| /* Generic NS8390 register definitions. */ |
| /* This file is part of Donald Becker's 8390 drivers, and is distributed |
| under the same license. Auto-loading of 8390.o only in v2.2 - Paul G. |
| Some of these names and comments originated from the Crynwr |
| packet drivers, which are distributed under the GPL. */ |
| |
| #ifndef _8390_h |
| #define _8390_h |
| |
| #include <linux/if_ether.h> |
| #include <linux/ioport.h> |
| #include <linux/skbuff.h> |
| |
| #define TX_PAGES 12 /* Two Tx slots */ |
| |
| #define ETHER_ADDR_LEN 6 |
| |
| /* The 8390 specific per-packet-header format. */ |
| struct e8390_pkt_hdr { |
| unsigned char status; /* status */ |
| unsigned char next; /* pointer to next packet. */ |
| unsigned short count; /* header + packet length in bytes */ |
| }; |
| |
| #ifdef notdef |
| extern int ei_debug; |
| #else |
| #define ei_debug 1 |
| #endif |
| |
| #ifdef CONFIG_NET_POLL_CONTROLLER |
| extern void ei_poll(struct net_device *dev); |
| #endif |
| |
| extern void NS8390_init(struct net_device *dev, int startp); |
| extern int ei_open(struct net_device *dev); |
| extern int ei_close(struct net_device *dev); |
| extern irqreturn_t ei_interrupt(int irq, void *dev_id); |
| extern struct net_device *__alloc_ei_netdev(int size); |
| static inline struct net_device *alloc_ei_netdev(void) |
| { |
| return __alloc_ei_netdev(0); |
| } |
| |
| /* You have one of these per-board */ |
| struct ei_device { |
| const char *name; |
| void (*reset_8390)(struct net_device *); |
| void (*get_8390_hdr)(struct net_device *, struct e8390_pkt_hdr *, int); |
| void (*block_output)(struct net_device *, int, const unsigned char *, int); |
| void (*block_input)(struct net_device *, int, struct sk_buff *, int); |
| unsigned long rmem_start; |
| unsigned long rmem_end; |
| void __iomem *mem; |
| unsigned char mcfilter[8]; |
| unsigned open:1; |
| unsigned word16:1; /* We have the 16-bit (vs 8-bit) version of the card. */ |
| unsigned bigendian:1; /* 16-bit big endian mode. Do NOT */ |
| /* set this on random 8390 clones! */ |
| unsigned txing:1; /* Transmit Active */ |
| unsigned irqlock:1; /* 8390's intrs disabled when '1'. */ |
| unsigned dmaing:1; /* Remote DMA Active */ |
| unsigned char tx_start_page, rx_start_page, stop_page; |
| unsigned char current_page; /* Read pointer in buffer */ |
| unsigned char interface_num; /* Net port (AUI, 10bT.) to use. */ |
| unsigned char txqueue; /* Tx Packet buffer queue length. */ |
| short tx1, tx2; /* Packet lengths for ping-pong tx. */ |
| short lasttx; /* Alpha version consistency check. */ |
| unsigned char reg0; /* Register '0' in a WD8013 */ |
| unsigned char reg5; /* Register '5' in a WD8013 */ |
| unsigned char saved_irq; /* Original dev->irq value. */ |
| struct net_device_stats stat; /* The new statistics table. */ |
| u32 *reg_offset; /* Register mapping table */ |
| spinlock_t page_lock; /* Page register locks */ |
| unsigned long priv; /* Private field to store bus IDs etc. */ |
| }; |
| |
| /* The maximum number of 8390 interrupt service routines called per IRQ. */ |
| #define MAX_SERVICE 12 |
| |
| /* The maximum time waited (in jiffies) before assuming a Tx failed. (20ms) */ |
| #define TX_TIMEOUT (20*HZ/100) |
