blob: c60ec82a9604209880fbb7a8beb12fd0177996b8 [file] [log] [blame]
// This file was extracted from the TCG Published
// Trusted Platform Module Library
// Part 4: Supporting Routines
// Family "2.0"
// Level 00 Revision 01.16
// October 30, 2014
#define TPM_FAIL_C
#include "InternalRoutines.h"
#include <assert.h>
//
// On MS C compiler, can save the alignment state and set the alignment to 1 for the duration of the
// TPM_Types.h include. This will avoid a lot of alignment warnings from the compiler for the unaligned
// structures. The alignment of the structures is not important as this function does not use any of the
// structures in TPM_Types.h and only include it for the #defines of the capabilities, properties, and
// command code values.
//
#pragma pack(push, 1)
#include "TPM_Types.h"
#pragma pack (pop)
#include "swap.h"
//
//
// Typedefs
//
// These defines are used primarily for sizing of the local response buffer.
//
#pragma pack(push,1)
typedef struct {
TPM_ST tag;
UINT32 size;
TPM_RC code;
} HEADER;
typedef struct {
UINT16 size;
struct {
UINT32 function;
UINT32 line;
UINT32 code;
} values;
TPM_RC returnCode;
} GET_TEST_RESULT_PARAMETERS;
typedef struct {
TPMI_YES_NO moreData;
TPM_CAP capability; // Always TPM_CAP_TPM_PROPERTIES
TPML_TAGGED_TPM_PROPERTY tpmProperty; // a single tagged property
} GET_CAPABILITY_PARAMETERS;
typedef struct {
HEADER header;
GET_TEST_RESULT_PARAMETERS getTestResult;
} TEST_RESPONSE;
typedef struct {
HEADER header;
GET_CAPABILITY_PARAMETERS getCap;
} CAPABILITY_RESPONSE;
typedef union {
TEST_RESPONSE test;
CAPABILITY_RESPONSE cap;
} RESPONSES;
#pragma pack(pop)
//
// Buffer to hold the responses. This may be a little larger than required due to padding that a compiler
// might add.
//
// NOTE: This is not in Global.c because of the specialized data definitions above. Since the data contained in this
// structure is not relevant outside of the execution of a single command (when the TPM is in failure mode. There
// is no compelling reason to move all the typedefs to Global.h and this structure to Global.c.
//
#ifndef __IGNORE_STATE__ // Don't define this value
static BYTE response[sizeof(RESPONSES)];
#endif
//
//
// Local Functions
//
// MarshalUint16()
//
// Function to marshal a 16 bit value to the output buffer.
//
static INT32
MarshalUint16(
UINT16 integer,
BYTE **buffer
)
{
return UINT16_Marshal(&integer, buffer, NULL);
}
//
//
// MarshalUint32()
//
// Function to marshal a 32 bit value to the output buffer.
static INT32
MarshalUint32(
UINT32 integer,
BYTE **buffer
)
{
return UINT32_Marshal(&integer, buffer, NULL);
}
//
//
// UnmarshalHeader()
//
// Funtion to unmarshal the 10-byte command header.
//
static BOOL
UnmarshalHeader(
HEADER *header,
BYTE **buffer,
INT32 *size
)
{
UINT32 usize;
TPM_RC ucode;
if( UINT16_Unmarshal(&header->tag, buffer, size) != TPM_RC_SUCCESS
|| UINT32_Unmarshal(&usize, buffer, size) != TPM_RC_SUCCESS
|| UINT32_Unmarshal(&ucode, buffer, size) != TPM_RC_SUCCESS
)
return FALSE;
header->size = usize;
header->code = ucode;
return TRUE;
}
//
//
// Public Functions
//
// SetForceFailureMode()
//
// This function is called by the simulator to enable failure mode testing.
//
LIB_EXPORT void
SetForceFailureMode(
void
)
{
g_forceFailureMode = TRUE;
return;
}
//
//
// TpmFail()
//
// This function is called by TPM.lib when a failure occurs. It will set up the failure values to be returned on
// TPM2_GetTestResult().
//
void
TpmFail(
const char *function,
int line, int code
)
{
// Save the values that indicate where the error occurred.
// On a 64-bit machine, this may truncate the address of the string
// of the function name where the error occurred.
s_failFunction = *(UINT32*)&function;
s_failLine = line;
s_failCode = code;
// if asserts are enabled, then do an assert unless the failure mode code
// is being tested
assert(g_forceFailureMode);
// Clear this flag
g_forceFailureMode = FALSE;
// Jump to the failure mode code.
// Note: only get here if asserts are off or if we are testing failure mode
longjmp(&g_jumpBuffer[0], 1);
}
//
//
// TpmFailureMode
//
// This function is called by the interface code when the platform is in failure mode.
