blob: 75946ac89ee9216103de2daf08f3a09bd22daf88 [file] [log] [blame]
Kevin Wells680b2862010-07-27 08:46:22 -07001if ARCH_LPC32XX
2
3menu "Individual UART enable selections"
4
5config ARCH_LPC32XX_UART3_SELECT
6 bool "Add support for standard UART3"
7 help
8 Adds support for standard UART 3 when the 8250 serial support
9 is enabled.
10
11config ARCH_LPC32XX_UART4_SELECT
12 bool "Add support for standard UART4"
13 help
14 Adds support for standard UART 4 when the 8250 serial support
15 is enabled.
16
17config ARCH_LPC32XX_UART5_SELECT
18 bool "Add support for standard UART5"
19 default y
20 help
21 Adds support for standard UART 5 when the 8250 serial support
22 is enabled.
23
24config ARCH_LPC32XX_UART6_SELECT
25 bool "Add support for standard UART6"
26 help
27 Adds support for standard UART 6 when the 8250 serial support
28 is enabled.
29
30endmenu
31
Roland Stiggec20b9092012-03-12 22:27:28 +010032menu "LPC32XX chip components"
33
34config ARCH_LPC32XX_IRAM_FOR_NET
35 bool "Use IRAM for network buffers"
36 default y
37 help
38 Say Y here to use the LPC internal fast IRAM (i.e. 256KB SRAM) as
39 network buffer. If the total combined required buffer sizes is
40 larger than the size of IRAM, then SDRAM will be used instead.
41
42 This can be enabled safely if the IRAM is not intended for other
43 uses.
44
45config ARCH_LPC32XX_MII_SUPPORT
46 bool "Check to enable MII support or leave disabled for RMII support"
47 help
48 Say Y here to enable MII support, or N for RMII support. Regardless of
49 which support is selected, the ethernet interface driver needs to be
50 selected in the device driver networking section.
51
52 The PHY3250 reference board uses RMII, so users of this board should
53 say N.
54
55endmenu
56
Kevin Wells680b2862010-07-27 08:46:22 -070057endif
58