| |
| #define ei_status (*(struct ei_device *)netdev_priv(dev)) |
| |
| /* Some generic ethernet register configurations. */ |
| #define E8390_TX_IRQ_MASK 0xa /* For register EN0_ISR */ |
| #define E8390_RX_IRQ_MASK 0x5 |
| #define E8390_RXCONFIG 0x4 /* EN0_RXCR: broadcasts, no multicast,errors */ |
| #define E8390_RXOFF 0x20 /* EN0_RXCR: Accept no packets */ |
| #define E8390_TXCONFIG 0x00 /* EN0_TXCR: Normal transmit mode */ |
| #define E8390_TXOFF 0x02 /* EN0_TXCR: Transmitter off */ |
| |
| /* Register accessed at EN_CMD, the 8390 base addr. */ |
| #define E8390_STOP 0x01 /* Stop and reset the chip */ |
| #define E8390_START 0x02 /* Start the chip, clear reset */ |
| #define E8390_TRANS 0x04 /* Transmit a frame */ |
| #define E8390_RREAD 0x08 /* Remote read */ |
| #define E8390_RWRITE 0x10 /* Remote write */ |
| #define E8390_NODMA 0x20 /* Remote DMA */ |
| #define E8390_PAGE0 0x00 /* Select page chip registers */ |
| #define E8390_PAGE1 0x40 /* using the two high-order bits */ |
| #define E8390_PAGE2 0x80 /* Page 3 is invalid. */ |
| |
| /* |
| * Only generate indirect loads given a machine that needs them. |
| * - removed AMIGA_PCMCIA from this list, handled as ISA io now |
| */ |
| |
| #if defined(CONFIG_MAC) || \ |
| defined(CONFIG_ZORRO8390) || defined(CONFIG_ZORRO8390_MODULE) || \ |
| defined(CONFIG_HYDRA) || defined(CONFIG_HYDRA_MODULE) |
| #define EI_SHIFT(x) (ei_local->reg_offset[x]) |
| #undef inb |
| #undef inb_p |
| #undef outb |
| #undef outb_p |
| |
| #define inb(port) in_8(port) |
| #define outb(val,port) out_8(port,val) |
| #define inb_p(port) in_8(port) |
| #define outb_p(val,port) out_8(port,val) |
| |
| #elif defined(CONFIG_ARM_ETHERH) || defined(CONFIG_ARM_ETHERH_MODULE) |
| #define EI_SHIFT(x) (ei_local->reg_offset[x]) |
| #undef inb |
| #undef inb_p |
| #undef outb |
| #undef outb_p |
| |
| #define inb(_p) readb(_p) |
| #define outb(_v,_p) writeb(_v,_p) |
| #define inb_p(_p) inb(_p) |
| #define outb_p(_v,_p) outb(_v,_p) |
| |
| #elif defined(CONFIG_NE_H8300) || defined(CONFIG_NE_H8300_MODULE) |
| #define EI_SHIFT(x) (ei_local->reg_offset[x]) |
| #else |
| #define EI_SHIFT(x) (x) |
| #endif |
| |
| #define E8390_CMD EI_SHIFT(0x00) /* The command register (for all pages) */ |
| /* Page 0 register offsets. */ |
| #define EN0_CLDALO EI_SHIFT(0x01) /* Low byte of current local dma addr RD */ |
| #define EN0_STARTPG EI_SHIFT(0x01) /* Starting page of ring bfr WR */ |
| #define EN0_CLDAHI EI_SHIFT(0x02) /* High byte of current local dma addr RD */ |
| #define EN0_STOPPG EI_SHIFT(0x02) /* Ending page +1 of ring bfr WR */ |
| #define EN0_BOUNDARY EI_SHIFT(0x03) /* Boundary page of ring bfr RD WR */ |
| #define EN0_TSR EI_SHIFT(0x04) /* Transmit status reg RD */ |
| #define EN0_TPSR EI_SHIFT(0x04) /* Transmit starting page WR */ |
| #define EN0_NCR EI_SHIFT(0x05) /* Number of collision reg RD */ |
| #define EN0_TCNTLO EI_SHIFT(0x05) /* Low byte of tx byte count WR */ |
| #define EN0_FIFO EI_SHIFT(0x06) /* FIFO RD */ |
| #define EN0_TCNTHI EI_SHIFT(0x06) /* High byte of tx byte count WR */ |
| #define EN0_ISR EI_SHIFT(0x07) /* Interrupt status reg RD WR */ |
| #define EN0_CRDALO EI_SHIFT(0x08) /* low byte of current remote dma address RD */ |
