| Linus Torvalds | 1da177e | 2005-04-16 15:20:36 -0700 | [diff] [blame] | 1 | menu "Dallas's 1-wire bus" |
| 2 | |
| 3 | config W1 |
| 4 | tristate "Dallas's 1-wire support" |
| 5 | ---help--- |
| 6 | Dallas's 1-wire bus is usefull to connect slow 1-pin devices |
| 7 | such as iButtons and thermal sensors. |
| 8 | |
| 9 | If you want W1 support, you should say Y here. |
| 10 | |
| 11 | This W1 support can also be built as a module. If so, the module |
| 12 | will be called wire.ko. |
| 13 | |
| 14 | config W1_MATROX |
| 15 | tristate "Matrox G400 transport layer for 1-wire" |
| 16 | depends on W1 && PCI |
| 17 | help |
| 18 | Say Y here if you want to communicate with your 1-wire devices |
| 19 | using Matrox's G400 GPIO pins. |
| 20 | |
| 21 | This support is also available as a module. If so, the module |
| 22 | will be called matrox_w1.ko. |
| 23 | |
| 24 | config W1_DS9490 |
| 25 | tristate "DS9490R transport layer driver" |
| 26 | depends on W1 && USB |
| 27 | help |
| 28 | Say Y here if you want to have a driver for DS9490R UWB <-> W1 bridge. |
| 29 | |
| 30 | This support is also available as a module. If so, the module |
| 31 | will be called ds9490r.ko. |
| 32 | |
| 33 | config W1_DS9490_BRIDGE |
| 34 | tristate "DS9490R USB <-> W1 transport layer for 1-wire" |
| 35 | depends on W1_DS9490 |
| 36 | help |
| 37 | Say Y here if you want to communicate with your 1-wire devices |
| 38 | using DS9490R USB bridge. |
| 39 | |
| 40 | This support is also available as a module. If so, the module |
| 41 | will be called ds_w1_bridge.ko. |
| 42 | |
| 43 | config W1_THERM |
| 44 | tristate "Thermal family implementation" |
| 45 | depends on W1 |
| 46 | help |
| 47 | Say Y here if you want to connect 1-wire thermal sensors to you |
| 48 | wire. |
| 49 | |
| 50 | config W1_SMEM |
| 51 | tristate "Simple 64bit memory family implementation" |
| 52 | depends on W1 |
| 53 | help |
| 54 | Say Y here if you want to connect 1-wire |
| 55 | simple 64bit memory rom(ds2401/ds2411/ds1990*) to you wire. |
| 56 | |
| 57 | endmenu |