| Arnd Bergmann | 88ced03 | 2005-12-16 22:43:46 +0100 | [diff] [blame] | 1 | #ifndef _ASM_POWERPC_HEATHROW_H |
| 2 | #define _ASM_POWERPC_HEATHROW_H |
| Paul Mackerras | 42650d8 | 2005-12-20 18:43:52 +1100 | [diff] [blame] | 3 | #ifdef __KERNEL__ |
| Linus Torvalds | 1da177e | 2005-04-16 15:20:36 -0700 | [diff] [blame] | 4 | /* |
| 5 | * heathrow.h: definitions for using the "Heathrow" I/O controller chip. |
| 6 | * |
| 7 | * Grabbed from Open Firmware definitions on a PowerBook G3 Series |
| 8 | * |
| 9 | * Copyright (C) 1997 Paul Mackerras. |
| 10 | */ |
| 11 | |
| 12 | /* Front light color on Yikes/B&W G3. 32 bits */ |
| 13 | #define HEATHROW_FRONT_LIGHT 0x32 /* (set to 0 or 0xffffffff) */ |
| 14 | |
| 15 | /* Brightness/contrast (gossamer iMac ?). 8 bits */ |
| 16 | #define HEATHROW_BRIGHTNESS_CNTL 0x32 |
| 17 | #define HEATHROW_CONTRAST_CNTL 0x33 |
| 18 | |
| 19 | /* offset from ohare base for feature control register */ |
| 20 | #define HEATHROW_MBCR 0x34 /* Media bay control */ |
| 21 | #define HEATHROW_FCR 0x38 /* Feature control */ |
| 22 | #define HEATHROW_AUX_CNTL_REG 0x3c /* Aux control */ |
| 23 | |
| 24 | /* |
| 25 | * Bits in feature control register. |
| 26 | * Bits postfixed with a _N are in inverse logic |
| 27 | */ |
| 28 | #define HRW_SCC_TRANS_EN_N 0x00000001 /* Also controls modem power */ |
| 29 | #define HRW_BAY_POWER_N 0x00000002 |
| 30 | #define HRW_BAY_PCI_ENABLE 0x00000004 |
| 31 | #define HRW_BAY_IDE_ENABLE 0x00000008 |
| 32 | #define HRW_BAY_FLOPPY_ENABLE 0x00000010 |
| 33 | #define HRW_IDE0_ENABLE 0x00000020 |
| 34 | #define HRW_IDE0_RESET_N 0x00000040 |
| 35 | #define HRW_BAY_DEV_MASK 0x0000001c |
| 36 | #define HRW_BAY_RESET_N 0x00000080 |
| 37 | #define HRW_IOBUS_ENABLE 0x00000100 /* Internal IDE ? */ |
| 38 | #define HRW_SCC_ENABLE 0x00000200 |
| 39 | #define HRW_MESH_ENABLE 0x00000400 |
| 40 | #define HRW_SWIM_ENABLE 0x00000800 |
| 41 | #define HRW_SOUND_POWER_N 0x00001000 |
| 42 | #define HRW_SOUND_CLK_ENABLE 0x00002000 |
| 43 | #define HRW_SCCA_IO 0x00004000 |
| 44 | #define HRW_SCCB_IO 0x00008000 |
| 45 | #define HRW_PORT_OR_DESK_VIA_N 0x00010000 /* This one is 0 on PowerBook */ |
| 46 | #define HRW_PWM_MON_ID_N 0x00020000 /* ??? (0) */ |
| 47 | #define HRW_HOOK_MB_CNT_N 0x00040000 /* ??? (0) */ |
| 48 | #define HRW_SWIM_CLONE_FLOPPY 0x00080000 /* ??? (0) */ |
| 49 | #define HRW_AUD_RUN22 0x00100000 /* ??? (1) */ |
| 50 | #define HRW_SCSI_LINK_MODE 0x00200000 /* Read ??? (1) */ |
| 51 | #define HRW_ARB_BYPASS 0x00400000 /* Disable internal PCI arbitrer */ |
| 52 | #define HRW_IDE1_RESET_N 0x00800000 /* Media bay */ |
| 53 | #define HRW_SLOW_SCC_PCLK 0x01000000 /* ??? (0) */ |
| 54 | #define HRW_RESET_SCC 0x02000000 |
| 55 | #define HRW_MFDC_CELL_ENABLE 0x04000000 /* ??? (0) */ |
| 56 | #define HRW_USE_MFDC 0x08000000 /* ??? (0) */ |
| 57 | #define HRW_BMAC_IO_ENABLE 0x60000000 /* two bits, not documented in OF */ |
| 58 | #define HRW_BMAC_RESET 0x80000000 /* not documented in OF */ |
| 59 | |
| 60 | /* We OR those features at boot on desktop G3s */ |
| 61 | #define HRW_DEFAULTS (HRW_SCCA_IO | HRW_SCCB_IO | HRW_SCC_ENABLE) |
| 62 | |
| 63 | /* Looks like Heathrow has some sort of GPIOs as well... */ |
| 64 | #define HRW_GPIO_MODEM_RESET 0x6d |
| 65 | |
| Arnd Bergmann | 88ced03 | 2005-12-16 22:43:46 +0100 | [diff] [blame] | 66 | #endif /* __KERNEL__ */ |
| 67 | #endif /* _ASM_POWERPC_HEATHROW_H */ |