| #define EN0_RSARLO EI_SHIFT(0x08) /* Remote start address reg 0 */ |
| #define EN0_CRDAHI EI_SHIFT(0x09) /* high byte, current remote dma address RD */ |
| #define EN0_RSARHI EI_SHIFT(0x09) /* Remote start address reg 1 */ |
| #define EN0_RCNTLO EI_SHIFT(0x0a) /* Remote byte count reg WR */ |
| #define EN0_RCNTHI EI_SHIFT(0x0b) /* Remote byte count reg WR */ |
| #define EN0_RSR EI_SHIFT(0x0c) /* rx status reg RD */ |
| #define EN0_RXCR EI_SHIFT(0x0c) /* RX configuration reg WR */ |
| #define EN0_TXCR EI_SHIFT(0x0d) /* TX configuration reg WR */ |
| #define EN0_COUNTER0 EI_SHIFT(0x0d) /* Rcv alignment error counter RD */ |
| #define EN0_DCFG EI_SHIFT(0x0e) /* Data configuration reg WR */ |
| #define EN0_COUNTER1 EI_SHIFT(0x0e) /* Rcv CRC error counter RD */ |
| #define EN0_IMR EI_SHIFT(0x0f) /* Interrupt mask reg WR */ |
| #define EN0_COUNTER2 EI_SHIFT(0x0f) /* Rcv missed frame error counter RD */ |
| |
| /* Bits in EN0_ISR - Interrupt status register */ |
| #define ENISR_RX 0x01 /* Receiver, no error */ |
| #define ENISR_TX 0x02 /* Transmitter, no error */ |
| #define ENISR_RX_ERR 0x04 /* Receiver, with error */ |
| #define ENISR_TX_ERR 0x08 /* Transmitter, with error */ |
| #define ENISR_OVER 0x10 /* Receiver overwrote the ring */ |
| #define ENISR_COUNTERS 0x20 /* Counters need emptying */ |
| #define ENISR_RDC 0x40 /* remote dma complete */ |
| #define ENISR_RESET 0x80 /* Reset completed */ |
| #define ENISR_ALL 0x3f /* Interrupts we will enable */ |
| |
| /* Bits in EN0_DCFG - Data config register */ |
| #define ENDCFG_WTS 0x01 /* word transfer mode selection */ |
| #define ENDCFG_BOS 0x02 /* byte order selection */ |
| |
| /* Page 1 register offsets. */ |
| #define EN1_PHYS EI_SHIFT(0x01) /* This board's physical enet addr RD WR */ |
| #define EN1_PHYS_SHIFT(i) EI_SHIFT(i+1) /* Get and set mac address */ |
| #define EN1_CURPAG EI_SHIFT(0x07) /* Current memory page RD WR */ |
| #define EN1_MULT EI_SHIFT(0x08) /* Multicast filter mask array (8 bytes) RD WR */ |
| #define EN1_MULT_SHIFT(i) EI_SHIFT(8+i) /* Get and set multicast filter */ |
| |
| /* Bits in received packet status byte and EN0_RSR*/ |
| #define ENRSR_RXOK 0x01 /* Received a good packet */ |
| #define ENRSR_CRC 0x02 /* CRC error */ |
| #define ENRSR_FAE 0x04 /* frame alignment error */ |
| #define ENRSR_FO 0x08 /* FIFO overrun */ |
| #define ENRSR_MPA 0x10 /* missed pkt */ |
| #define ENRSR_PHY 0x20 /* physical/multicast address */ |
| #define ENRSR_DIS 0x40 /* receiver disable. set in monitor mode */ |
| #define ENRSR_DEF 0x80 /* deferring */ |
| |
| /* Transmitted packet status, EN0_TSR. */ |
| #define ENTSR_PTX 0x01 /* Packet transmitted without error */ |
| #define ENTSR_ND 0x02 /* The transmit wasn't deferred. */ |
| #define ENTSR_COL 0x04 /* The transmit collided at least once. */ |
| #define ENTSR_ABT 0x08 /* The transmit collided 16 times, and was deferred. */ |
| #define ENTSR_CRS 0x10 /* The carrier sense was lost. */ |
| #define ENTSR_FU 0x20 /* A "FIFO underrun" occurred during transmit. */ |
| #define ENTSR_CDH 0x40 /* The collision detect "heartbeat" signal was lost. */ |
| #define ENTSR_OWC 0x80 /* There was an out-of-window collision. */ |
| |
| #endif /* _8390_h */ |