Blame - drivers/net/ethernet/stmicro/stmmac/Kconfig - kernel/msm-4.9

blob: f2d7c702c77f3853fc05c90753f1ae90773d8753 [file] [log] [blame]

Giuseppe Cavallaro	47dd7a5	2009-10-14 15:13:45 -0700	[diff] [blame]	1	config STMMAC_ETH
				2	tristate "STMicroelectronics 10/100/1000 Ethernet driver"
Geert Uytterhoeven	fd1eb9e	2013-05-09 11:04:46 +0000	[diff] [blame]	3	depends on HAS_IOMEM && HAS_DMA
Giuseppe Cavallaro	47dd7a5	2009-10-14 15:13:45 -0700	[diff] [blame]	4	select MII
				5	select PHYLIB
Carmelo AMOROSO	7ba8a9b	2010-03-31 21:44:03 +0000	[diff] [blame]	6	select CRC32
Rayagond Kokatanur	92ba688	2013-03-26 04:43:11 +0000	[diff] [blame]	7	select PTP_1588_CLOCK
Chen-Yu Tsai	c5e4ddb	2014-01-17 21:24:41 +0800	[diff] [blame]	8	select RESET_CONTROLLER
Jeff Kirsher	7ac6653	2011-05-16 00:05:19 -0700	[diff] [blame]	9	---help---
Giuseppe CAVALLARO	7187c1a	2010-01-06 23:07:22 +0000	[diff] [blame]	10	This is the driver for the Ethernet IPs are built around a
Giuseppe CAVALLARO	ac75791	2010-08-23 20:40:41 +0000	[diff] [blame]	11	Synopsys IP Core and only tested on the STMicroelectronics
Giuseppe CAVALLARO	7187c1a	2010-01-06 23:07:22 +0000	[diff] [blame]	12	platforms.
Giuseppe Cavallaro	47dd7a5	2009-10-14 15:13:45 -0700	[diff] [blame]	13
				14	if STMMAC_ETH
				15
Giuseppe CAVALLARO	bfab27a	2011-12-21 03:58:19 +0000	[diff] [blame]	16	config STMMAC_PLATFORM
Giuseppe CAVALLARO	ba27ec6	2012-06-04 19:22:57 +0000	[diff] [blame]	17	bool "STMMAC Platform bus support"
Giuseppe CAVALLARO	bfab27a	2011-12-21 03:58:19 +0000	[diff] [blame]	18	depends on STMMAC_ETH
Giuseppe CAVALLARO	33d5e33	2012-06-07 19:25:07 +0000	[diff] [blame]	19	default y
Giuseppe CAVALLARO	bfab27a	2011-12-21 03:58:19 +0000	[diff] [blame]	20	---help---
				21	This selects the platform specific bus support for
				22	the stmmac device driver. This is the driver used
				23	on many embedded STM platforms based on ARM and SuperH
				24	processors.
				25	If you have a controller with this interface, say Y or M here.
				26
				27	If unsure, say N.
				28
Chen-Yu Tsai	af0bd4e	2014-01-17 21:24:47 +0800	[diff] [blame]	29	config DWMAC_SUNXI
				30	bool "Allwinner GMAC support"
				31	depends on STMMAC_PLATFORM && ARCH_SUNXI
				32	default y
				33	---help---
				34	Support for Allwinner A20/A31 GMAC ethernet controllers.
				35
				36	This selects Allwinner SoC glue layer support for the
				37	stmmac device driver. This driver is used for A20/A31
				38	GMAC ethernet controller.
				39
Srinivas Kandagatla	d15891c	2014-02-11 09:59:57 +0000	[diff] [blame]	40	config DWMAC_STI
				41	bool "STi GMAC support"
				42	depends on STMMAC_PLATFORM && ARCH_STI
				43	default y
				44	---help---
				45	Support for ethernet controller on STi SOCs.
				46
				47	This selects STi SoC glue layer support for the stmmac
				48	device driver. This driver is used on for the STi series
				49	SOCs GMAC ethernet controller.
				50
Giuseppe CAVALLARO	bfab27a	2011-12-21 03:58:19 +0000	[diff] [blame]	51	config STMMAC_PCI
Kees Cook	6e1215a	2013-01-22 10:30:30 -0800	[diff] [blame]	52	bool "STMMAC PCI bus support"
				53	depends on STMMAC_ETH && PCI
Giuseppe CAVALLARO	bfab27a	2011-12-21 03:58:19 +0000	[diff] [blame]	54	---help---
				55	This is to select the Synopsys DWMAC available on PCI devices,
				56	if you have a controller with this interface, say Y or M here.
				57
				58	This PCI support is tested on XLINX XC2V3000 FF1152AMT0221
				59	D1215994A VIRTEX FPGA board.
				60
				61	If unsure, say N.
				62
Giuseppe CAVALLARO	7ac2905	2011-09-01 21:51:39 +0000	[diff] [blame]	63	config STMMAC_DEBUG_FS
				64	bool "Enable monitoring via sysFS "
				65	default n
				66	depends on STMMAC_ETH && DEBUG_FS
Giuseppe CAVALLARO	bfab27a	2011-12-21 03:58:19 +0000	[diff] [blame]	67	---help---
Giuseppe CAVALLARO	e743482	2011-09-01 21:51:41 +0000	[diff] [blame]	68	The stmmac entry in /sys reports DMA TX/RX rings
				69	or (if supported) the HW cap register.
Giuseppe CAVALLARO	7ac2905	2011-09-01 21:51:39 +0000	[diff] [blame]	70
Giuseppe Cavallaro	47dd7a5	2009-10-14 15:13:45 -0700	[diff] [blame]	71	config STMMAC_DA
				72	bool "STMMAC DMA arbitration scheme"
				73	default n
Jeff Kirsher	7ac6653	2011-05-16 00:05:19 -0700	[diff] [blame]	74	---help---
Giuseppe Cavallaro	47dd7a5	2009-10-14 15:13:45 -0700	[diff] [blame]	75	Selecting this option, rx has priority over Tx (only for Giga
				76	Ethernet device).
				77	By default, the DMA arbitration scheme is based on Round-robin
				78	(rx:tx priority is 1:1).
				79
Giuseppe Cavallaro	47dd7a5	2009-10-14 15:13:45 -0700	[diff] [blame]	80	endif