| Bluedroid Test Application |
| ========================== |
| The test application provides a small console shell interface that allows |
| access to the Bluetooth HAL API library though ASCII commands. This is similar |
| to how the real JNI service would operate. The primary objective of this |
| application is to allow Bluetooth to be put in DUT Mode for RF/BB BQB test purposes. |
| |
| This application is mutually exclusive with the Java based Bluetooth.apk. Hence |
| before launching the application, it should be ensured that the Settings->Bluetooth is OFF. |
| |
| This application is built as 'bdt' and shall be available in '/system/bin/bdt' |
| |
| Limitations |
| =========== |
| 1.) Settings->Bluetooth must be OFF for this application to work |
| 2.) Currently, only the SIG 'HCI Test Mode' commands are supported. The vendor |
| specific HCI test mode commands to be added. |
| |
| Usage instructions |
| ================== |
| The following section describes the various commands and their usage |
| |
| Launching the test application |
| ============================== |
| $ adb shell |
| root@android:/ # /system/bin/bdt |
| set_aid_and_cap : pid 1183, uid 0 gid 0 |
| ::::::::::::::::::::::::::::::::::::::::::::::::::: |
| :: Bluedroid test app starting |
| Loading HAL lib + extensions |
| HAL library loaded (Success) |
| INIT BT |
| HAL REQUEST SUCCESS |
| |
| Enabling Bluetooth |
| ================== |
| >enable |
| ENABLE BT |
| HAL REQUEST SUCCESS |
| >ADAPTER STATE UPDATED : ON |
| |
| Enabling Test Mode (Bluetooth must be enabled for this command to work) |
| ====================================================================== |
| >dut_mode_configure 1 |
| BT DUT MODE CONFIGURE |
| HAL REQUEST SUCCESS |
| > |
| |
| Disabling Test Mode |
| =================== |
| >dut_mode_configure 0 |
| BT DUT MODE CONFIGURE |
| HAL REQUEST SUCCESS |
| > |
| |
| Running BLE Test commands (Bluetooth must be enabled) |
| ===================================================== |
| NOTE: Unlike BR/EDR, there is no explicit DUT mode to run these BLE tests. |
| |
| > le_test_mode 1 <rx_freq> |
| |
| > le_test_mode 2 <tx_freq> <test_data_len> <payload_pattern> |
| |
| > le_test_mode 3 <no_args> |
| Please refer to the BT Core spec pages-1099 to 1102 for possible values for |
| the above parameters. These values need to be provided in Decimal format. |
| |
| Exit the test application |
| ========================= |
| >quit |
| shutdown bdroid test app |
| Unloading HAL lib |
| HAL library unloaded (Success) |
| :: Bluedroid test app terminating |
| |
| Help (Lists the available commands) |
| =================================== |
| >help |
| help lists all available console commands |
| |
| quit |
| enable :: enables bluetooth |
| disable :: disables bluetooth |
| dut_mode_configure :: DUT mode - 1 to enter,0 to exit |
| le_test_mode :: LE Test Mode - RxTest - 1 <rx_freq>, |
| TxTest - 2 <tx_freq> <test_data_len> <payload_pattern>, |
| End Test - 3 <no_args> |
| |