| /* |
| * board-specific data for the libertas_spi driver. |
| * |
| * Copyright 2008 Analog Devices Inc. |
| * |
| * This program is free software; you can redistribute it and/or modify |
| * it under the terms of the GNU General Public License as published by |
| * the Free Software Foundation; either version 2 of the License, or (at |
| * your option) any later version. |
| */ |
| #ifndef _LIBERTAS_SPI_H_ |
| #define _LIBERTAS_SPI_H_ |
| |
| struct spi_device; |
| |
| struct libertas_spi_platform_data { |
| /* There are two ways to read data from the WLAN module's SPI |
| * interface. Setting 0 or 1 here controls which one is used. |
| * |
| * Usually you want to set use_dummy_writes = 1. |
| * However, if that doesn't work or if you are using a slow SPI clock |
| * speed, you may want to use 0 here. */ |
| u16 use_dummy_writes; |
| |
| /* GPIO number to use as chip select */ |
| u16 gpio_cs; |
| |
| /* Board specific setup/teardown */ |
| int (*setup)(struct spi_device *spi); |
| int (*teardown)(struct spi_device *spi); |
| }; |
| #endif |