//
void
TpmFailureMode (
unsigned int inRequestSize, // IN: command buffer size
unsigned char *inRequest, // IN: command buffer
unsigned int *outResponseSize, // OUT: response buffer size
unsigned char **outResponse // OUT: response buffer
)
{
BYTE *buffer;
UINT32 marshalSize;
UINT32 capability;
HEADER header; // unmarshaled command header
UINT32 pt; // unmarshaled property type
UINT32 count; // unmarshaled property count
// If there is no command buffer, then just return TPM_RC_FAILURE
if(inRequestSize == 0 || inRequest == NULL)
goto FailureModeReturn;
// If the header is not correct for TPM2_GetCapability() or
// TPM2_GetTestResult() then just return the in failure mode response;
buffer = inRequest;
if(!UnmarshalHeader(&header, &inRequest, (INT32 *)&inRequestSize))
goto FailureModeReturn;
if( header.tag != TPM_ST_NO_SESSIONS
|| header.size < 10)
goto FailureModeReturn;
switch (header.code) {
case TPM_CC_GetTestResult:
// make sure that the command size is correct
if(header.size != 10)
goto FailureModeReturn;
buffer = &response[10];
marshalSize = MarshalUint16(3 * sizeof(UINT32), &buffer);
marshalSize += MarshalUint32(s_failFunction, &buffer);
marshalSize += MarshalUint32(s_failLine, &buffer);
marshalSize += MarshalUint32(s_failCode, &buffer);
if(s_failCode == FATAL_ERROR_NV_UNRECOVERABLE)
marshalSize += MarshalUint32(TPM_RC_NV_UNINITIALIZED, &buffer);
else
marshalSize += MarshalUint32(TPM_RC_FAILURE, &buffer);
//
break;
case TPM_CC_GetCapability:
// make sure that the size of the command is exactly the size
// returned for the capability, property, and count
if( header.size!= (10 + (3 * sizeof(UINT32)))
// also verify that this is requesting TPM properties
|| (UINT32_Unmarshal(&capability, &inRequest,
(INT32 *)&inRequestSize)
!= TPM_RC_SUCCESS)
|| (capability != TPM_CAP_TPM_PROPERTIES)
|| (UINT32_Unmarshal(&pt, &inRequest, (INT32 *)&inRequestSize)
!= TPM_RC_SUCCESS)
|| (UINT32_Unmarshal(&count, &inRequest, (INT32 *)&inRequestSize)
!= TPM_RC_SUCCESS)
)
goto FailureModeReturn;
// If in failure mode because of an unrecoverable read error, and the
// property is 0 and the count is 0, then this is an indication to
// re-manufacture the TPM. Do the re-manufacture but stay in failure
// mode until the TPM is reset.
// Note: this behavior is not required by the specification and it is
// OK to leave the TPM permanently bricked due to an unrecoverable NV
// error.
if( count == 0 && pt == 0 && s_failCode == FATAL_ERROR_NV_UNRECOVERABLE)
{
g_manufactured = FALSE;
TPM_Manufacture(0);
}
if(count > 0)
count = 1;
else if(pt > TPM_PT_FIRMWARE_VERSION_2)
count = 0;
if(pt < TPM_PT_MANUFACTURER)
pt = TPM_PT_MANUFACTURER;
// set up for return
buffer = &response[10];
// if the request was for a PT less than the last one
// then we indicate more, otherwise, not.
if(pt < TPM_PT_FIRMWARE_VERSION_2)
*buffer++ = YES;
else
*buffer++ = NO;
marshalSize = 1;
// indicate the capability type
marshalSize += MarshalUint32(capability, &buffer);
// indicate the number of values that are being returned (0 or 1)
marshalSize += MarshalUint32(count, &buffer);
// indicate the property
marshalSize += MarshalUint32(pt, &buffer);
if(count > 0)
switch (pt) {
case TPM_PT_MANUFACTURER:
// the vendor ID unique to each TPM manufacturer
#ifdef MANUFACTURER
pt = *(UINT32*)MANUFACTURER;
#else
pt = 0;
#endif
break;
case TPM_PT_VENDOR_STRING_1:
// the first four characters of the vendor ID string
#ifdef VENDOR_STRING_1
pt = *(UINT32*)VENDOR_STRING_1;
#else
pt = 0;
#endif
break;
case TPM_PT_VENDOR_STRING_2:
// the second four characters of the vendor ID string
#ifdef VENDOR_STRING_2
pt = *(UINT32*)VENDOR_STRING_2;
#else
pt = 0;
#endif
break;
case TPM_PT_VENDOR_STRING_3:
// the third four characters of the vendor ID string
#ifdef VENDOR_STRING_3
pt = *(UINT32*)VENDOR_STRING_3;
#else
pt = 0;
#endif
break;
case TPM_PT_VENDOR_STRING_4:
// the fourth four characters of the vendor ID string
#ifdef VENDOR_STRING_4
pt = *(UINT32*)VENDOR_STRING_4;
#else
pt = 0;
#endif
break;
case TPM_PT_VENDOR_TPM_TYPE:
// vendor-defined value indicating the TPM model
// We just make up a number here
pt = 1;
break;
case TPM_PT_FIRMWARE_VERSION_1:
// the more significant 32-bits of a vendor-specific value
// indicating the version of the firmware
#ifdef FIRMWARE_V1
pt = FIRMWARE_V1;
#else
pt = 0;
#endif
break;
default: // TPM_PT_FIRMWARE_VERSION_2:
// the less significant 32-bits of a vendor-specific value
// indicating the version of the firmware
#ifdef FIRMWARE_V2
pt = FIRMWARE_V2;
#else
pt = 0;
#endif
break;
}
marshalSize += MarshalUint32(pt, &buffer);
break;
default: // default for switch (cc)
goto FailureModeReturn;
}
// Now do the header
buffer = response;
marshalSize = marshalSize + 10; // Add the header size to the
// stuff already marshaled
MarshalUint16(TPM_ST_NO_SESSIONS, &buffer); // structure tag
MarshalUint32(marshalSize, &buffer); // responseSize
MarshalUint32(TPM_RC_SUCCESS, &buffer); // response code
*outResponseSize = marshalSize;
*outResponse = (unsigned char *)&response;
return;
FailureModeReturn:
buffer = response;
marshalSize = MarshalUint16(TPM_ST_NO_SESSIONS, &buffer);
marshalSize += MarshalUint32(10, &buffer);
marshalSize += MarshalUint32(TPM_RC_FAILURE, &buffer);
*outResponseSize = marshalSize;
*outResponse = (unsigned char *)response;
return;
}