFE_RAIL_ON, |
| PCOM_CLK_REGIME_SEC_GRP_RAIL_OFF, |
| PCOM_CLK_REGIME_SEC_GRP_RAIL_ON, |
| PCOM_CLK_REGIME_SEC_VDC_RAIL_OFF, |
| PCOM_CLK_REGIME_SEC_VDC_RAIL_ON, |
| PCOM_CLK_REGIME_SEC_LCD_CTRL, |
| PCOM_CLK_REGIME_SEC_REGISTER_FOR_CPU_RESOURCE, |
| PCOM_CLK_REGIME_SEC_DEREGISTER_FOR_CPU_RESOURCE, |
| PCOM_CLK_REGIME_SEC_RESOURCE_REQUEST_WRP, |
| PCOM_CLK_REGIME_MSM_SEC_SEL_CLK_OWNER, |
| PCOM_CLK_REGIME_SEC_DEVMAN_REQUEST_WRP, |
| PCOM_GPIO_CONFIG, |
| PCOM_GPIO_CONFIGURE_GROUP, |
| PCOM_GPIO_TLMM_SET_PORT, |
| PCOM_GPIO_TLMM_CONFIG_EX, |
| PCOM_SET_FTM_BOOT_COUNT, |
| PCOM_RESERVED0, |
| PCOM_RESERVED1, |
| PCOM_CUSTOMER_CMD1, |
| PCOM_CUSTOMER_CMD2, |
| PCOM_CUSTOMER_CMD3, |
| PCOM_CLK_REGIME_ENTER_APPSBL_CHG_MODE, |
| PCOM_CLK_REGIME_EXIT_APPSBL_CHG_MODE, |
| PCOM_CLK_REGIME_SEC_RAIL_DISABLE, |
| PCOM_CLK_REGIME_SEC_RAIL_ENABLE, |
| PCOM_CLK_REGIME_SEC_RAIL_CONTROL, |
| PCOM_SET_SW_WATCHDOG_STATE, |
| PCOM_PM_MPP_CONFIG_DIGITAL_INPUT, |
| PCOM_PM_MPP_CONFIG_I_SINK, |
| PCOM_RESERVED_101, |
| PCOM_MSM_HSUSB_PHY_RESET, |
| PCOM_GET_BATT_MV_LEVEL, |
| PCOM_CHG_USB_IS_PC_CONNECTED, |
| PCOM_CHG_USB_IS_CHARGER_CONNECTED, |
| PCOM_CHG_USB_IS_DISCONNECTED, |
| PCOM_CHG_USB_IS_AVAILABLE, |
| PCOM_CLK_REGIME_SEC_MSM_SEL_FREQ, |
| PCOM_CLK_REGIME_SEC_SET_PCLK_AXI_POLICY, |
| PCOM_CLKCTL_RPC_RESET_ASSERT, |
| PCOM_CLKCTL_RPC_RESET_DEASSERT, |
| PCOM_CLKCTL_RPC_RAIL_ON, |
| PCOM_CLKCTL_RPC_RAIL_OFF, |
| PCOM_CLKCTL_RPC_RAIL_ENABLE, |
| PCOM_CLKCTL_RPC_RAIL_DISABLE, |
| PCOM_CLKCTL_RPC_RAIL_CONTROL, |
| PCOM_CLKCTL_RPC_MIN_MSMC1, |
| PCOM_CLKCTL_RPC_SRC_REQUEST, |
| PCOM_NPA_INIT, |
| PCOM_NPA_ISSUE_REQUIRED_REQUEST, |
| PCOM_CLKCTL_RPC_SET_EXT_CONFIG, |
| }; |
| |
| enum { |
| PCOM_OEM_FIRST_CMD = 0x10000000, |
| PCOM_OEM_TEST_CMD = PCOM_OEM_FIRST_CMD, |
| |
| /* add OEM PROC COMM commands here */ |
| |
| PCOM_OEM_LAST = PCOM_OEM_TEST_CMD, |
| }; |
| |
| enum { |
| PCOM_INVALID_STATUS = 0x0, |
| PCOM_READY, |
| PCOM_CMD_RUNNING, |
| PCOM_CMD_SUCCESS, |
| PCOM_CMD_FAIL, |
| PCOM_CMD_FAIL_FALSE_RETURNED, |
| PCOM_CMD_FAIL_CMD_OUT_OF_BOUNDS_SERVER, |
| PCOM_CMD_FAIL_CMD_OUT_OF_BOUNDS_CLIENT, |
| PCOM_CMD_FAIL_CMD_UNREGISTERED, |
| PCOM_CMD_FAIL_CMD_LOCKED, |
| PCOM_CMD_FAIL_SERVER_NOT_YET_READY, |
| PCOM_CMD_FAIL_BAD_DESTINATION, |
| PCOM_CMD_FAIL_SERVER_RESET, |
| PCOM_CMD_FAIL_SMSM_NOT_INIT, |
| PCOM_CMD_FAIL_PROC_COMM_BUSY, |
| PCOM_CMD_FAIL_PROC_COMM_NOT_INIT, |
| }; |
| |
| #ifdef CONFIG_MSM_PROC_COMM |
| void msm_proc_comm_reset_modem_now(void); |
| int msm_proc_comm(unsigned cmd, unsigned *data1, unsigned *data2); |
| #else |
| static inline void msm_proc_comm_reset_modem_now(void) { } |
| static inline int msm_proc_comm(unsigned cmd, unsigned *data1, unsigned *data2) |
| { return 0; } |
| #endif |
| |
| #endif |